Jump to content
SAU Community

Spilt Beer In My Backseat

Crackfox

By Crackfox,
in Exterior & Interior Styling

 Share

Recommended Posts

Crackfox Community Regular

Crackfox

Posted
Posted

I just had about 100ml of beer spill onto the backseat of my car, I soaked up ~50% of it with a towel and then sat another dry towel over the wet patch to try suck up some more of it. What products can I use to get at this in the morning? Right now i'm off to bed cos ive had about 5 hours sleep since thursday.

Link to comment
https://www.sau.com.au/forums/topic/308131-spilt-beer-in-my-backseat/
Share on other sites
BeEnAr Experienced

BeEnAr

Posted
Posted

Still against the law to have open alcohol in the car while it's driving, even if it's a passenger. But seriously, how many of us still allow it. I know I do and I have never drunk drove in my life.

Try the Metho trick dude. The worst part about spilt beer is the smell after a while.

Crackfox Community Regular

Crackfox

Posted
  • Author
Posted
Still against the law to have open alcohol in the car while it's driving, even if it's a passenger. But seriously, how many of us still allow it. I know I do and I have never drunk drove in my life.

Try the Metho trick dude. The worst part about spilt beer is the smell after a while.

Haha yeah true. I have even been pulled over a few times with passengers that have opened alcohol and the police didnt mind as long as I'm sober.

Do I just pour some metho onto my back seat and leave it? Or should I dab at it with a clothe or something, I'll be trying it tomorrow. Today the car didnt smell to bad and you could only smell a faint beer smell if you sat in he backseat

Basti Grand Master

Basti

Posted
Posted

idiot brother left a full stubbie on the rear footwell after they were predrinkin b4 goin in to a club. didnt bother to tell me. when i went to get the car at the end of the night, beer went every where. that is one of the worst smells imo. had to get it steam cleaned

GTR-N1 Grand Master

GTR-N1

Posted
Posted
Do I just pour some metho onto my back seat and leave it? Or should I dab at it with a clothe or something,

Just soak some rag with methylated spirits and dab the area. It'll evaporate anyway and with no stain and even less smell.

joeyjoejoejuniorshabadoo Grand Master

joeyjoejoejuniorshabadoo

Posted
Posted
It wasnt me that was drinking. My asian friend decided his beer would be ok if he sat it down upright while I took a roundabout. That was his only his third beer as well and he's a big guy about 95kgs. asians cant drink

if it was a white guy i could help you, but asian beer stains are a different matter...

Mandingo Proficient

Mandingo

Posted
Posted (edited)
see if you can use a carpet cleaner. might be able to rent one somewhere.

I wouldnt go near one of those things. They are SHIT. I have 10 yrs carpet cleaning experience so I know.

Ring a carpet cleaner if your really keen to get it super clean. Most carpet cleaners hate doing cars so be nice and pull the seats out for him. If they try to charge you more then $100 to do both fronts and the back tell em to get f**ked. and make sure they use the hot water extraction method, not some half arsed dry cleaning bullshit. this goes for your carpets too.

If your in brisbane or gold coast PM me.

Edited by Flipmo

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • RP1421
      S15 Spec R

      By RP1421 · Posted

      As discussed in the previous post, the bushes in the 110 needed replacing. I took this opportunity to replace the castor bushes, the front lower control arm, lower the car and get the alignment dialled in with new tyres. I took it down to Alignment Motorsports on the GC to get this work done and also get more out of the Shockworks as I felt like I wasn't getting the full use out of them.  To cut a very long story short, it ended up being the case the passenger side castor arm wouldn't accept the brand new bush as the sleeve had worn badly enough to the point you could push the new bush in by hand and completely through. Trying a pair of TRD bushes didn't fix the issue either (I had originally gone with Hardrace bushes). We needed to urgently source another castor arm, and thankfully this was sourced and the guys at the shop worked on my car until 7pm on a Saturday to get everything done. The car rides a lot nicer now with the suspension dialled in properly. Lowered the car a little as well to suit the lower profile front tyres, and just bring the car down generally. Eternally thankful for the guys down at the shop to get the car sorted, we both pulled big favours from our contacts to get it done on the Saturday.  Also plugged in the new Stedi foglights into the S15, and even from a quick test in the garage I'm keen to see how they look out on the road. I had some concerns about the length of the LED body and whether it'd fit in the foglight housing but it's fine.  I've got a small window coming up next month where I'll likely get a little paint work done on the 110 to remove the rear wing, add a boot wing and roof wing, get the side skirt fixed up and colour match the little panel on the tail lights so that I can install some badges that I've kept in storage. I'm also tempted to put in a new pair of headlights on the 110.  Until then, here's some more pictures from Easter this year. 
    • joshuaho96
      R32 GTS (RB20DE) Injectors Replacement

