Jump to content
SAU Community

Recommended Posts

About 4 years ago bought an Aussie R32 GTR with a damaged engine. Apparently the idler puller had let get (when it was idling, cooling down after a dyno run) and did major damage to the head when the timing went out.

I replaced the motor with a fresh R33 GTR motor (I still have the original motor plus a spare block, head and gearbox, other bits like dump pipes and bigger turbos). New clutch, new brakes.

I have only driven about 4,000km since the new engine.

Overall mechanically good.Interior very tidy. Minor cosmetic body problems and a few spots of rust near windscreen that haven't changed in 4 years. Pretty much original condition except for bigger intercooler and exhaust.Drives well. 246,000 kms.

I no longer have much opportunity to drive it and it is a car that would do better being used than stored.

I was hoping it may be an appreciating asset but I am not sure if I should sell it or store it for 10 yrs.

I am not sure what it would be worth as there are a couple of these, possibly better condition, chasing $78k and $60k.

Any thoughts?

Frank

Link to comment
https://www.sau.com.au/forums/topic/354711-aussie-delivered-r32-gtr/
Share on other sites

Its sure to appreciate but how long it takes is the question. I reckon you might be waiting 20yrs before its valuable..But that give you a lot of time to gather up parts for a ground up rebuild to original condition..Just think what a fully restored muscle cars goes for these days, they're not cheap. GTRs may be plentiful now but 1 by 1 they are getting over modded and smashed,crashed bent twisted and stuffed. I guess it depends what its costing you to store it..If its not costing and you dont need the cash let it sit..It is a solid investment and you wont regret it..

Edited by Arthur T3

Not to be a knob, but surely for it to be worth something, it has to be totally original? Including engine...

And its got 246k kms (Yes, I know imports are wound back etc)

It does look really good though.

Edited by Ten Four

Hey Ten Four what wing are you running in that pic

?

It looks like a standard wing.

Here are some pics of mine that I took last Sunday......... The garage was owned by the original owner when the car was new.

Bob.

post-78207-0-70632100-1298314324_thumb.jpg

post-78207-0-13251200-1298314329_thumb.jpg

post-78207-0-82957000-1298314333_thumb.jpg

post-78207-0-09173700-1298314338_thumb.jpg

post-78207-0-54802100-1298314342_thumb.jpg

post-78207-0-21924900-1298314347_thumb.jpg

  • Like 1

Frank, do you have books for the car? If you were to sell it i would rebuild the standard motor and get it back as close to standard as possible.

The vehicles you have seen going for big dollars are mint units like Bobs maroon one above (with 50kms on it).

These cars will shoot up in value in another 10 years, where they go from there is anyones guess. If the cash is not a problem Id just remove the fluids, stick it up on stands and leave it be.

Keep and use the original block whatever you do.

Even if you mod it just make sure it looks standard. Inside no one could tell if its an HKS 2.8 stroker or a standard 2.6:)

I'm all for modding but keeping standard appearance (aside from suspension, exhaust and wheels). Except for Bobs, which still looks like he took delivery from Nissan this morning so probably best let his car become the museum piece in the future!

Edited by gtr fan

It looks like a standard wing.

Here are some pics of mine that I took last Sunday......... The garage was owned by the original owner when the car was new.

Bob.

I recognise that workshop. Although since moving to sydney in 1985 I don't recall ever seeing a car in that brilliant showcase on the front! Is that workshop still operational?

Not to be a knob, but surely for it to be worth something, it has to be totally original? Including engine...

And its got 246k kms (Yes, I know imports are wound back etc)

It does look really good though.

Wanted to get it up and running at the time.

Have original block etc.

Probably enough bits for two engines but not the enthusiasm.

Frank

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • You just need to remove the compressor housing, not the entire turbo. I would not be drilling and tapping anything with the housing still on anyways. 
    • So, I put my boat on a boat. First of all, I'm going to come out and say it. Why is Tasmania not considered a holy goal, an apex that all road-legal modified cars go to, to experience? This place is an absolute wonderland of titanic proportions. If people are already getting club runs for once in a lifetime 30 person cruises to Tassy then I've never seemed to see it. It is like someone replaced the entire place with an idyllic wonderland for cars, and all of the people living there with paid actors who are kind, humble, and friendly. Dear god. After doing a lap of almost all of the place I've found that it's a great way to find out all of the little things that the car isn't doing quite right and a great way to figure it all out. All in all, I drove for 4 hours a day for a week and nothing broke. I didn't even need to open the engine bay. This is by all means a great success, but it has left me with a list of things to potentially address. I also now have a 3D printed wheel fitment tool which annoyingly hasn't got any threads in it to actually assemble it. I might be able to tape it together to check the sizing I actually want to use, but it'll likely involving pulling the shocks out to properly measure travel at least at the front, and probably raise the car while I'm at it, at least in the rear. I scraped on quite a few things and I'm not sure how else to go about it. I was taking anything with a bump at what felt like 89 degree angles. And address those 10 other tasks. And wash the car. God damn it is dirty. And somehow, the weather was perfect the entire time - And because I was on the top of Mt Wellington it turns out it was very much about to freeze up there. I did something I typically never do and took some photos up there in what must have been -10 and the foggy felt like suspended ice, rather than mere fog. If you own a car in Australia, you owe it to yourself to do it.
    • Damn that was hilarious, and a bit embarrassing for skylines in general 😂 vintage car life ey. That R33 really stomped. Pretty entertaining stuff
    • Hi, I have a r32 gtr transmission. Does any of you guys have an idea how much power it will hold with the billet center plate and stock gearset? At what power level and use did yours brake with or without billet plate? Thanks, Oystein Lovik
    • Saw this replica police car based on a Mitsubishi Starion XX parked next to a 'police box' (it's literally a box) in Hirohata, Himeji City in Hyogo prefecture the other day. It's owned by Morii-san who is a local Mitsubishi Starion enthusiast. According to a local radio station blog post, he always wanted to make a police car himself based on ones he saw in his favourite Manga comics.  As it's illegal to modify a car to look like a police car and drive on the road, Morii-san tried many times to get permission from Aboshi police station headquarters nearby. They refused initially by after they got tired of that they granted him permission. However, the car can only be displayed on private property and obviously can't be registered as long as the police livery is present. The car was completed at a cost of 1.5 million yen (US$ 10,000) in addition to the car cost. A location was chosen outside Hirohata Police box where the car can easily been seen from the street. Morii-san has two other Starion road cars, both widebody GSR-VRs.
×
×
  • Create New...