Jump to content
SAU Community

Recommended Posts

  • Replies 62.7k
  • Created
  • Last Reply

Top Posters In This Topic

  • chaos

    7164

  • Ska

    5791

  • BelGarion

    3645

  • Nexus9

    3590

Top Posters In This Topic

Shut up or I will burst through your gimproom door, beat you about the head, shoulders and asymmetrical ****face with your Anal Destroyer Dildo Deluxe, drag you down the stale urine, dog shit, bodily fluids, and KY-Jelly covered hall by your single front bucktooth, bounce you down the stairs like a bloated blubber beach ball, past the hat stand that you're trying desperately to cling onto, through the front door of your hermit hovel, down the street filled with bemused onlookers for further acts of unparalleled savagery.

you have been saving that text file full of insults for a long time haven't you stink boy? :uh-huh:

ctr+c & ctrl+v this ..l., :D

you have been saving that text file full of insults for a long time haven't you stink boy? :uh-huh:

ctr+c & ctrl+v this ..l., :D

You may be the only person to have won a Watermelon Eating Contest with your arse and, no doubt, impressed and regaled many a bus stop stranger with the great event of your life, but it doesn't impress me and I'm still going to lay you out like an airport runway and land a 747 of beating on you if you don't shut the **** up, you loose roof tile in Cyclone Me.

woah... i got PM from Chaos..

btw.. anyone with an R33... can u tell me 2moro or whenever, whether or not u have

a pulley wire thingamabob in the rear left bit of the trunk? connected to the exhaust??

its behind where the jack is held.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • If it (the code) wasn't still current, it should have gone away by itself by now. No, nothing it 10/10. But it is quite likely. Everything else to do with the ignition could still be responsible (which is wires and connectors). The car is an old piece of shit now, so all the wires and connectors are also old pieces of shit.
    • Lock me in mate, although I'm not sure if I'll be heading up from Goulburn or down from Sydney, either way, return will be back to Goulburn 
    • Sounds good, we will aim to be there! @The Bogan I'll give you a shout if you are heading up to campbelltown for the meet too.
    • Before I get to the test day, just to finish off the android head unit. This is a demo from car start up....the standard/host system takes a few seconds to boot (same as all v37) but Android comes up quickly. In this vid I'm using the delivered launcher but have set the default to Agami since which is easier to navigate when if use primarily 5 apps. You can see the host system still takes over when required eg putting it in reverse, and you can switch between Android and not by holding the back button 3 sec. It is pretty responsive (fast) but you can see I had to press harder than expected a couple of times.  I still have the phone connected to the stock system, and that also seamlessly takes over Android music playing. v37-android-demo.mp4 The bigger reason that I put this in though is so that I can use Ecutek directly on the head unit. That gives me a dash with logging (up to 20MB only), high and low value warnings on any parameter etc etc. I've run a USB cable from the Ecutek OBD dongle to a USB input on the unit, easy. v37-ecutek-demo.mp4   The unit did freeze on the launcher the other day, I think Agami was trying to verify the license when it didn't have a data connection...will monitor and report back if there are any other problems but so far I'm very happy with the upgrade.
    • Nah that is just crappy GPS mapping, I did have a small excursion (cold tyres, damp track, surprise!), will post up that when I get a chance.
×
×
  • Create New...