Jump to content
SAU Community

Recommended Posts

Since fitting the plenum, after driving around a bit, when I stop a bubbling/gurgling sound, it almost seems like coolant is boiling, comes from the rear of the motor

and I think it is in the hoses for the heater or that goes to the turbo. Remember it is not the standard set up as in the plenum fit the original circuit that goes to warm up the throttle body is not there. It was cut out and another line inserted to cool the turbo. I retained the bleed valve on top at the front.

I have bled the system five or six times to no avail. On a trip the temp does not get above centre of gauge and oil temp does not go over 110 even after hard driving.

Today it started to loose power completely just as it came on boost. Back off and away it goes AOK. Then it does it again. Turned round and went home up Henri Robert without a prob but it had to be driven off boost. Very difficult.

I am thinking there could be a connection with the coolant to the turbo.

Any ideas please???

Link to comment
https://www.sau.com.au/forums/topic/331771-air-trapped-in-coolant-system/
Share on other sites

find a steep driveway and park nose up

also grab a coke bottle, cut the bottom off, wrap the small end (with the thread) in insulation tape then fill it with water

crack the bleeder bolt with that in, should force all the air out as its higher than the motor

hope that helps

did you hook all the water lines up the right way . there is only 1 thread with the right way on here

I followed ix9's DIY on Skylines. The only difference is that I retained the air bleeder.

Where is this "right way" thread???

  • 2 weeks later...

Is the top pipe going to the radiator feeling like it's boiling after the engines off?? I'd say you have a leek somewhere, my 260 was boiling like I said few months later the top tank shat it self, maybe just upgrade that with a nice think nismo number and low temp thermostat, if not u didn't go backwards! ! Have u ever added different coolants? This is goof to give u problems if so!

Still getting this gurgling sound after turning off engine. Tried bleeding etc. etc. etc..

Any more clues please???

chef_stagea said:
maybe just upgrade that with a nice think nismo number and low temp thermostat, if not u didn't go backwards! ! ...... This is goof to give u problems if so!

Good recommendations your giving here Adam you ****. On what basis is a lower temp thermostat and new radiator going to stop this gurgling sound?

To the issue:

So you have tried bleeding the system?

Radiator is full of coolant and the overflow tank is close'ish to the max line?

Yes Chris. Its all full. Had it parked uphill tried bleeding, which seemed to get a lot of air out, but still gurgles, and the sound comes from the back near the firewall. The sound is a steady "GLUG, GLUG, GLUG" after turning the engine off.

I am sure I connected all the water hoses the way it was detailed in ix9's DIY. The only thing I did different was to retain the bleed plug on the top of the engine.

I am using Nulon coolant.There does not appear to be any oil in the coolant nor coolant in the oil. My worry is that where the gurgle comes from is where the new connection was made for water to the turbo. It is a stock turbo, and I dont want to cook it.

Funnily the Stag is running really well after the mods. Fuel economy has improved to about 11L/100ks on the only trip I've had. Water temp on the stock gauge is still the same and my oil temp gauge is still reading the same.

what did you change? (what mod did you do)

b4 you bleed, crank the heater to full hot, could be air in the heater system, the hoses for that run around the back of the block

tom could you please go into further detail on your hill coolant bleeding method for future reference?

Are we putting the coke bottle with distilled water/coolant in the radiator cap or in the bleed screw as that what it sounds like....

coke bottle goes into the rad cap so you can raise the water level above the plenum

or you can put the nose up a hill to do the same

or do both if you so wish

thats how you are supposed to do vl's because holden put the radiators too low for the rb30

Someone has mentioned the little bleed screw near the thermostat by now surely? ( too lazy to read thread )

I had a really weird problem like this in my Pulsar - turned out the thermostat was bung.

something to look at I suppose

Someone has mentioned the little bleed screw near the thermostat by now surely? ( too lazy to read thread )

I had a really weird problem like this in my Pulsar - turned out the thermostat was bung.

something to look at I suppose

The bleed screw has been tried. I fitted it back at the start so the system could be bled. Might look into the thermostat.

Come to think of it now

mine gurgles sometimes after I turn it off

usually after I get stuck into it

sounds like it's coming from the back of the block between the firewall,my heater core has been byPassed too

Come to think of it now

mine gurgles sometimes after I turn it off

usually after I get stuck into it

sounds like it's coming from the back of the block between the firewall,my heater core has been byPassed too

Now we are talking. Why is it so????

i suggest using pipsters coke bottle trick and getting the motor to operating temp and holding the rev's at about 1500 rpm to help the coolent circulate then let it cool down you may have to do it a few times

it always has worked for me

maybe also pull a heater hose just off to se if you have coolent in the heater core

I might try and bleed out abit of air Sunday arvo

wen I first heard the gurgling I was well concerned that i'd f**ked something

it not a nice noise

haven't heard it in a while as I've been driving like a nanna(kidafa) cos I'm too scared I'll pop another cooler pipe

I need to shorten my heater core lines anyways while I'm at it cos wen my heater shat itself I just joined the hoses from the easiest spot and the stupidly long now for no reason

I might try and bleed out abit of air Sunday arvo

Why bother like its going to help your green, automatic baby seat carrying bucket one bit.

wen I first heard the gurgling I was well concerned that i'd f**ked something

Try fitting blue mesh, should magically make all issues vanish

haven't heard it in a while as I've been driving like a nanna(kidafa) cos I'm too scared I'll pop another cooler pipe

Sorry rod

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
    • You haven't driven many modern cars then have you? Most of them have sfa steering feel with their stupid electric bullshit steering systems.
×
×
  • Create New...