Jump to content
SAU Community

Recommended Posts

Hey everyone, as most of you know I am new to Sydney. My car is in dire need of a tune as it is still running the base Apexi program since rebuild. I was interested in peoples experiences with the different tunning shops Sydney has to offer. I have booked in at UAS for a mixture check ,but, have been put back by the $80 fee(some $30) more than Adelaide, and more expensive doesn't always mean better. I previouly did most of my tuning my self with a wide band sensor and meter. I don't know if any of the shops here are as trusting in adelaide and would lend one out. Sure does save alot of money(6 hours of my own road time and half an hour on the dyno). I think the end result comes out alot better as part throttle mapping can only be done properly on the road.

Link to comment
https://www.sau.com.au/forums/topic/33875-best-dyno-tuners/
Share on other sites

  • Replies 50
  • Created
  • Last Reply

Top Posters In This Topic

With tuning you really do pay for what you get. CRD in Silverwater, Jim in particular has a reputation as being one of the best tuners around.

Granted their $600 odd charge for a comprehensive dyno tune is above what other places will charge, but ultimately the tune will make or break the car so im my eyes its money well spent.

Ben at UAS is also good with power FC's and should be able to sort you out.

Link to comment
https://www.sau.com.au/forums/topic/33875-best-dyno-tuners/#findComment-679097
Share on other sites

With tuning you really do pay for what you get. CRD in Silverwater, Jim in particular has a reputation as being one of the best tuners around.

Granted their $600 odd charge for a comprehensive dyno tune is above what other places will charge, but ultimately the tune will make or break the car so im my eyes its money well spent.

Ben at UAS is also good with power FC's and should be able to sort you out.

I was a beleiver in "u get what you pay for " to ,but, myself and a dozen others from Adelaide have had issues with a certain shop who has charged for five hours work only to really spend an hour and a half. To make matters worse there have been issues with overly advanced mapping causing detonation and even cracked ring lans. I had my car tuned and rang back fifteen mintues later because it was detonating at 5000rpm. i was told not to come back in as they didn't have time to re-map. "Just turn the cam sensor back a little, it won't hurt any power they said"

The best tuner I had didn't even work at a dyno equipped shop and charged half as much.(hired dyno time). I have seen countless people throw good money away from not knowing any better. Having rebuilt my own engine, nothing p's me off more to be feed :bs!: to part with ur hard earned cash.

I have also heard CRD are very good.

Link to comment
https://www.sau.com.au/forums/topic/33875-best-dyno-tuners/#findComment-679155
Share on other sites

A friend was recently charged $750 for a CRD powerfc tune, however, i cannot provide you the full details on what was done, to the best of my knowledge it was just a tune.

On the weekend I was provided with a PowerFC tune by the Hitman. It was a road tune using a wide band a/f sensor and my hand controller.

I'm very pleased with Mat's tune. I have noticeable performance increases throughout the rev range and within every gear. Some comments were made on my previous tune and im sure they were dealt with and rectified where necessary. I still have some detonation which i will hopefully have sorted shortly.

Mat had a laptop with PowerFC software but unfortunately we couldn't get it to talk to the R34 PowerFC. Mat also personally owns an R33 GTSt.

Mat usually charges $300 for a road tune.

Link to comment
https://www.sau.com.au/forums/topic/33875-best-dyno-tuners/#findComment-679221
Share on other sites

I haven't had my own car tuned and im not aware of anyone that has but im happy with UniGroup's (www.unigroup.com.au) attitude and expertise towards tuning.

I'd happily drop in and have a talk with them when I get my PowerFC.

Link to comment
https://www.sau.com.au/forums/topic/33875-best-dyno-tuners/#findComment-679240
Share on other sites

  • 3 months later...

hey boostd i got a mate at C and V performance, they do a really good tune if you like, they keep my car in tune when i got racing and was impressed with what the can do.

also croydon austosports do a whole tune for about 800, but that means when it gets off the dyno your car will be a weapon.

Link to comment
https://www.sau.com.au/forums/topic/33875-best-dyno-tuners/#findComment-850832
Share on other sites

has anyone used hitman since he moved into the workshop at moorebank? do they have a 4WD dyno and does he charge more now? (of course after dyno time is considered)

Nope! its only a rear wheel drive dyno! Dunno if he charges extra...possibly a little bit more ontop of his base $300...

Hes also on these forums - Hitman...so can always PM him :rolleyes:

Link to comment
https://www.sau.com.au/forums/topic/33875-best-dyno-tuners/#findComment-856546
Share on other sites

When I'm not doing it, my car is tuned exclusively by Unigroup Engineering.

www.unigroup.com.au

Yavuz and Valent are very communicative guys and have tuned some very very fast and big dollar cars that are still running hard.

I cannot speak highly enough of their efforts in correcting my tune on the pfc. Less ignition advance, more fuel, same power. They are also happy to tell you exactly what they're doing as they do it which helps you stay in the loop.

I must have picked their brains 20 times since first going there, (phone, email etc) and have found them more than happy to chat.

Yavuz also operates one of the dynos for Dyno Dynamics at Summernats. Expert with the Power FC and how it should be tuned for our cars and your application.

Adrian

Link to comment
https://www.sau.com.au/forums/topic/33875-best-dyno-tuners/#findComment-856626
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • So, version 4 intake is on its way I was looking at these a while ago but at around $200 or more it was a little pricey for something that might not work, but, I had it in my watch list, but, I got a message saying it was on special, and I had a code thingie to use, it eventually came in at $120 delivered, so BAM, BUY NOW.....LOL I'll need to have a look when it arrives but I feel it will "look" better than what I currently have, as it comes with a PCV fitting, so I will be able to get rid of the alloy pipe that goes to the throttle body with the PCV fitting  Well, that's what the voices in my head are telling me  Oh, and this happened today Yeap, it was a Trojan, and it was cheap, so I headed back to the hardware store and actually spent a little bit more on a heavy duty,  one that was actually recommended by a plumber mate, a Cyclone one with a fibreglass handle that is actually rated for clay The broken shovel will eventually be "modified" into a short handle shovel
    • When you pulled it off, there is no signs of blown head gasket? Is it possible you have some other issues going on? Possible cracked blocked? Or do you think it's straight up lifting the head? Did you check what the head was torqued to before pulling it down (To see if possibly they're stretching, or starting to break threads out etc)?
    • Seems like a decent result for a modded JZX110. They are bulky in comparison to the 100 and 90 models (which I'd prefer myself) but they are getting very few and far between here in JP these days. Thanks for the detailed review and the import process into the UK. I also have a car which I'm hoping to export from Japan at some stage so it's good to know if someone from the UK was interested in it. By the way the corrosion underneath is par for the course for cars which were located in/near the mountains or along the Japan sea coastline. They get huge amounts of snow every winter and the sodium chloride is used on the roads. Many cars have some kind of rubber like treatment underneath but they tend to limit it to the wheel arches underbody and fuel tank. Suspension arms and sub-frames will have similar corrosion to your JZX110 which is a common sight. See it all the time and car dealers here generally don't even mention it unless asked.
    • If the sound goes away when you clutch in, the 1.5/2 way diffs are just shit, and you are a normal person. The diff is likely "fine" but driving at anything under 30kmh is a violent horrible experience. It would be exaggerated with solid diff bushings and subframe bushings if you have those.
×
×
  • Create New...