Jump to content
SAU Community

Hiding Boost Controller

rdirty3

By rdirty3,
in Engines & Forced Induction

 Share

Recommended Posts

  • Replies 44
  • Created
  • Last Reply

Top Posters In This Topic

Popular Days

Top Posters In This Topic

Popular Days

Popular Posts

Wizza181
Wizza181

I know this is a old post but i just hid my boost controller and wanted to show some photos to give people ideas if their thinking about ways to do it. All i did was pull out a small fuse box out of

Posted Images

GTScotT Grand Master

GTScotT

Posted
Posted

Realistically, they can do whatever they like. It is your word against theirs.

To get behind that trim piece, you can simply undo the screws holding it in behind the ash tray and above the speedo. From memory the rest of it is clipped in. Be careful though, it is fairly easy to crack. You also unclip the gearboot and there are a couple of screws for it under there too. Logic will prevail with this one if you take your time..

Best bet is to feed it into the glove box, that was its reasonably out of the way and you can still get to it. Generally if they actually look in your glove box you are up the creek anyway, yet having it there will minimize the attention.

GL

ARTZ Grand Master

ARTZ

Posted
Posted
i want to hide my boost controller?

how do i get into this compartment see below?

post-75167-1284382352_thumb.jpg

You do realize it wont be hidden now that you've told everyone where it is... ;)

May as well just hide it in your ashtray like normal people..

Are cops allowed to physically touch any parts of the car?

Ive heard they can even touch your bum :blink:

tridentt150v Grand Master

tridentt150v

Posted
Posted

It all depends on how you drive and what you are doing............like me, many ppl have SAFC and boost controllers mounted on the dash/steering column/console and have no problems with it.

I've been pulled over and they have looked at the car while I've done a RBT and then let go with no problems. But then again I don't use the road as a burn out pad or a race track.

So wanting to hide it is sort of suspicious???

yogibear Community Regular

yogibear

Posted
Posted
It all depends on how you drive and what you are doing............like me, many ppl have SAFC and boost controllers mounted on the dash/steering column/console and have no problems with it.

I've been pulled over and they have looked at the car while I've done a RBT and then let go with no problems. But then again I don't use the road as a burn out pad or a race track.

So wanting to hide it is sort of suspicious???

not sure where u come from , but being defected every time you move isn't very fun.

paulr33 Grand Master

paulr33

Posted
Posted

and when cops look for a boost controller they would usually look from the engine bay and look for vac lines running all over the place

people usually use coloured shiny vac lines they buy from autobarn etc so its easy to spot

use blank simple lines and try to make it look oem. but the vac lines always run to a solenoid of some sort, so thats the easiest way to find it with the controller hidden or not

rdirty3 Contributor

rdirty3

Posted
  • Author
Posted
It all depends on how you drive and what you are doing............like me, many ppl have SAFC and boost controllers mounted on the dash/steering column/console and have no problems with it.

I've been pulled over and they have looked at the car while I've done a RBT and then let go with no problems. But then again I don't use the road as a burn out pad or a race track.

So wanting to hide it is sort of suspicious???

i want to hide it inside the dash/steering wheel/console area, how do i "unclip" it to get in there?

Rolls Grand Master

Rolls

Posted
Posted (edited)

In my R32 I cut the ass out of the ashtray and mounted it inside there, when you flip it open it looks very tidy. Hid the solenoid underneath my AFM so that you need to unbolt the entire POD assembly to be able to even see it, no cop is ever going to find it.

All the wires and vac hoses are cable tied underneath it as well.

Edited by Rolls

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • dbm7
      R34 Skyline climate control unit transistor

      By dbm7 · Posted

      That's not a transistor --- it's marked ZD1 which makes it a zener diode. As to what the breakdown voltage is, not enough there to divine.
    • bilbo117
      R34 GTR Seats / No longer reclining

      By bilbo117 · Posted

      Hi all, Long time since I've posted here. Looking for some advice on what I can remove to further identify the cause of my issues.  I can move the passenger seat forward and back but the knob used to adjust the seat angle is pretty much free spinning, there's very little resistance.  Removing the side cover I can see that the chain is intact but the shaft for the adjustment spins without the gear attached to it moving.  What's my next step for disassembly here? Is this a common fault? Just being a little cautious as I didn't want to start removing bolts for a spring to fly out or something equally as stupid.  Cheers
    • joshuaho96
      Ethanol Content Sensor - Always at 11%?

      By joshuaho96 · Posted

      The incentives are mostly the same, yes. Ethanol is cheap compared to the cost of doing 98-100 RON with crude oil alone. 87 to 93-94 AKI all with E10. In 2020 Canada mandated E10 as a part of their "renewable fuel standard" and is supposedly going to go to E15 in 2030. In California where there are only 8 refineries with two threatening to shut down next year it's been over 20 years now of E10 and 91 AKI maximum because there's just not enough refinery capacity or crude oil supply relative to the demand for premium unleaded fuel. And CARB's low carbon fuel standard means functionally none of the diesel available at the pump is made from crude oil anymore. It's almost all entirely 20% biodiesel blended with 80% renewable diesel (hydrotreated vegetable oil) now. The number of gasoline vehicles that support E15 or higher ethanol concentrations is surprisingly low, I can't imagine it being wise to play tricks like this without flex fuel sensors in most of the fleet.
    • GTSBoy
      R34 Skyline climate control unit transistor

      By GTSBoy · Posted

      It's almost certainly the same as the one next to it. Have a fish around amongst these hits https://www.google.com/search?q=surface+mount+transistor+m33&sca_esv=9cb49794e0b2005d&source=hp&ei=2vJ5aNjTB7Kw0PEPldnS8QM&iflsig=AOw8s4IAAAAAaHoA6qkfmF6XcygtrZ4Vu9f92NXF_RFd&ved=0ahUKEwjYqIPP7MWOAxUyGDQIHZWsND4Q4dUDCA8&uact=5&oq=surface+mount+transistor+m33&gs_lp=Egdnd3Mtd2l6IhxzdXJmYWNlIG1vdW50IHRyYW5zaXN0b3IgbTMzMgUQIRigATIFECEYoAEyBRAhGKABMgUQIRigAUjKCFAAWABwAHgAkAEAmAHfAaAB3wGqAQMyLTG4AQPIAQD4AQL4AQGYAgGgAuYBmAMAkgcDMi0xoAfMBLIHAzItMbgH5gHCBwMyLTHIBwU&sclient=gws-wiz
    • GTSBoy
      Blue slip

      By GTSBoy · Posted

      South Australia, which is hardly as far behind as the rest pf Oz makes out, and who is also not a paragon of progressiveness (read that as over-legislation) in the area of vehicle standards, has this to say on the subject: Adjustable coil-over suspension Aftermarket adjustable coil-over suspension components are suspension units that incorporate an external thread on the main body and corresponding threaded spring saddle that allows the vehicle's suspension height to be varied. If fitting aftermarket or coil-over suspension components you must submit an Application to modify a light motor vehicle form and a report from a light vehicle engineering signatory (LVES).
×
×
  • Create New...