Jump to content
SAU Community

Recommended Posts

Hi guys.I currently have a turbosmart boost T ,one of the latest type with the ball and spring and was just wondering if a turbotech would be any better? I will be getting a retune soon with bigger injectors and z32 afm to go with my current turbo which is a apexi ax53b70p25.The common trend with these internal wastegate turbos is that they tend to drop a few pounds of boost towards redline. Cheers

Link to comment
https://www.sau.com.au/forums/topic/348562-turbotech-vs-turbosmart/
Share on other sites

there is a thread on here some where thats like 70 hundred pages long about the turbotech boost controller being the best so i brought one in short it was shit. i now have a turbosmart T and think it is heaps better.

I had a better boost curve running the Turbosmart than the blitz ebc I upgraded to, although the ebc does ramp on the boost a little quicker.

Either of these cheap manual regulator style controllers should do the job perfectly. If your boost curve still drops off it wont be the controller, more likely you would need a stronger wastegate actuator.

+1 to turbotech!

Had a GFB bleed installed set to 12psi,

then switched to a turbotech (just to test) and the car hit 12psi so much quicker then the GFB, ditched the GFB immediately.

turbotech will be my only manual bleed valve choice, other then that, EBC it is :)

Thanks for the replies guys. I think i will look into getting a stronger actuator to suit my turbo.Does anybody know if a hks or garrett actuator will fit my apexi turbo?The actuator on it is apparently a 12psi.Cheers.

Buy an EBC. The cheapness of skyline owners never ceases to amaze me. It is scrooge season though I suppose.

So do you believe an EBC will stop my boost dropping at high Rpm,cause if so that is all i'm looking for?

A decent electronic boost controller is always going to be better then a bleed valve if set up right.

Just Jap have the Blitz Dual SBC Spec R boost conrollers going for $599. Its not cheap but you will get great results....

here is my boost graph its holding 22psi with a 15psi actuator.

post-32514-0-25374400-1293926323_thumb.jpg

A decent electronic boost controller is always going to be better then a bleed valve if set up right.

Just Jap have the Blitz Dual SBC Spec R boost conrollers going for $599. Its not cheap but you will get great results....

here is my boost graph its holding 22psi with a 15psi actuator.

post-32514-0-25374400-1293926323_thumb.jpg

The actuator is doing most of the work in your setup, try that with a 7psi spring. I have the same Blitz unit, it wont hold boost any better than the Turbosmart as my actuator is blowing open.

The Turbosmart and Turbotech ones are not bleed valves, they are regulators that are run in line, just like an ebc. They are great if hooked up correctly, not just for tight arses.

and a turbotech is not a bleed valve. it's a ball and spring type that blocks the pressure to the actuator until desired boost is reached, at which point the pressure is passed through.

very simple. very effective. very cheap.

but it only holds one boost level throughout the rpm range, and isnt configurable in any other parameters, obviously.

