Jump to content
SAU Community

Recommended Posts

780hp. Check it out.

http://speedhunters.com/archive/2010/01/21...ys-tas2010.aspx

Anyone know how much do os giken 2.4 kits go for roughly?

More money than you have J & more than I'm prepared to spend.

I'm looking at 350HP at the wheels from a 2.1L FJ20 and that will be a handful, so why would you even consider what a 2.4 is capable of.

D

More money than you have J & more than I'm prepared to spend.

I'm looking at 350HP at the wheels from a 2.1L FJ20 and that will be a handful, so why would you even consider what a 2.4 is capable of.

D

Because he can consider it??? Does it matter? More cubes means less boost = more driveable car???

If money was no object i'd be building a FJ24 for sure :worship:

What you think the RB26 boys pay for thier OS giken etc 3 litre kits???? Bit more then 10k i'd hazzard a big guess!

I can tell you for fact, that the 3.0L RB conversions in the US were nearly all done with aussie supplied RB30 bottom ends and they were getting them for about $500.00 plus freight.

The Japs maybe, but I was shipping RB30E bottom ends to Boston at the rate of 24 per year for a couple of years and making a tidy profit. 3 per crate and I was buying them steam cleaned for AU$60.00 each & selling them for AU$500.00 each.

D

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • neither stumble or cut really seem to be an appropriate term....hard to explain its like a rev limiter but at 4k, but it violently shakes engine and entire vehicle as the rpms will not rise over 4k, even with slow acceleration. as soon as it hits 4k, it sounds like entire spark is lost entirely. plugs were 1.1 which I used as such, but later put in new plugs gapped down to .8 changed back after issue arose when I replaced the coils, still does it with either plug gap...damn and it was all running so good.
    • Oh how times have changed! I actually lean it out relative to my water/methanol injector duty cycle. The methanol adds a lot of fueling and you can then lean it out even more due to reduced knock. 
    • Yeah my thoughts are the same, a well thought out WMI setup, would be slightly ahead of just straight E85 and you're also chemically intercooling the charged air, dropping it even further. This is why you need to add so much more fuel as soon as you spray. I remember someone taking me through their set up before (Dennis, has a R33, lives around Cabramatta - no idea if he's still around on this forum). He would target AFR 10:1 on 98, then as WMI ramped on, AFR would lean back up to 11:1. Amazingly, he did this all through his PowerFC, a relay to cut power to his EBC solenoid if there was not enough line pressure on his WMI kit. And of course, if there wasn't any boost made above gate pressure, you wouldn't be accessing the load cells with heaps of timing for WMI. One downside to that rudimentary setup, once the WMI came on, the EBC would unleash the dragon, and of course all the timing. Tyres would fry lol.
    • Shimmed or shimless, still solid, no hydraulic pump up stuff.
    • They have said food will be limited. Mainly meat pies and sausage rolls from memory. But they have a coffee van!
×
×
  • Create New...