Jump to content
SAU Community

Recommended Posts

usually located next to the fuse panel under the steering wheel on the right hand side... however the clip that holds them in place isnt very good, and the consult port can usually be found floating around somewhere up under the drivers side foot well

from memory HR32 doesnt have OBD ver1 or ver2 connector

i think you can only do consult diag via the wire short trick and it flashes a light code

does your ECU have a light on it for diag ?

Cars with ODB connector have the connector and no light on the ECU

yeah paul, r32's do have consult port

unless your wiring has been totally messed with... it will be under the dash on the drivers side... not near the ecu

usually next to the fuse panel or as i said above, floating around above it... can be hard to find, but should be there!

what month/year model is ur r32? not before sep 89 is it? if so connector might have been wired in at the ecu

who put the nistune in? previous owner? ask them where the port is, if not in normal location?

Went to my mates place to check where his was and sure enough found it instantly above his fuse box, went back to mine and sure enough it was in the same place.

So confused how I spent 20 minutes looking and couldn't find it but found it immediately on another car.

Strange.

Edited by Rolls

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The filter only filters down to a specific size. Add to that, the filter is AFTER the pump. So it means everything starts breaking your pump even if its being filtered out.
    • Just like in being 14mm too small (296mm) makes it not fit, being 14mm too big (324mm) it also won't fit. You want to find the correct rotor.
    • @GTSBoy Ok so that was the shops problem...they showed R33 rotors on R34 page and i did not know 296 do not fit(and are for R33) Yes i bought "kit" with rotors and pads. Pads are ok(i have GTT calipers front and rear). They have some 324mm but no 310mm. So i dont know if they would fit. I have 17inch LMGT4s So another question. Can i fit those in the rear or they are just "too" big for that?
    • I started removing the tank a while back with the intent to give it a proper clean. Got to a bolt that I couldn't undo completely due to a diff being in the way, so just said f**k it and siphoned the gluggy old fuel out and called it a day. Looking it the tank it looks less corroded than the one in the pics for that billet hanger from Frenchy's anyway. Isn't it the fuel filters job to worry about this stuff? I scraped off most the crusty shit of the hanger but will give it another go before reinstall coz maybe the fuel and return pipes are also full of gunk  
    • Pretty sure it is a common fault. I believe this is the only part you need, but don't quote me as I don't have a V36.  I also believe it is a bit of a pain to change and the device needs to be encoded to the car once it is replaced, so may need someone with the right tools. Buy Genuine Nissan 48700JF00D (48700-JF00D) Lock Set-Steering. Prices, fast shipping, photos, weight - Amayama
×
×
  • Create New...