      By joshuaho96 · Posted

      I would put a fuel pressure gauge between the filter and the fuel rail, see if it's maintaining good fuel pressure at idle going up to the point when it stalls. Do you see any strange behavior in commanded fuel leading up to the point when it stalls? You might have to start going through the service manual and doing a long list of sensor tests if it's not the fuel system for whatever reason.
    • perry_r33
      R34 GTR Vspec Garage Sale - All must go!

      By perry_r33 · Posted

      Pm sent 
    • Robot
      Skyline v36 350GT sedan hunting on idle

      By Robot · Posted

      Hi,  Just joined the forum so I could share my "fix" of this problem. Might be of use to someone. Had the same hunting at idle issue on my V36 with VQ35HR engine after swapping the engine because the original one got overheated.  While changing the engine I made the mistake of cleaning the throttle bodies and tried all the tricks i could find to do a throttle relearn with no luck. Gave in and took it to a shop and they couldn't sort it. Then took it to my local Nissan dealership and they couldn't get it to idle properly. They said I'd need to replace the throttle bodies and the ecu probably costing more than the car is worth. So I had the idea of replacing the carbon I cleaned out with a thin layer of super glue and it's back to normal idle now. Bit rough but saved the car from the wreckers 🤣
    • GabsReDeal
      R32 GTS (RB20DE) Injectors Replacement

      By GabsReDeal · Posted

      After my last update, I went ahead with cleaning and restoring the entire fuel system. This included removing the tank and cleaning it with the Beyond Balistics solution, power washing it multiple times, drying it thoroughly, rinsing with IPA, drying again with heat gun and compressed air. Also, cleaning out the lines, fuel rail, and replacing the fuel pump with an OEM-style one. During the cleaning process, I replaced several hoses - including the breather hose on the fuel tank, which turned out to be the cause of the earlier fuel leak. This is what the old fuel filter looked like: Fuel tank before cleaning: Dirty Fuel Tank.mp4   Fuel tank after cleaning (some staining remains): Clean Fuel Tank.mp4 Both the OEM 270cc and new DeatschWerks 550cc injectors were cleaned professionally by a shop. Before reassembling everything, I tested the fuel flow by running the pump output into a container at the fuel filter location - flow looked good. I then fitted the new fuel filter and reassembled the rest of the system. Fuel Flow Test.mp4 Test 1 - 550cc injectors Ran the new fuel pump with its supplied diagonal strainer (different from OEM’s flat strainer) and my 550cc injectors using the same resized-injector map I had successfully used before. At first, it idled roughly and stalled when I applied throttle. Checked the spark plugs and found that they were fouled with carbon (likely from the earlier overly rich running when the injectors were clogged). After cleaning the plugs, the car started fine. However, it would only idle for 30–60 seconds before stalling, and while driving it would feel like a “fuel cut” after a few seconds - though it wouldn’t fully stall. Test 2 – Strainer swap Suspecting the diagonal strainer might not be reaching the tank bottom, I swapped it for the original flat strainer and filled the tank with ~45L of fuel. The issue persisted exactly the same. Test 3 – OEM injectors To eliminate tuning variables, I reinstalled the OEM 270cc injectors and reverted to the original map. Cleaned the spark plugs again just in-case. The stalling and “fuel cut” still remained.   At this stage, I suspect an intermittent power or connection fault at the fuel pump hanger, caused during the cleaning process. This has led me to look into getting Frenchy’s fuel hanger and replacing the unit entirely. TL;DR: Cleaned and restored the fuel system (tank, lines, rail, pump). Tested 550cc injectors with the same resized-injector map as before, but the car stalls at idle and experiences what feels like “fuel cut” after a few seconds of driving. Swapped back to OEM injectors with original map to rule out tuning, but the issue persists. Now suspecting an intermittent power or connection fault at the fuel pump hanger, possibly cause by the cleaning process.  
×
×
  • Create New...