Jump to content
SAU Community

Recommended Posts

Hey everyone,

i was just doing some searching on whether i could replace my stock GTR afms for some green label RB20/25 ones.

i have read some posts saying that it is possible, but i was wondering whether there is anyone that is using 2 green label AFM's on their GTR and what issues they experienced with it. for me it seems to be the much cheaper option than forking out for a pair of z32's. i am not chasing huge power.

my mods are

2860-5's

Nistune ECU

660cc injectors

Walbro fuel pump

3in exhaust with a 3.5in muffler

3in highflow cat

rebuild engine with forged internals

recond head done while engine out for rebuild

stock r34 GTR intercooler

stock AFM's

i had it last dynoed and got 320rwkw @ 18psi

i know that the turbos have much more room for more power. but i would be limited to the stock intercooler and 3in exhaust

but i would like to just be able to bump the boost up to 20psi and see if i could get close to 350rwkw without maxing out my AFM's

so to me paying $400 for a second hand set of z32's and getting some piping and filters for the bigger AFM's is not worth the extra 30rwkw. so if i could pick up some green label AFM's for cheaper i would be much happier, and my wallet would be a little fuller.

Cheers,

Link to comment
https://www.sau.com.au/forums/topic/326962-rb25-afms-on-a-gtr/
Share on other sites

It is doable, you will require a retune just as if you had installed Z32s or nismo AFMs.

Guaranteed it is covered more than enough on the forum, it would be almost the exact same deal as installing Z32s. You will need a new suction pipe to fit the 80mm AFMs as the stocks are 65mm and you will need the plugs for them also.

AFAIK you will also need to change your air filters.

Thats EVERYTHING you need to know.

Hey everyone,

i was just doing some searching on whether i could replace my stock GTR afms for some green label RB20/25 ones.

i have read some posts saying that it is possible, but i was wondering whether there is anyone that is using 2 green label AFM's on their GTR and what issues they experienced with it. for me it seems to be the much cheaper option than forking out for a pair of z32's. i am not chasing huge power.

my mods are

2860-5's

Nistune ECU

660cc injectors

Walbro fuel pump

3in exhaust with a 3.5in muffler

3in highflow cat

rebuild engine with forged internals

recond head done while engine out for rebuild

stock r34 GTR intercooler

stock AFM's

i had it last dynoed and got 320rwkw @ 18psi

i know that the turbos have much more room for more power. but i would be limited to the stock intercooler and 3in exhaust

but i would like to just be able to bump the boost up to 20psi and see if i could get close to 350rwkw without maxing out my AFM's

so to me paying $400 for a second hand set of z32's and getting some piping and filters for the bigger AFM's is not worth the extra 30rwkw. so if i could pick up some green label AFM's for cheaper i would be much happier, and my wallet would be a little fuller.

Cheers,

$400 for 30Kw is a very good deal, once you do all the basic stuff like ECU and Exhaust, getting a whack of power like that get's a whole lot more expensive then $400...

My 2c :D

Pluses I found for using 2 RB25 AFM's- they fit on the stock inlet piping (with a little stretching, and I needed to add an elbow to get the top one around the power steering res) and they plug straight into the standard plugs.

Pluses I found for using 2 RB25 AFM's- they fit on the stock inlet piping (with a little stretching, and I needed to add an elbow to get the top one around the power steering res) and they plug straight into the standard plugs.

Well there you go!

Although, they are the same size as a Z32 and have been said NOT to fit.

cheer's guys,

i am aware that i'll need to get a retune for the bigger AFM's, that's not an issue. i'll speak to my tuner and ask whether he is able to do it.

another tuner i spoke to about this told me he wouldnt do it, because he wont tune on second hand AFM's he only uses brand new z32's because he said that its very hard to get the tune right on GTR's because there are 2 AFM's and they could be reading differently?

all i am after is a little more scope so with a slight bit more boost i have some reading from the AFM's that isnt at full.

will post back once i get it done with the results

cheer's guys,

i am aware that i'll need to get a retune for the bigger AFM's, that's not an issue. i'll speak to my tuner and ask whether he is able to do it.

another tuner i spoke to about this told me he wouldnt do it, because he wont tune on second hand AFM's he only uses brand new z32's because he said that its very hard to get the tune right on GTR's because there are 2 AFM's and they could be reading differently?

all i am after is a little more scope so with a slight bit more boost i have some reading from the AFM's that isnt at full.

will post back once i get it done with the results

If thats the case, just get nismo or mines afm's, direct fit and same power handling as they are essentially std units recalibrated to near z32 specs. The smaller body of the nismo /mines items allow nicer low and mid tuning.

