Jump to content
SAU Community

Recommended Posts

HI all

Sadly my GTR has been smashed up several months ago and I have decided to part it out to compensate for my loss. The car has already been stripped ad most parts are ready to go.

Parts are located in Adelaide Hills

Please contact me by my mobile 0417975331 vie call or text rather than personal messaging here, as I will not always have a pc at hand and you may not get a response or a while (hence sms/ phone call)

LHS of car has been crushed in the center. Contact me for parts you are after. ( basically everything is available minus crushed parts) I will list parts and photos later

NO LOWBALL OFFERS OR TYREKICKERS PLEASE

Engine (136xxx kms)

N1 turbos

runs fine (running 14 psi previous to accident tuned by JAZMAC Performance Garage)

Power FC with hand controller

Gearbox (runs fine no slipping crunchng etc)

Engine wiring loom

($5500 for power fc plus engine and loom and gearbox) Will seperate if interest

Link to comment
https://www.sau.com.au/forums/topic/353017-wrecking-entire-89-32-gtr/
Share on other sites

do you have your climate control unit and associated bits,

Boot lining and trim ?

the metal sheet that closes up the hole between the boot and the rear seats ?

the factory gauge cluster IE oil temp, voltage and boost ?

also what about side skirts ?

Edited by Nee-san
  • 2 weeks later...

yes i do, please conaqct me via mobile as i have no idea how to use this site. cheers

Have you the black centre consol surround - around the radio / air-con / instruments?

Les . . .

i have all things u have asked for but not the side skirts. please contatc via mobile.. cheers

do you have your climate control unit and associated bits,

Boot lining and trim ?

the metal sheet that closes up the hole between the boot and the rear seats ?

the factory gauge cluster IE oil temp, voltage and boost ?

also what about side skirts ?

Guest
This topic is now closed to further replies.


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...