Jump to content
SAU Community

Recommended Posts

I've been thinking about fuel for my rb30. I was going to go e85 but we can't get it at the pumps where I'm at. I was going to ship it by the barrel, fill up for races(time attack, drag, HPDE, etc), and use pump gas for the street.

BUT! If I'm going to be shipping fuel and making an alcohol safe fuel system, why not use methanol? According to my math, even at 75/25 meth-to-pump it should make more power than E85. It should also run cooler, be easier to find (lots of drag cars here,) and be cheaper.

Anybody gone done this road before?

Interesting fact- in china, where corn is expensive, flex fuel vehicles run M85!

Link to comment
https://www.sau.com.au/forums/topic/350574-methanol-vs-e85/
Share on other sites

Nobody has any experience? I keep looking around and all I'm finding is a lot of bs about methanol being dangerous and toxic. It's actually less dangerous and toxic than gasoline.

I think the only reason it isn't used is because Injectors large enough to use methanol and still idle and run normal only recently became available. (id2000)

Unless someone has a good reason not to do it I'm gonna give it a shot.

Link to comment
https://www.sau.com.au/forums/topic/350574-methanol-vs-e85/#findComment-5630372
Share on other sites

I can add that buying E85 at the pump will only give many inconsistent results.

Preferred race fuel is C16 or Aviation fuels as they prove to be more stable throughout the year.

As for Power, Methanol makes a bigger bang but more costly to obtain. You will require some form of license in most developed countries.

Link to comment
https://www.sau.com.au/forums/topic/350574-methanol-vs-e85/#findComment-5630563
Share on other sites

I've been thinking about fuel for my rb30. I was going to go e85 but we can't get it at the pumps where I'm at. I was going to ship it by the barrel, fill up for races(time attack, drag, HPDE, etc), and use pump gas for the street.

BUT! If I'm going to be shipping fuel and making an alcohol safe fuel system, why not use methanol? According to my math, even at 75/25 meth-to-pump it should make more power than E85. It should also run cooler, be easier to find (lots of drag cars here,) and be cheaper.

Anybody gone done this road before?

Interesting fact- in china, where corn is expensive, flex fuel vehicles run M85!

What is the engine built for? Compression, expected boost, is it intercooled, what is the injector location?

Edited by rob82
Link to comment
https://www.sau.com.au/forums/topic/350574-methanol-vs-e85/#findComment-5630810
Share on other sites

I can add that buying E85 at the pump will only give many inconsistent results.

Preferred race fuel is C16 or Aviation fuels as they prove to be more stable throughout the year.

As for Power, Methanol makes a bigger bang but more costly to obtain. You will require some form of license in most developed countries.

Pump e85 is fine provided you tune for the variations. We can match c16 but @ $1 a litre....

Link to comment
https://www.sau.com.au/forums/topic/350574-methanol-vs-e85/#findComment-5630944
Share on other sites

If you are talking about E85 vs meth, why not go WMI? You get pretty much the same power boost as you would when tuning for E85 and the methanol cooler running = the best of both worlds. And you won't use much unless you are boosting, don't need huge injectors, can run on pump fuel everywhere, don't need to upgrade any fuel lines or systems and there are some great packages out there for it. Plus you can vary the amount of meth by juggling with nozzle sizes and multiple nozzles. It is on tap just waiting for you to boost it!

As an example I used probably 100-150ml in 400km of highway driving and I have a 3.5 litre reservoir. I know that when you race with it it is used heaps more, but you can top up between laps etc.

And mixed 50/50 WM in a container is pretty much inert.

Link to comment
https://www.sau.com.au/forums/topic/350574-methanol-vs-e85/#findComment-5631965
Share on other sites

One bad thing I've seen with methanol is it burns with almost invisible flames, though E85 could be the same.

All those burnout cars that run it seem to set their tyres and half the track alight though. I also saw an evo with big cams shooting 1m flames on the overrun after it supposedly had been tuned, whether this was the car or the fuel I do not know.

Anyone know more ?

