Jump to content
SAU Community

Recommended Posts

  • Replies 62.7k
  • Created
  • Last Reply

Top Posters In This Topic

  • chaos

    7164

  • Ska

    5791

  • BelGarion

    3645

  • Nexus9

    3590

Top Posters In This Topic

Cut wire #53 on the ECU harnes to disable the 180 kph speed cut. The wire is yellow-green with a silver trace. Insulate the bare ends with tape. Maybe wire in a switch to enable / disable the speed cut.

Note:

This impacts the HICAS diagnostic mode - will not exit the diagnostic when 10kph is exceeded.

This mod is only for legal off street activities - ie drag racing, circuit racing, speed trials (eg the annual Ohakea trial) or if you live in a country where the speed limit is over 180 kph.

It is up to you to ensure your engine does not run lean at high speed - you will loose your engine if it does.

skyline%20ecu%5B1%5D.gif

courtesy: http://www.overflow.250x.com/

Ok...what's with the birthday crap....you and I have the same b'day Erin....so following that logic.....It's your birthday too.....what's the go??....or am I missing some joke?

I dont know I just read a post saying it was your birfday and I didn't wanna miss out on the fun!!

But if it's my birthday too.. I'm kinda missing the FMIC i've been begging soo long to get :P

14.6.. but it had a blown motor... it was ticking madly when i got out for my time slip... should have done a mid 13.... thats wat i was hoping for....

id be happy with a high 12 now...   should do it... just depends on me really

And the gearbox :P

The car looks sweet though. I like simple; tint, lowered but not extreme and a good set of rims. Its a winning combination!

I dont know I just read a post saying it was your birfday and I didn't wanna miss out on the fun!!

But if it's my birthday too.. I'm kinda missing the FMIC i've been begging soo long to get :P

can you tell santa or the easter bunny or whoever is responsible for birthday pressies that I would like a FMIC too please, as well as a 3" dump pipe....thanks :)

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Maybe also really stiffly sprung track cars. Get the inside wheel up in a corner and all the fun stops. Also me sometimes (rarely) when I have to stand on the brake to convince the diff to drive the wheel that is still on the ground when I'm trying to diagonally get over severe driveway entrance, etc.
    • I feel like I'm missing something. You had an authorised installer come out and install a new alarm. Post install the car doesn't start, and you aren't getting the installer back to fix what they did wrong?
    • So either way it is gearbox out and look what is wrong?  I know about the input shaft bearing. Even before swap/new clutch the it sounded exactly like this: So is that inout shaft bearing or the other was installed backwards?  And can some please tell me the part number for that input shaft bearing? The gearbox is small box from R34 N/A and number is FS5W71C. Thank you  
    • I am yet to see anyone ever regret a quaife or helical. ...other than drifting/skidpan duties. I kind of want to upgrade my factory helical with a Quaife (but really it's not ultimately that different, and is a MASSIVE UNDERTAKING), that's how good the hype is about them, that I want to try them 'just to see'  
    • D2 and Ksport are essentially the same thing and basically just generic Taiwanese manufacture. Better than ChinaBay crap, but... not top shelf. Öhlins have got to be some of the best dampers around, so likely to be a good option. It's going to get to the point though where I suggest you buy from Oz. We have at least 2x excellent options here. If I were you though, I'd be talking to KW about doing something for the R33. There's bugger all difference between that and the 32. In GTR land, anyway.
×
×
  • Create New...