Jump to content
SAU Community

Recommended Posts

Could be a stuffed wheel bearing. I'm in the process (quite literally as we speak) of replacing my front ones because of much the same problem.

Did you get the rear wheels alligned too? Remember these cars have four wheel steering...

Could be a stuffed wheel bearing. I'm in the process (quite literally as we speak) of replacing my front ones because of much the same problem.

Did you get the rear wheels alligned too? Remember these cars have four wheel steering...

ok i'll give it a try and keep you posted on results, got to find time...

Thanks for the help

spacers? not too sure, will find out, they are aftermarket wheels

They are new rims, will get back balanced too

Thanks

Edited by Rbsushi
how long were the tyres unbalanced for?

if the tyres have been run unbalanced for a while they wear in a way that, when rebalanced, they unbalance themselves again

urgh and by unbalanced i meant out of alignment, shouldn't post when tired

I got new tyres yesterday, balanced and aligned, front and back.

after 1 day my steering tremors are back @80km/h, I'm going to change caster and sway bar bushings, cause mine are stuffed and get aligned again and see how that goes.

Take a look if your bushings need to be done.

that should only affect it when you put the brakes on. i had a magna that kept warping the front rotors every few months after getting them machined. they were really really bad. even at 60kmh by the time you had gotten down to 50kmh the vibration would be shocking and by the time you stopped it was ridiculously bad, but it never affected how the car drove when you weren't touching the brakes. ended up getting new rotors and it didn't warp them anymore.

I too am going for the bush route now because I've replaced wheel bearings and alligned/balanced everything so I can only put it down to the other weak link in steering gear; bushes. Either that or the mob who did my alligning/balancing did a shit job.

  • 2 weeks later...

I had to get mine balanced/aligned twice cos the first did indeed do a shit job, so don't take it back to the same place the 2nd time, likely they'll do a crap job still...

The only company that does good aligns seem to be Tyrepower and Beaurepairs from my experience.

I found out that my suspension is stuffed, crappy ones through pedders, new but now pretty much throw away, bad mistake, and all my bushes need changing. So off to fulcrum suspension, where I'll get some tein suspension, shocks etc; put in and replace the bushes with fulcrums polyutherine bushes.post-63012-1272202781_thumb.jpg

But now with the accident today, it's all been put on hold, man whats next.............

:P

I found out that my suspension is stuffed, crappy ones through pedders, new but now pretty much throw away, bad mistake, and all my bushes need changing. So off to fulcrum suspension, where I'll get some tein suspension, shocks etc; put in and replace the bushes with fulcrums polyutherine bushes.post-63012-1272202781_thumb.jpg

But now with the accident today, it's all been put on hold, man whats next.............

:)

Did the suspension contribute to not pulling up in time - out of interest?

Insurance job (even tho' it looks as if you'd be paying Excess)?

Hope the car is all good pretty soon!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • An update regarding the registration with the DVLA I sent off the paperwork the day after I collected the car from the port, two weeks later it was all returned with a letter explaining they have rejected the application. This was because the cheque was £20 short for the road tax (I used a price list I found online). Nevermind it is what it is, it was sent back to them the following day with a new cheque. Fast forward another 2 weeks or so, I called them for an update to be told it had been rejected. Yesterday (16th September) I received the documents back along with another letter, this time it was because I didn't put an X in one box on the V750 (personalised number plate certificate), which declared that I had the rights to the personalised number plate. Why this wasn't mentioned in the first rejection letter, I don't know, but it could have saved this headache. The documents were sent back today, so fingers crossed third times a charm and it'll FINALLY be registered on the road just in time for the bad weather (woohoo!) To cheer myself up I lowered the front 25mm, was sick of seeing it sit like a monster truck. No idea how much clearance I'll have getting on and off the driveway, I'll worry about that when I can actually drive it
    • You're going to miss not worrying about rust in the strut towers like the Skyline shitboxes out there
    • A few little updates that weren't filmed due to not taking long to do or not interesting enough for their own video. My new K&N Air Filter arrived, I went with an RU-4180 which matched the dimensions of the universal cone filter the car originally had.  The battery had gone flat, while that was charging I tidied up the spaghetti wiring at the bulk head and down the sides of the engine Next job was to swap the stereo The Kenwood harness had the female ISO plugs cut off and the male ISO plugs cut off the adaptor loom and joined with bullet connectors. I ordered in a repair loom through work and re-did it all. New Kenwood unit installed (Android Auto, DAB, Bluetooth, Reverse Camera) The bonnet/hood gas struts have been poor since collecting the car. I couldn't find any suitable replacements locally so took a chance on a pair from AliExpress.  The originals don't use a retaining clip to secure the cup onto the ball fixture, would explain why I struggled for 10-15mins trying to pry off the cups. The ball fixtures unscrew using a 12mm spanner, new ones are the same size. Sadly no photo of them fitted, you're not missing much lol The dished Momo steering wheel got replaced with my Momo Tuner, turns out I ordered counter sunk bolts for the horn trim ring (like they normally are for the steering wheel) instead of allen cap (flat seat)  A terrible photo of a Quaife style gear shift knob I've had stashed in my tool box for many years after purchasing the incorrect thread size (I can see a pattern emerging with ordering incorrect parts...) Also threw in a cup holder and a (empty) Boss Coffee can, because why not  
    • GT-R clearly the better choice! The 300 is certainly not insaly fast but has a decent amount of poke. Does a nice little drift around the corners with a decent amount of throttle. It's VERY predictable in a slide too.  Feels so progressive! People probably presume there's a 25 year old driving it based on my behaviour this week! 🤣
    • Yeah Jap import. Fairlady Z then! I'm a bit the same.  They've been on my radar for a fair while but then just impulsively decided to buy one!  Was going to just buy an NA and add turbos to it later but decided to save the f'ing around and just buy the turbo version. 
×
×
  • Create New...