Jump to content
SAU Community

Recommended Posts

  • Replies 122
  • Created
  • Last Reply

Top Posters In This Topic

Hi ....

Recomendations fitting / installation etc ....

I must stress that I'm advised correct installation is very important.

It is advised to put at least one if not more layers of a decent sealer, i.e. a coat of your best nail varnish would be good ~ wink.gif .... Ok the wifes then.

Completely cover the edges of the glass and don't just depend on the windscreen sealer doing it's job used by the installer ( As there can be times when no visable leaks will be seen inside the cabin, as the water may just be sitting in there hidden from veiw and gradually seeping between the two layers of glass ) Premature failure with water seeping / getting between the two layers of glass is common if not sealed correctly, causing a failure of the elements.

This type of failure is NOT covered by any warrantee issued with the screens ( six months on the element from date of supply )

An inline fuse of 20 amp must also be used in conjunction with say a LED indicator/switch visable by the driver.

Any questions please call me on 0422 425 026

Alt [email protected]

Again Thanks to all for your patience and trust.

Cheers .... Del

Again ....

One other thing which may interest.

I shall have available " Tear Offs " simular to the V8 Taxis etc.

There will be very little loss of vision / clarity, but will prolong the life of the screen, and stop the sand blasting effect experienced with long term use or long distance races.

Obviously this will not stop rocks, but will assist in the overall longevity of the screens life ....

Cheers .... Del

Ahhhhh! That's good! I'll be needing those too.

I'm extremely unlucky with the amount of screen damage I get. Porsche drivers seem unable to hear lowly R32 horns or see the high beams?

Edited by Marlin

Hi Again ....

I have an account with DHL and was quoted to send it to Dunedin by the cheapest most economical service available ( 4 - 5 days, door to door ) they have quoted $264 AU freight inc insurance.

Screen cost with no GST charge, as it's leaving the country .... $535

To send sea freight would be cheaper buy incure the wrath of all sorts of other mandated charges when going consolodated cargo.

If there is any way you know or any one who ships to NZ from here who may somehow help out I can deliver to any freight forwarding agent in Sydney for $0 if it helps ?

Cheers mate, will have to check how much the customs goons would sting me with once it gets here. Not sure if I'm keen yet but if I end up needing/wanting one I'll PM you.

Hi ....

any more for r32's?

mine just decided to explode after tipping over

farken!

I am shocked and confussed to hear ? Screens are somewhat fragile though .... How the hell did you do that ?

I have two left Peter ....

Cheers .... Del

Hey ....

now i have to give up drinking for 3 weeks to pay for a new one

hook me up del

You are making things easy to sell these Pete :thumbsup:

So that is $11.43 per day over three weeks !

Sorry to say but if you need a replacement ? you may have to give up drinking for 3 weeks 3.84 days. As replacment costs are $40 more expensive :down:

Either way let me know as I may have sold one of the last two today

Cheers ...

now i have to give up drinking for 3 weeks to pay for a new one

hook me up del

be honest. $500 is like 2 days drinking not 3 weeks. monkey. and yeah I wondered who was yelling C$%NT!! last night.

Hey ....

Duncans screen has now been fitted. No problems it fitted okay and sealed up alright

That's good to hear Brad. The S15 one I sold was a very neat fit also ( And so it should be ! )

Have a few running already .... Andrew Mc'phersons Lotus Exige is using one and already, used it at the Wakefeild 300.

Having a batch made made for his Mosler too.

For what it's worth the Lotus Exige drew 8.8 amps.

Got a few in the NA Motorsport Evo 9 & V Sport Evo 10's at Super Lap ( If any one wants to check them out ) looks like they won't need to use them after driving 2500 klm's to deliver to NA Motorsport :down: .... And Ben's too of course :thumbsup:

All others will be out next week inc Ben in Tassie.

Cheers .... Del

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • For these last 7 years of ownership, I've always had to use a small scissor jack under one of the front tow hooks to raise the front just enough so my low-profile jack fits under to reach my subframe jack point. I'm beginning to get annoyed of always having to do this. Are there any lower low-profile jacks that fit under the gtr lip on a dropped car?
    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
×
×
  • Create New...