Well there you go!

Although, they are the same size as a Z32 and have been said NOT to fit.

And yes you need to change your air filter setup as the afm's (either ones) are physically bigger. The inlet pipes are quite stretchy, will stretch to accomadate 3'' piping. Keeping the same plug for the rb25's was the factor that decided it for me at the time. If I was going to keep running afm's (I now run motec) I would seriously consider the nismo option though expensive, they are brand new, have the required resolution for the sort of power you're after with a streetable twin turbo setup and fit without modification (apart from tuning of course).

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • To follow up a question from earlier too since I had the front bar off again (fking!) This is what is between the bumper and the drivers side wheel And this is the navigator side, only one thing but its a biggy! So basically....no putting coolers in the wheel arches without a lot of moving other stuff. Assuming I move to properly race prepping this car I'll take that job on and see how the computers respond to removing a whole bunch of ADAS modules
    • So I prepped the car for another track day on Wednesday (will be interesting to see coolant temps post flushing out and the larger reservoir, with a forecast of 3-14 being 20o cooler than last time I took it out). Couple of things to mention; since I am just driving the car and not taking a support vehicle, I took the rear seats out and just loaded the back up Team Trackday style. Look at all that space! To cover off removing the rear seat....it is weird (note the hybrid is probably different because it wouldn't have folding rear seats) Basically, you remove the lower seat base, very similar to a r series but it is a clip that pulls forward to release the base rather than it being bolted down. Easy Then, you need to remove the side section of the rear seat on each side. There is a 14mm head nut at the bottom of the side piece, the it slides upwards off a hook at the top to release; you also need to unhook the seatbelt from the loop at the top. Then the centre piece is weird. You need to release/fold the seats forward with the tab in the boot on each side From there, there are 2,x12mm headed bolts holding the rear of each seat to the folding bracket, under the trim between the rear seat and the boot (4x christmas tree clips there, they suck). The seat is out but you can see where the bolts attach to the bracket
    • As discussed in the previous post, the bushes in the 110 needed replacing. I took this opportunity to replace the castor bushes, the front lower control arm, lower the car and get the alignment dialled in with new tyres. I took it down to Alignment Motorsports on the GC to get this work done and also get more out of the Shockworks as I felt like I wasn't getting the full use out of them.  To cut a very long story short, it ended up being the case the passenger side castor arm wouldn't accept the brand new bush as the sleeve had worn badly enough to the point you could push the new bush in by hand and completely through. Trying a pair of TRD bushes didn't fix the issue either (I had originally gone with Hardrace bushes). We needed to urgently source another castor arm, and thankfully this was sourced and the guys at the shop worked on my car until 7pm on a Saturday to get everything done. The car rides a lot nicer now with the suspension dialled in properly. Lowered the car a little as well to suit the lower profile front tyres, and just bring the car down generally. Eternally thankful for the guys down at the shop to get the car sorted, we both pulled big favours from our contacts to get it done on the Saturday.  Also plugged in the new Stedi foglights into the S15, and even from a quick test in the garage I'm keen to see how they look out on the road. I had some concerns about the length of the LED body and whether it'd fit in the foglight housing but it's fine.  I've got a small window coming up next month where I'll likely get a little paint work done on the 110 to remove the rear wing, add a boot wing and roof wing, get the side skirt fixed up and colour match the little panel on the tail lights so that I can install some badges that I've kept in storage. I'm also tempted to put in a new pair of headlights on the 110.  Until then, here's some more pictures from Easter this year. 
    • I would put a fuel pressure gauge between the filter and the fuel rail, see if it's maintaining good fuel pressure at idle going up to the point when it stalls. Do you see any strange behavior in commanded fuel leading up to the point when it stalls? You might have to start going through the service manual and doing a long list of sensor tests if it's not the fuel system for whatever reason.
×
×
  • Create New...