Jump to content
SAU Community

Recommended Posts

  • Replies 62.7k
  • Created
  • Last Reply

Top Posters In This Topic

  • chaos

    7164

  • Ska

    5791

  • BelGarion

    3645

  • Nexus9

    3590

Top Posters In This Topic

i am talking 93 or 94 model.. i have been looking on yahoo auctions for a bit of a rough indicator.. 400 - 600,000yen.

of course 1997 or so above they jump WAY up.

But the earlier ones seem to be around the same price of soarers.. and soarers i am sick of seeing, too many around.

but i am going off yahoo auctions and whacking $7k ontop for landing and compliance.

Its the best i can do to get a rough guide at the moment.. if its too expensive i wouldn't bother. may as well just keep the R33

They are twin turbo yer, same engine as soarers, which have modification potential.

http://www.alljapanesecars.com/viewcr.php3...r=1994&mc=JZX90

here are the specs, etc.

Eug: You might be talking about 1998 or later models. They are around the $1mil yen mark, which i guess would work out to be $20-$30k i guess

it would be something different, no dont see too many around, and plenty of 1jze-gte engines itn he soarers for parts.

Its possible compliance isn't available for earlier models. If that is the case :(

but something i am thinking of.. i have been thinking 1989 GTR and RB30 bottom end, and full rebuild -- while could end up under $30k for a 11sec GTR.. i really need something cheaper.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Started sifting thru my brakes to decide which ones I will run on Clem   Made me think I should just put them all on Silver...for when brake fade just isn't an option   Should be able to bump rotor up from 343x32 to 348x36 off Supra. Not sure if the Supra annulus is right for the Alcons or APs but trying g to find a used Supra\M4 rotor to test fit The Alcons seem to gain 1-2mm clearance which all helps  
    • So car is getting a few mods to the cage and some jacking points welded in Meantime Ol Silver gets a new gearbox and shiny clutch.  Old Box is being set aside for Clem  
    • Probably speedometer itself if the odometer is ticking. If the needle is stuck from a bit of grease or something that can cause it to stay at 0. Or a cracked solder joint in the speedometer can do it too.
    • Thanks Fella’s   to take this off topic and to elaborate a bit more. I have an rb25/30 going into a r32 GTST.. expected to make around 600-700hp. Would you?   A) R34 GTT box   B) CD00#?  I’ve seen a few posts about the CD swap and sounds fairly involved with making it fit etc but if it’s worth the work then I’ll go that way
    • Lower at the hubs. Funny I forgot to mention that part. Do this pull here I turned the camera off too soon but the graph shows a drop at the top and that was because the pipe from the turbo blew off. The tuner said we could’ve made possibly another 15 whp. He also added if I switched to ethanol we could up the boost some more as well. I was comfortable capping it at the most of 20 pounds. Turns out the turbo pipe just needed a new worm clamp. Got home replaced that then did a third gear pull from 3k to 7200 rpm and the power was great to the top. I just got an ecu mounting bracket from IEE that I need to try and get everything to fit well. It’s a PITA to get the harness and ecu fit properly behind that kick plate 
×
×
  • Create New...