Jump to content
SAU Community

Recommended Posts

my car started developing this terrible belt squeal on cold starts. it's only happening for the past week since it got colder...but it goes away after bout 5 minutes.

had the serpentine and a/c belt replaced y'day but now the squeal is louder :D

the old belts looked brand new too with no signs of wear. wondering what else it could be??

pointless leaving it at the dealers coz it does not happen at any other time of the day only in the morning when the car has been garaged overnight.

Link to comment
https://www.sau.com.au/forums/topic/327195-belt-squeal-on-cold-mornings/
Share on other sites

I had the same problem. I had both my belts replaced a few months back but they didn't tighten them enough. Now that it is cold, until the belts get a bit of heat they start slipping causing the squealing. I took mine back to the dealer who changed the belts and got them to tighten them, which they did for free.

I had the same problem. I had both my belts replaced a few months back but they didn't tighten them enough. Now that it is cold, until the belts get a bit of heat they start slipping causing the squealing. I took mine back to the dealer who changed the belts and got them to tighten them, which they did for free.

did that get rid of the squeal?

ps levels looks ok...i did do a top up about 10,000kms ago and it's remained at the same level since. could be the ps lube is getting on and thickening...dunno...maybe

i'm going to send the car to get the belts re-adjusted since I only replaced them yesterday...see if that helps.

I have this issue as well.

Had the belt replaced about 2 months ago after a bolt from the bottom of the engine ha worked itself loose and was eating away at the old belt.

The new belt squeals for about 5 seconds on start up when its cold. Havent got arround to tightening it yet, there a a few tensioners for these belts by the looks of it!

Just a thought ( if your brave enough ) when the engine is running grab a piece of ordinary blackboard chalk and try to touch it onto the inside of the belt as it goes around.

Doesn't sound like much but is an old trick old mechanics used.

I have tried it before on older model cars including my old 31, seemed to do the job then.

Have you tightened the belt tensioners? There are two of them. When it's cold the metal pulleys get smaller and expand when they get hot also if you've had new belts put on they loosen a bit once they break in, you'll need to tighten them once that happens. Note you should only need to tighten your belts up occasionally...if you're constantly tightening the belts then there might be some other issue.

I used to own a Corolla with the same problem. I think the coldness dries out (or freezes) the belts. A bit of WD40 did the trick for me... I bit of a spray (DO NOT soak it) in each side of the belts where it connects to the pulleys.

Edited by Bourbon Boy

had my first belt squeal last night, damnit! Hopefully it can be attributed to the fact that it was freezing, and raining: pretty sure the bonnet vents were letting water drip onto the belts: I was parked on a relatively steep hill...

I get a one second squeal from my A/c belt. I know because when i start the car in the morning and have the A/c on it's even longer.

But i also have light wieght under drive pulleys with new belts and when i got them thats when the squeaking started.

ask rianto what he did...he got his belts changed at the dealer and they squeeled next day. he took it back and they adjusted the tension of the belts i think...

mine squeeled and were deteriorated so i got mine changed and the problem went away. so it really depends on how well of a job they did in changing your belts.

Just had the belts done on mine - next cold morning they squealed for about 30s or so. Took back to dealer who did the belts, they re-adjusted the tension and now all good, squeal gone. Story from the dealer was that the belts expand a bit after installation so they very rarely get the tension right first time.

sent it back to the mechanic to re-adjust the tension...so far I've got no more squealing so i guess my last belts only needed retensioning...went a bit overkill getting new belts but at least i dont have to worry about it again for a while.

oh and I got the similar story about the belts stretching and it being quite common that they need to re-adjust after a day or 2.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Hi GTSBoy, Excuse my ignorance but what does a "Bad" Knee point mean ? 
    • HFM BM57 has a "bad" knee point, IIRC. It's not the same thing as the later R chassis MC.
    • The ATTESSA is functionally identical to R34; there were a bunch of JDM models that continued ATTESSA including Fuga/Q70, Skyline/Q50, Cima etc as an option. All with Auto only and I think mostly for snow regions. AFAIK there were no AWD VR30DDTT sold in Australia - it is on my to do list to check regs for racing a LHD car in Targa/ATR/AASA/CAMS events because if I can get the auto to work it would be interesting to run a 4wd car The Ecuteck TCM tuning is the same model as their ECU tuning, they already have it for R35 and Dose's favourite, BMW. You buy "points" to allow your computer to be tuned, buy either a bluetooth (phone app) or bluetooth+USB+Key (phone and PC) dongle, and pay for a tune that will be locked to your tuner ( ). You can also access the tuning software yourself but 1. it is mega expensive and 2. these computers have a billion parameters that intersect, so how could you ever spend enough time on it to get a decent result.
    • Or, is it a case of what it is like owning an R series Skyline? NFI what the previous owner has done or fiddled with... Ha ha ha After reading through this thread, I went on a bit of a research about the Q50/Q60. Now I'm quite intrigued by them! Is the AWD in them more like a WRX where it's always AWD, or is it more like the ATTESSA in the GTRs? By the sound of this TCU tuning, this sounds like a case of someone has made some real software for it, and you just need the right piece of hardware, and then you license that specific vehicle/TCU. Or is this a case of the software will be really expensive so only a few tuners have it, and you still have to pay a license per vehicle?
    • By popular demand.. it was a coil. Got my hands on 1 new OEM coil, replaced with the one that made the less noise difference when I unplugged it while the car was running and started the car up. No stutter and the engine light was gone. I guess I’ll buy the other 5 they have lol
×
×
  • Create New...