Jump to content
SAU Community

Recommended Posts

Hi Guy's,

Up for sale in my Black AR-X.

Mod's

Motor

Nismo ECU Piggybacked with an E-manage Ultimate - Tuned to run BP98 - Currently safe tuned to 15-16 PSI at 268AWKW's - Capable of more this is a very safe tune!

HDI EBC

HDI FMIC

Rebuild and high flowed turbo with a Garret BB set and GT30/71 core

Dump with a 3" custom exhaust

Suction Pipe

Custom intake

New motor with 55K on it. - Runs Neo 30w/5 racing oil

Custom Alloy radiator

Catch can

Nismo low temp thermostat.

Phenolic Runner spacer

600cc injectors

Walbro Fuel pump running 14v

Drivetrain

Nismo Springs

Bilstein Shock's

Whiteline front Sway bar

R33 GTR Callipers with DBA slotted rotors

19"x8.5 +36 Lenso Wheels

Currently running the standard 3.1 LSD gears (but I have 3.538 front and rear LSD diff on the way....these do not come with the car but will sell and install if wanted at what I paid for them)

A new exchange gearbox can will be sorted with a Stage 2 shift kit....to be installed.

PWR Large Trans cooler

Interior/Exterior

Standard AR-X Interior with twin sunroofs and Centre control panel

English translation is done

Digital TV is done

Autometer boost gauge

R33 GTR N1 duct's

Aftermarket Grill

Blacked out headlights

Eyelids

More about it

This car's driveline one the new Gears and Gearbox goes in will be under 60K....I can prove this!!! It is a well sorted car. The body needs a buff and there are 2 small fixable dents on the drivers side. The interior needs a new set of floor matt's and a detailer to go over the leather. Other than that the car is pretty good and for those that want a performance wagon but lack the funds to get it there it's a pretty good buy.

I am available to take you for a drive or show the car at anytime.

Asking 18,500 firm!

You can contact me on 0406 754 304.

cheers

Craig

Edited by Jetwreck
Link to comment
https://www.sau.com.au/forums/topic/365885-nm35-stagea-ar-x/
Share on other sites

Any interior shots? What suburb are you in?

I'm in Thornleigh.......My wife is up the coast in my car today rant.gif so I cannot do the shot's I wanted of the interior for you today........I can tell you that it's a standard AR-X interior with not rip's, burns crack or permanent stains....I had a quote to clean it up...was about $300 for the full leather detail and treatment.

  • 3 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yeh I think i'll message an old contact i had for ages that manages his own tyre shop now.. n tell him what i want n work with him before ordering..  Got this 17x9 +30 Driftteks on 245/45/17 PSR Drag Radials on the rear.. They fit well - for your reference in future - Rear guards  have been lipped in & minimal to non flaring of the rear Gaurds.    
    • If only it were that easy! I also needed to remove seats, shocks, brake calipers, send my car through a fence, and use measuring and ended up guessing because I didn't remove seats, shocks and brake calipers. It can be hard sometimes Can be a little more complex than 'just measure' if you want to truly measure the entire wheel through all of it's suspension travel. But if you aren't going for every last mm then yeah, you can check the space you currently have and guesstimate.
    • If you own a car, and it has wheels on it, and you know the offset of those wheels, and you have a measuring device, you have everything you need to work out if other wheels will fit.
    • Will this fit? but they are staggered set - RAYS 57DR SEMI GLOSS BLACK 18x8.5 +37 | 18x9.5 +38 5-114.3 STAGGERED SET   or If no go could just get a set 4's wheels of 18x8.5 +37 5-114.3 - would i run 8.5's 235s up front n 245's at the back if I do?   Thanks.        
    • Put a clamp on your return line. I have a feeling it's sucking air, and introducing bubbles to your fuel. With a lot of fuel, less problematic. I'd honestly be redoing all the lines in the tank and clamps on everything.   Also, you've given two different answers to the same question: Asked if being followed by the police you could get down to use the whole tank, you said yes you could, so long as you keep off boost. However, you then followed this up that free revving, it would also cause the issues. I'm doubting free revving is enough to make any noticeable boost on what is likely a decent sized turbo.   So now I have to ask, can you actually drive it lightly and use all the fuel, or does it break up even free revving? Also, have you put a fuel pressure gauge on it? Can you hear the pump change noise at all when you're having this issue?
×
×
  • Create New...