Jump to content
SAU Community

Hel Stainless Steel Braided Clutch Line Group Buy


Recommended Posts

  • Replies 187
  • Created
  • Last Reply

Top Posters In This Topic

Cheers man.

Pintaline is going to wait for the next one (good man!) so that's that sorted.

They are all packaged and ready to send tomorrow so every one should have them by Friday since it is going with Express Post.

Just a reminder to the GTT boys, I got you guys GTST clutch lines so please let me know if they fit (99% sure they will) so I can inform Hel to add the GTT to their list.

Awesome, thanks for letting me know guys.

It's fairly easy to do yourself, most annoying thing is bleeding it.

Just once again, let me know if they fit.

The clutch lines are unknown.

Hey buddy, do you currently have any leftover braided brake lines kits for R33 gtst,

Im interested in getting a set from you. Ebay is selling them for $175 deliverd to your door

How much can you get them for..

thanks mate

Edited by manuel

Hi Phil,

Do you plan on running the clutch and brake line and sump bolt group buys again if there is enough interest?

  • 4 weeks later...
  • 3 weeks later...

I will be doing an order with them in the next week because we need some lines for our Wilwood group buy. So I will message you before I place the order to see if you are still keen.

Got the line installed but just to let everyone know, you gotta modifiy the fitting a little to make it fit. According to Dan (the mechanic that does all my work) the banjo is at an angle which will cause abrasion. Thats for the 33GTR.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Wrong question. There's no point in spending the rather large sum of cash and effort to add turbo, without taking it to the "sensible" limit of the motor itself. If you have to upgrade injectors, etc, then so be it. That is a tiny fraction of what it will cost you to turbo it.
    • Measure voltage at the starter solenoid terminal when the key is at start and it has clicked. If it is really low, then the suspicion falls on the ignition switch (contacts or wiring thereof) as causing a voltage drop instead of sending enough volts to throw the solenoid all the way to engage the starter itself. If it is a decent voltage, then the suspicion is on the solenoid. Might have s horted coil, or might hva dirty contacts. Rip the starter off, dismantle, clean up contacts and inspect winding. It might not be possible to see if there is a short in the winding though. I have a spare starter here that I could measure the resistance of the coil, as a guide to about what it should be, if you need a comparison. <parts hoarder>No you cannot have it.</parts hoarder>
    • lights are on just the one click.  
    • Absolutely matters because, while a temperature change will eventually reach a sensor at the end of a static line, the response time is far far far too slow to be useful. Might as well not have a temp gauge at all.
    • When I was eyeing off the 370GT (after deciding I didn't want to spend 30-40k+ to relive my early 20s in an R33) I thought it'd be a good project to add a turbo to it. Now that I have a 370GT, and I've had a couple of chances to open it up, I'm pretty stunned by how much power it makes 🫠 Honestly, the way the VVEL opens it up, it almost feels like there's a little turbo tucked away in there somewhere. It's like Nissan looked at VTEC and said "hold my beer" 😁 Has anyone thrown a turbo into their 370Z or 370GT? Is there a conservative boost level you can run without having to upgrade the fuel system, or are bigger injectors and a bigger pump a given?
×
×
  • Create New...