so depending what you need. ebc may be better, or may be a waste of money.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Back again. I returned to Japan in Jul/Aug to spend time with the car on my birthday and remind myself what all the sacrifice and compromise is for. It happened to line up with the monthly morning meet in Okutama, which I have been wanting to go to for a long time. It's a unique event at a unique spot with really rare, interesting, and quirky cars. It's where all the oldheads and OGs gather. The nighttime scene at DKF certainly has its place and should be experienced if you're into cars, but there's too much bad attention and negativity around it now. IMO the better time is Sunday morning at DKF or Okutama; it's more chill and relaxed. I'm glad I was finally able to go, but not sure it's worth the drive from all the way from Nagoya immediately the day before, unless I was already staying in Tokyo for the days right before the meet, because you have to wake up quite early to make it in time. Funnily enough though I didn't drive the car all that much this trip because it was just too damn hot. While there were zero issues and running temps were nominal and the A/C was strong, RBs already run crazy hot as it is. Sure, it took it all like a champ but something about driving these cars in the ridiculous heat/humidity bothers me and makes me feel like I'm asking too much of it. I'm just me being weird and treating the car like a living thing with feelings; I'm mechanically sympathetic to a fault. Instead I was mainly driving something else around - a KX4(silver) 2001 X-Trail GT, that I acquired in May. There's a few different flavors to choose from with Xs, but visually it's the Nissan version of the Honda CR-V. Mechanically it's a whole different story as this, being the top-trim GT, has an SR20VET mated to a four-speed auto and full-time AWD! It was a very affordable buy in exceptional condition inside and out, with very low mileage...only 48k kms. Most likely it was owned by an older person who kept it garaged and well-maintained, so I'm really happy with how it all worked out. It literally needs zero attention at the moment, albeit except for some minor visual touch-ups. I wanted something quirky, interesting, and practical and for sure it handily delivers on all three of those aspects. I was immediately able to utilize the cargo and passenger capacity to its full extent. It's a lot of fun to drive and is quite punchy through 1st and 2nd. It's very unassuming -in the twisty bits it's a lot more composed than one would think at a glance- and it'll be even better once I get better tires on it(yes, it's an SUV but still a little boat-y for my liking). So...now I have two golden-era Nissans in silver. One sports car and one that does everything else; the perfect two-car solution I think👍 The rest of the trip...I was able to turn my stressed brain off and enjoy it, although I didn't quite get to do as much as I thought. I did some interesting things, met some interesting people, and happened into some interesting situations however, that's all for another post though only if people really want to know. Project-wise, I went back to Mine's again to discuss more plans and am hoping to wrap that up real soon; keep watching this space if that interests you. Additionally, while working in the tormenting sweatbox that is the warehouse, I was able to organize most of the myriad of parts that my friend is storing for me along with the cars, and the 34 has a nice little spot carved out for it: And since it can get so stupid hot in there, that made it all the more easy -after I was standing there looking at the car and said 'f**k it'- to finally remove all the damn gauges that have mostly been an eyesore all this time. Huzzah. The heat basically makes the adhesive backing on the gauge mounts more pliable to work with, so it was far less stressful getting this done. I didn't fully clean it up or chase the wiring though; that will happen once I have the car in closer possession. Another major reason to remove all that stuff is to give people less reasons to get in my car and steal s**t while it's being exported/imported when/if the time comes, which leads us to my next point... ...and that is even though it's time in Japan is technically almost up since it's a November car and the X would be coming in March, I'm still not entirely sure where my life and career is headed; I don't really know what the future looks like and where I'm going to end up. I feel there's a great deal of uncertainty with me and as a result of that, it feels like I'm at a crossroads moreso now than any point in my life thus far and there are some choices I need to make. Yes, I've had some years to consider things and prepare myself, however too much has happened in that time to maintain confidence and everything feels so up in the air; tenuous one might say. Simply put, there's just too much nonsense going on right now from multiple vectors. Admittedly, I'm struggling to stay in the game and keep my eyes on the prize. So much so in fact, that very recently I came the closest I ever have before to calling it quits outright; selling everything and moving on and not looking back. The astute among you will pick up on key subtext within this paragraph. In the meantime I've still managed to slowly acquire some final bits for the car, but it feels nice knowing there's not much left to get and I'm almost across that finish line; I have almost everything I'll ever want for my interpretation and expression on what it is I think an R34 should be. 'til later.
    • Thanks for that, hadn’t used my brain enough to think about that. 
    • Also playing with fire if they start to flow more air down low than what the stock twins can. It's not even up top you need to worry, it can be at 3000rpm and part throttle and it's getting way more flow than it should.
    • Any G40/1000 or G40/1250 results out there?  
    • You still want a proper tune on the stock ECU though. Stock tune + stock ECU with GT-SS/-9s is probably playing with fire if you're running more than stock airflow/power.
×
×
  • Create New...