Jump to content
SAU Community

Recommended Posts

My R34's has been using way too much petrol lately, I get about 200km's for $50, that's close to 17L per 100km. I cleaned the K&N air filter, tried both Shell V-Power and Mobil 98 Octane, but it didn't help.

Would anyone have any idea what the problem could be? I'm thinking it might be the spark plugs, I got the premium one's put in about 30.000k's ago and haven't changed them in a while. I change the oil, fuel filter & oil filter regularly.

Thanks for the help.

check O2 sensor between the extractor and firewall. or get nissan consult and read the R34 service manual. the manuals basically covers the whole problems. PM me if u need the R34 manual copy.

the first question has to be asked, how do you drive and what mods do you have? that can rule out pretty much all other things depending on the answer.

if you have mods like a bigger turbo, etc then you will always use more fuel if you like to give it the beans often.

also if you just drive lots of short trips and spend a fair bit of time with your foot down on boost. if you do like to boost it often then you aren't too far out of the range of what you can expect, however if you do lots of steady driving and don't spend much time in traffic slowing down and speeding up then that is a bit high and the o2 sensor is probably the main cause. this can be done with a multimeter. do a search to find out how.

how long does the car take to warm up (for the needle to come up to half way)? it should come up to temp within about 5 mins of driving (or 3 or 4kms). if it is taking much longer to do this then your thermostat needs replacing and that will get you better economy because you won't be on cold start enrichment so much. coming into the colder months this can become more of an issue as you can actually get to a point where the car pretty much never warms up so you use much more fuel.

the first question has to be asked, how do you drive and what mods do you have? that can rule out pretty much all other things depending on the answer.

if you have mods like a bigger turbo, etc then you will always use more fuel if you like to give it the beans often.

also if you just drive lots of short trips and spend a fair bit of time with your foot down on boost. if you do like to boost it often then you aren't too far out of the range of what you can expect, however if you do lots of steady driving and don't spend much time in traffic slowing down and speeding up then that is a bit high and the o2 sensor is probably the main cause. this can be done with a multimeter. do a search to find out how.

how long does the car take to warm up (for the needle to come up to half way)? it should come up to temp within about 5 mins of driving (or 3 or 4kms). if it is taking much longer to do this then your thermostat needs replacing and that will get you better economy because you won't be on cold start enrichment so much. coming into the colder months this can become more of an issue as you can actually get to a point where the car pretty much never warms up so you use much more fuel.

I imagine he doesn't hit boost very often...

Thanks for the replies guys.

mad082, I don't hit the boost often since the car is non-turbo :D but thank you for the reply, I usually shift the gears around 2.5k's RPM's, I don't really drive hard.

I found a thread on how to test the O2 sensor with the paperclip method, so I will do this on the weekend. Only mods I have on the car is an exhaust system and splitfire coilpacks, I'll test the o2 sensor on the weekend, if that's fine, then I will try changing the coilpacks.

  • 1 month later...

Well I changed the o2 sensor, no improvement.

Checked spark plugs and the fuel regulator, all good.

Checked the ECU for error codes but it comes up as code 55 = no error.

I get about 320k's per full tank before the fuel light comes on.

Anybody got any other ideas with what's causing this? Bad injectors? Vacuum leak?

Fatter tires = more drag

Underinflated tires

Check for dragging brakes. Also check the park brake/handbrake.

Get your wheels re-aligned.

If your car is a manual - check for a slipping clutch

If your car is an auto get the automatic serviced.

Check the vacum line to the variable length intake manifold's acuator. This can cause the car to act sluggish at low RPMs and also lower the engine torque - therefore you will be pressing the accelerator more.

Ensure you are using light weight engine oil nothing heavier than 40 weight.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The wiring diagram for the R33 RB25 is freely available, and is essentially the same same as most other RBs (just with differences as to which pin # does which job). To get the ECU to power up, you just need to provide power to the ECCS relay, and have the other power feeds that come in from the top left of the wiring diagram (wrt the ECU) that give perma power to the fuel pump relay, the ECU itself, etc etc, all connected. When you put power on all these it will just come to life. It's pretty clear from the diagram what needs to happen. Just follow the lines from the 12V + supply stuff in the top left over towards the ECU. I've even posted snips of such diagrams (not for vanilla 25, I think for Neo and 26) to various threads here in the last few months, talking about what it takes to get the fuel pump and FPCM up and going. Search these up and they will help get you started on doing the same with the vanilla 25 diagram. Hell, for all I know, I've done the same with that one in years past and have forgotten.
    • Yep...so unless someone posts up the answer you will need to probe from the ECU connector to the dash plug with a multi meter in continuity mode to trace the wires.  Note the ECU has multiple - and + (and across different key settings - Battery, IGN and Start) and most likely the power is fed from the connector(s) that is normally near the left hand headlight.
    • Thanks Duncan, I am actually just trying to get the Rb turning and running with the RB25DET S2 original loom itself  I am just trying to get it going outside the body and not thinking about the S15 or trying to match anything to the S15 loom at all I am only trying to see if anyone has done this and what pin they found to be the ignition trigger and ECU+/- on the dash connector, that's about it. Thanks  
    • Hi Guys, Does anyone know any aftermarket part numbers for a starter motor to suit the VQ25DET? I can find lots of alternative part number for the VQ35DE, which I assume would fit, but there is a lot of conflicting information out there. Thanks..
    • I don't understand how this hasn't boiled down to - Upgrade the turbo when you have everything required. ECU, injectors, fuel pump, turbo, etc. Do it all at once.  If you don't have everything required, just enjoy the car as it is and keep saving up your pennies. 
×
×
  • Create New...