Jump to content
SAU Community

Recommended Posts

We have owned this car for about 18 months now maybe a bit more. Its been the finace's daily driven car up untill 2 months ago when I bought her a GTiR pulsar, she wanted a smaller car.

Im upfront about the car so any questions ill answer

Its a 1994 M spec with ABS, Hicas, adjustable front spoiler etc

body

The car is gunmetal Grey, has a few minot dents and a little damage to the drivers front guard. Paint on the front bumper needs work, no fading or major damage

There is some minor accident damage to the drivers front headlight support and battery tray. The rails are striaght and damage is superficial only. It has all been repaired as the photos show

The sunroof seal is missing and requires replacement.

Inside is good condition and has R32 GTR seats. Aftermarket steering wheel (not the pink one pictured)

Nothing is missing or broken

engine & driveline

The car has its original RB20DET engine and is automatic

Im willing to convert to manual for the cost of parts alone if a potential buyer wants it manual.

Engine has had

timing belt & idlers etc, waterpump, all drive belts

Major service done 200Km's ago, plugs filters etc etc

New PWR auto trans cooler (fitted yesterday)

Vehicle has had

New rack, steering arms and outter tie rods

New rack bushes, upper control arm bushes

front adjustable castor arms

New tires 1500km's ago

New rear steering arms

New rear camber arms adjustable

All work done within 2500Km's

Has 17 inch wheels as pictured.

aftermarket exhaust system, cat back only

Otherwise its stock and orginal. It was driven daily approx 110Km's per day and is very reliable

Currently has 4 months rego remaining

Its priced to go and I dont have the room to keep storing the car, it hasnt been driven for months now.

Dont bother offering me 2K for it ill tell you to f**k off and I wont be polite about it.

asking $4500 as it is. or $4500 plus manual conversion parts

If your stadning here with cash I MAY negotiate with you, if not dont bother making me offers via the internet, i dont have time

Can contact via pm and il give a contact number

Brad

post-20349-0-23147900-1304844846_thumb.jpg

post-20349-0-94983100-1304844928_thumb.jpg

post-20349-0-46757400-1304845064_thumb.jpg

Link to comment
https://www.sau.com.au/forums/topic/363525-r32-gts-t-skyline/
Share on other sites

certainly got a decent buy.

I forgot how much hassle it is to sell a car.

Leif will use it well and im sure local guys will see it out and about.

Lisa is a little disapointed its going but she's got another car and is happy with it so far.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • neither stumble or cut really seem to be an appropriate term....hard to explain its like a rev limiter but at 4k, but it violently shakes engine and entire vehicle as the rpms will not rise over 4k, even with slow acceleration. as soon as it hits 4k, it sounds like entire spark is lost entirely. plugs were 1.1 which I used as such, but later put in new plugs gapped down to .8 changed back after issue arose when I replaced the coils, still does it with either plug gap...damn and it was all running so good.
    • Oh how times have changed! I actually lean it out relative to my water/methanol injector duty cycle. The methanol adds a lot of fueling and you can then lean it out even more due to reduced knock. 
    • Yeah my thoughts are the same, a well thought out WMI setup, would be slightly ahead of just straight E85 and you're also chemically intercooling the charged air, dropping it even further. This is why you need to add so much more fuel as soon as you spray. I remember someone taking me through their set up before (Dennis, has a R33, lives around Cabramatta - no idea if he's still around on this forum). He would target AFR 10:1 on 98, then as WMI ramped on, AFR would lean back up to 11:1. Amazingly, he did this all through his PowerFC, a relay to cut power to his EBC solenoid if there was not enough line pressure on his WMI kit. And of course, if there wasn't any boost made above gate pressure, you wouldn't be accessing the load cells with heaps of timing for WMI. One downside to that rudimentary setup, once the WMI came on, the EBC would unleash the dragon, and of course all the timing. Tyres would fry lol.
    • Shimmed or shimless, still solid, no hydraulic pump up stuff.
    • They have said food will be limited. Mainly meat pies and sausage rolls from memory. But they have a coffee van!
×
×
  • Create New...