Edited by Rolls
Link to comment
https://www.sau.com.au/forums/topic/350574-methanol-vs-e85/#findComment-5633915
Share on other sites

One bad thing I've seen with methanol is it burns with almost invisible flames, though E85 could be the same.

All those burnout cars that run it seem to set their tyres and half the track alight though. I also saw an evo with big cams shooting 1m flames on the overrun after it supposedly had been tuned, whether this was the car or the fuel I do not know.

Anyone know more ?

The 15% fuel in the methanol would cause the flame to be visible :)

Link to comment
https://www.sau.com.au/forums/topic/350574-methanol-vs-e85/#findComment-5633942
Share on other sites

BoostedR's build data from the -5 vs GTRS thread

I have built a RB31/26DETT 824hp -engine hp

264 9.8 HKS

Tomei Dumps

3" x 2 (no mufflers)

530ft lb @ 2800rpm

22psi max

Garrett -10's

Ported std manifolds

BP98 with 10% methanol

Motec

That result proves you can lean on the engine a lot more with just 10% methanol. A water/meth injection setup would produce a similar result.

Link to comment
https://www.sau.com.au/forums/topic/350574-methanol-vs-e85/#findComment-5633983
Share on other sites

I have an aquamist hfs-6 on the car right now. It works good but won't give the same performance as mixing meth. It's also something else to break at the track.

The 15% gasoline is supposed to add color to the flame also. I might try a 50/50 mix and move up from there.

Link to comment
https://www.sau.com.au/forums/topic/350574-methanol-vs-e85/#findComment-5634225
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I would just put EBC back on the "I would not use their stuff" pile and move on.
    • Can I suggest you try EBC directly again and link them to as many competitor catalogues as you can to show their listing is incorrect, eg https://dba.com.au/product/front-4000-series-hd-brake-rotor-dba42304/ If you have access to an R33 GTST VIN and your VIN, you could also use a Nissan Parts lookup like Amayama to show them the part number is different between 33 GTST and 34 GTT which may get their attention
    • So i got reply from EBC and they just this site where you can clearly see those 296mm fronts on R34 GTT. I send them photos and "quotes" that 296mm are not for 34 GTT and they are too small. But it will be very hard to return them cuz nobody here knows 100% and they just copy those EBC catalogue :-D https://ebcbrakesdirect.com/automotive/nissan/skyline-r34
    • Hi, is the HKS  Tower Bar still available ? negotiable ? 🤔
    • From there, it is really just test and assemble. Plug the adapter cables from the unit into the back of the screen, then the other side to the car harness. Don't forget all the other plugs too! Run the cables behind the unit and screw it back into place (4 screws) and you should now have 3 cables to run from the top screen to the android unit. I ran them along the DS of the other AV units in the gap between their backets and the console, and used some corrugated tubing on the sharp edges of the bracket so the wires were safe. Plug the centre console and lower screen in temporarily and turn the car to ACC, the AV should fire up as normal. Hold the back button for 3 sec and Android should appear on the top screen. You need to set the input to Aux for audio (more on that later). I put the unit under the AC duct in the centre console, with the wifi antenna on top of the AC duct near the shifter, the bluetooth antenna on the AC duct under the centre console The GPS unit on top of the DS to AC duct; they all seem to work OK there are are out of the way. Neat cable routing is a pain. For the drive recorder I mounted it near the rear view mirror and run the cable in the headlining, across the a pillar and then down the inside of the a pillar seal to the DS lower dash. From there it goes across and to one USB input for the unit. The second USB input is attached to the ECUtec OBD dongle and the 3rd goes to the USB bulkhead connected I added in the centre console. This is how the centre console looks "tidied" up Note I didn't install the provided speaker, didn't use the 2.5mm IPod in line or the piggyback loom for the Ipod or change any DIP switches; they seem to only be required if you need to use the Ipod input rather than the AUX input. That's it, install done, I'll follow up with a separate post on how the unit works, but in summary it retains all factory functions and inputs (so I still use my phone to the car for calls), reverse still works like factory etc.
×
×
  • Create New...