Jump to content
SAU Community

Recommended Posts

Ok my climate control is faulty, so how do I fix it? I did the diagnostic and it flashes up 25 (sunload sensor) and -26 (PBR). I don't know what the PBR is, and I don't know why it flashes up with a negative symbol.

Can someone tell me how I would fix both of these things?

Link to comment
https://www.sau.com.au/forums/topic/32565-faulty-climate-control/
Share on other sites

Oops I forgot to describe the symptoms. At night the climate control is still cold, even when set to 32 degrees. Well it's slightly warmer when set to 32, but still relatively freezing. If I turn the a/c off, it starts to warm up slightly, but still nowhere near 32, and of course then the glass fogs up because the a/c is off. So I'm doing an endless adjustment of the climate control between keeping the temperature right and the fog off the windows. It's annoying to say the least.

Thanks for that info 2fardown, I didn't think to put it in the sun to try it. Maybe it's fine, so that would leave the PBR I guess? Hmm.

er yeah.. sounds like possibly stuffed vent control.

When i pulled it all apart, worked out roughly how it works.. heater is constantly on, (although there maybe some type of control from the engine side via controlling the amount of coolant/heat going to it), basically fan blows through aircon, and there is a flap in the heater box that opens and closes. Depending on the amount of heat or cool to give you xx degrees, the flap is either full open or full closed, or somewhere in between.

Therefore it *sounds* like your flap is stuck on full close, just letting aircon through.. It could also indicate a possible electrical fault in the eCU or rest of the wiring somewhere meaning the signal to "start heating" or 'start cooling" is stuffed.

Anyhow, have a play and see what you discover.

Well I ran the second test which is meant to test the mode doors and they all came up ok. I could hear them moving around so I'm pretty sure that's not it. It just seems to have difficulty in determining the temperature.

I'll try the test again in sunlight and if that clears but I still get the PBR error I guess I'll have to look into it further. Otherwise buggered if I know what's wrong.

It could be a fault with the internal temp sensor. This is located in the dash below the gauge cluster. You can see it because it draws air in through a vent. There is supposed to be a hose connected to this vent which commonly goes missing when people remove the dash fascia.

inside the vent is a temperature sensor which is always getting really dusty. Spray some electrical contact cleaner on it after removing as much excess dust as you can.

Ill try to find a pic.

Another suggestion is to see if the heater core is blocked. Run the car to operating temp.

You should see 2 water hoses running into the cabin (not aircon) they both should be hot. if only one is hot, then the core may be blocked. just a suggestion :0-)

Ta

Mal

I spoke to someone that knows more about this thing, and they reckon that there is a valve in one of the hoses that often plays up. He reckons that this is more likely the cause than a blocked heater core. He said that it was on the inside of the firewall where one of the heater hoses comes in. Aside from that though I don't have much of an idea of how to get it out or replace it. Does the dash need to come out? Anyone with experience and/or photos please help!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • For these last 7 years of ownership, I've always had to use a small scissor jack under one of the front tow hooks to raise the front just enough so my low-profile jack fits under to reach my subframe jack point. I'm beginning to get annoyed of always having to do this. Are there any lower low-profile jacks that fit under the gtr lip on a dropped car?
    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
×
×
  • Create New...