Jump to content
SAU Community

Recommended Posts

well the skyline in mention got towed the last 300kms (by a xr6t hahah) of the way there cause the afm died and was lucky enough to get a z32 one in melb on the sat b4 racing on sunday btw the xr6t that towed it did a 12.2 with next to no mods injectors,tune,zorst everything else stock :worship:

  • Replies 3.6k
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

so its time for me to buy some tyres!

I have 17x9 rears and currently on them are some kumho ku36's which are 255/40/r17

Never bought tyres before, but I was considering getting the same. Any recommendations for where I could get some for a good price?

Or maybe should I buy a different size? I have 235/45/r17's on the front atm

any advice would be much appreciated!

Here you go Matty :D

http://www.ebay.com.au/itm/Mitsubishi-Fuso-Tilt-Slide-Tray-Tow-Truck-/260839817388?pt=AU_Trucks_Commercial_Vehicles&hash=item3cbb43c0ac

http://www.ebay.com.au/itm/Tilt-Tray-Tow-truck-/280727324546?pt=AU_Trucks_Commercial_Vehicles&hash=item415ca70782

http://www.ebay.com.au/itm/UD-TILT-TRAY-TOW-TRUCK-/270804698798?pt=AU_Trucks_Commercial_Vehicles&hash=item3f0d37c6ae

so its time for me to buy some tyres!

I have 17x9 rears and currently on them are some kumho ku36's which are 255/40/r17

Never bought tyres before, but I was considering getting the same. Any recommendations for where I could get some for a good price?

Or maybe should I buy a different size? I have 235/45/r17's on the front atm

any advice would be much appreciated!

I run 235/45/R17's on my fronts and rears 17x8 up front and 17x9 on the rears. Not had a problem with it so far. Blackwood Tyre Power are a SAU:SA club sponsor so go and have a chat with them to see what deals they can get you.You will also find that the 235's are slightly cheaper then the 255's :D

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Wife wanted basket things in the wardrobe in our temporary house. Thought about ripping our the wardrobe and fitting the entire IKEA set, but it's a temporary house and we want to move in a few years. So IKEA advertises this as a 50cm unit, however the actually basket and rails measure 46cm wide. Only issue was depth, IKEA stuff is quite deep, where as the builder special junk is super shallow at less than 40cm. Send it, chopped the rails, then offset the mounting holes, job done, happy wife, less shit scattered all over the bedroom. Did the same to the other side too. Also drove the Skyline shit box today, dropped off oil at Supercheap Auto. I didn't realise they only now take max 2x bottles per visit. I visited 2x Supercheap Autos.  
    • I've seen similar actually in my situation. You never know what tables are attempted to be used when the car thinks it's -99C or +200C. The fail state is not usually that extreme but you know what I mean - it was in my case though! This is where being able to read all the sensors is useful cause you see this stuff really quickly.
    • The above is very important. However as long as you keep timing relatively low, it's plausible to make your own knock ears and plausible to learn to tune with a modern ECU that can do wideband O2 correction like a boost controller. I mean if you only have one viable road to even drive the car on, learning to tinker to this level may be worth doing given you can't do much else with the car...?
    • I find the fact that the rear plate has to be bent inwards at the rear not so bad: but the front is just awful: It's like come on. (these are my very old, now retired/turned in plates) TBH it is a lot of money to fix a minor issue, the fact I said "I'll never really spend the money on doing this" is why people ended up buying them as a gift for a 'car guy' who can be hard to shop for.. for car guy things.
    • I just bent the ends of my premo plates. It even went through Regency like that after the engine conversion and the inspector (a great bloke!) just squinted his eyes and said "I didn't see that". Plates, and how they look, are just something that have zero importance to me.
×
×
  • Create New...