Jump to content
SAU Community

Recommended Posts

I am planning a trip and looking at fuel stops but have come accross a small problem. For 1 fill up, there isn't a servo that has V-Power or BP Ultimate, only Unleaded 95. I don't want to fill up with just 95 as the octane level is too low. Are there anyways around this or anyways to increase the octane level, without doing any engine damage??

Cheers,

Dan.

Link to comment
https://www.sau.com.au/forums/topic/346451-fuel-adivice-octane/
Share on other sites

you could run it on 91 if you want, you just got to run it off boost and with low throttle %'s and you won't be near the knock threshold.

If your worried just put some octane booster in 95 octane and you'll be laughing.

Edited by D_Stirls
  • Like 1

Take a can of Toluene with you ad that to your 91 or 95 should bring you back up to a higher rating. Much better octane booster than mos of the commercial ones on the market

Or just knock a couple of degrees ignition timing out of it

where is your trip most of my trips to Canberra Sydney have BP all the way over pretty sure they all have ultimate

Coming from Taree back home near Adelaide, via Dubbo, West Wyalong, Hay, Mildura then Renmark etc... It's the stretch between Wyalong and Mildura where there is no V-Power or Ultimate. Might not matter, as the roads might be cut off because of the flooding.

NULON octane booster take it up 8 points from memory so it will make 91 into 99. I think it's $25-$29 per bottle that will treat a full tank of fuel. If you only want to take 95 up to 98 you could spread the one bottle over 2 tanks of fuel.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Join SAU NSW for a flame-grilled feed & flame-spitting cruise! Sunday 17th August 2025 3:30PM Meeting Archies Flame Grille Sylvania Waters 4:45PM Cruise Departure 5:15PM Arrival at Cape Solander Kurnell Meet Location: Archies Flame Grille Final Destination: Cape Solander Kurnell *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
    • Yeah good luck out there! Will be good to see a mighty GTST going harder than the GTRs
    • i will be there 😁
    • Hello!  i just finished manual swaping my r34 skyline with a r33 rb20de box(RB71C)box  When the car is running it squeaks crazy loud and it was smoking from the gearbox area. The gearbox is fine it was tested. The clutch slave cylinder seems like it doesn't fully releases the clutch. I want to ask if this noise is from the throw out bearing or could it be the clutch assembly or disk att.xFliq87Gzw6kImKBVqDebXkj0fBqymk0JaYeP3_3SlM.mp4
    • A few small updates since the previous post and lessons. I decided to do a little interior light upgrade on the 110. I quite like the iilumo items, even if they're a bit of a premium over other brands. You'll also note the Stedi Fogs, that will go into the S15 fog lights as I needed to match the bulbs since I got the new ones earlier. I hope they fit as the body is quite a bit longer than your normal bulb.  Annoyingly, I managed to trip the fuse, which normally wouldn't be an issue until I located the fuse. I can't say I've ever come across this. I had lucked out that someone nearby had a spare, but oddly enough Toyota dealerships seem to keep this in stock. I ordered some to keep in my stash and as luck would have it, someone else nearby tripped the same fuse so I passed on the favour.  I also did a little service on the 110 ahead of some additional work coming up. It's been annoying that Goleby's stopped carrying this particular HKS filter for the 110, so now I need to keep them on order from Japan. I also took the opportunity to install a bash plate and number plate riser. The plate riser is such a cheap but nice fix to help really tidy up the car. I'm tempted to now also replace my headlights, on this car. Both items were from Project Aero.    I also needed to replace the rear tyres on the 110, and after trying to get it aligned learnt that I need to replace some bushes in the front end, so that's next.  Closing out this update with a nicer picture as always! 
×
×
  • Create New...