Jump to content
SAU Community

Recommended Posts

  • Replies 41
  • Created
  • Last Reply

Top Posters In This Topic

Swaybars changed my life, I'd get them straight up.

Spacers to give you extra lock cost <$50 so deff get those, makes the steering quicker too.

Coilovers are good too if your budget will allow. (BC Coilovers are good for around $1200)

Shim your stock diff up nice and tight.

500ml extra oil is handy.

Get an alignment too, ever so slight toe in on the back to help keep it predictable and slight toe out on the front to sharpen up the steering.

Tune Agent castor rods are cheap too ~$250, helps the car self steer. But I think adjustable castor rods are illegal for street use? correct me if I'm wrong.

Try and drift with brand new tyres, then you can spend more time out there and less time in the pits changing them thumbsup.gif

My car felt like two bricks connected by some playing cards before I got the cage put in it. While you wont actually damage your chassis by drifting (lol FF) some extra bracing might help tighten it up a little.

Before you do any mods though, just get out there and try it! See if you really like it first! Just give it a go ;)

Tyres... just buy tyres and get some track time.

Don't buy tune agent anything! I watched 2 pairs of castor arms break/fatigue topoint of failure with in 6 laps of a track!!!

Tyres, tyres, tyres...

Tyres... just buy tyres and get some track time.

Don't buy tune agent anything! I watched 2 pairs of castor arms break/fatigue topoint of failure with in 6 laps of a track!!!

Tyres, tyres, tyres...

My tune agent castor rods have done a lot more than 6 laps and I've had many unfriendly encounters with the curbs and they still look shmick as. I'll admit the older ones for the Silvias look like dried spaghetti though.

And yes, tyres, lots and lots of them. I've had good results with admirals. Cheap and they wear evenly right down to the carcass and don't delaminate at high temps. the Federal 595-ss are also good.

Get ready to buy HEAPS of tyres. :D Buy brand new ones though, 2nd hand ones you'll just spend the whole day in the pits swapping them over.

+1 to track time too, any track time is fine, even if it's not drifting, you just need to learn how your car behaves on the track\at the limit.

steering rack spacers are win and cost next to nothing

Spacers to give you extra lock cost <$50 so deff get those, makes the steering quicker too.

What are these,where do you get them, where do they go and how do they work..? :D

  • 2 weeks later...
  • 2 months later...

Where do you get those tierods that you posted simon?

You can get some Tien tierods from Cartel Aus - http://www.shop.cartel-aus.com/Tein-Tie-Rods-Tie-Rod-Ends-DWSS028.htm

I drift with just my stock 32, i just chucked in some tien coilovers and away i went, and it's handy to have good steer tyres. all the extra's just make drifting easier

  • 2 weeks later...

Diff... welded works a treat

choppies or coilovers if u can afford them... more drift less sailing on the high seas

Seat if your picky...

Fuel

Lots of tyres

A smile for the camera and the pretty ladies watching you

Seems people get so caught up on what is done to all the high end cars and forget to go out and give it a go.

I started in my first 32 years ago with a shimmed diff and a set of coilovers. best time of my life, spent plenty of money on fuel, entry fees and tyres then went and bought a seat and camber arms etc later on as I improved and found the need.

GO SKID

Edited by ti2l
  • 2 weeks later...

Alright,

I'm curious to see how a stock R32 reacts to sliding so I'll gradually add mods as needed.

This is how I think my priority list should look. I don't plan on buying everything at once or back-to-back so I'll see what the car tells me and upgrade as when I need to.

1) LSD - I'll probably get a 2-way diff as I'll use the GTS-T on the street and welds aren't daily driver friendly.

2) Sways- Adjustable only. I think Whiteline is the only company that makes adjustable sways for the Skyline.

3) Tie Rods - I'll be driving a '89 GTS-T so I'll probably buy whole replacement rods as opposed to just the spacers.

4) Harness (with stock seats) - Cassbo's suggestion. I'll try that first.

5)Clutch- A durable clutch

6) E-Brake- A durability to the E-brake (or upgrade)

7) Tires/Wheels- Brand New sticky tires up front and decent brand new tires for the rear. Extra wheels (maybe).

8) HICAS/ABS- Remove HICAS and/or ABS. I have my eyes on these: http://www.splparts.com/chassis-Z32.html#SPLHCKZ32

9) Suspension- Coilovers and supporting suspension parts.

10)Engine- PS cooler and more HP.

that's a mighty fine list you've got there son :)

Rack spacers should be on there too at #3.

Drift button too if you don't already have one.

Maybe a deep dish steering wheel too so you're not always slapping the wiper\indicators when you're throwing the wheel around. (that's if you have this problem)

  • 3 weeks later...

id be removing hicas sooner rather than later... will make life a lot easier

second hand tyres are fine for the rear... dont ned to be decent to get u started.. 595 or similar up front are cheap and work well

id also throw coilovers a bit higher up the list.... unless ur getting the angle grinder out ;)

u really wont need tie rods and rod ends till much later on, skidded for years in mine with stock tie rods etc.

stock handbrake is great... just get it adjusted

order should be:

Diff

Remove Hicas

Coilovers

skids

the rest can really happen whenever u progress and arent necessities to get you started..... stop thinking and go drive

yeah I've got the 595-evo on the front of mine, they're pretty good :) you want a slight stretch too to sharpen up the steering response. I upped my camber to -4 degrees too, changed my life.

Again, I have let the car tell me what needs to be changed..

This is a very wise attitude and I approve thumbsup.gif

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • I'm selling my personal race car. 1992 BNR32 Skyline GT-R About eight years ago the engine developed the dreaded low oil pressure problem. I removed it and found the issue. However shortly after I moved half way across the country, moved my work shop, bought a house, got married, then moved my shop again to it's permanent location for the time being. in turn I do not have the time to race this car as it should be. In turn the engine I built for this car will end up in my street car and this car I hope finds a home with someone who can use it to it's full potential. The roll bar was built by Jason Noren Fabricaiton in Pomona California to SCCA and NASA Specs. The car used to compete in redline time attack and global time attack enthusiast class. It also has a fire suppression system.  The car is with me at my workshop in Kyle Texas, USA. Shipping it is no problem, I can personally deliver the car to the port of either Houston or Los Angeles. Any other port depending on where it is may require transport but we can always work that out.   The chassis itself is rust free, rear quarters and under fenders are free of any rust so it's a very solid foundation for anyone who wishes to move forward with it. As posted and at the asking price of $20,000 USD the car includes all of the following;   All OEM Body panels, front fenders, rear bumpers etc.  OEM Nissan Projector headlamps (Pictured N1 lamps were removed) OEM Nismo Side Skirts / Extensions OEM Rear Spats  Front & Rear Subframes are installed car is full roller Rear Subframe has Cusco Camber Arms, Whiteline HICAS Elimination Front Subframe has Whiteline tension rods and whiteline Sway bars w/ endlinks.  Buddy Club N1 Coilovers All chassis wiring and engine wiring is in tact. Attessa System is fully in tact and was functional before engine removal.  BCNR33 GT-R Brembo Brakes F+R with Endless MX72 Plus Pads, DBA Rotors & Stainless Steel Brake lines Billion Racing Radiator Billion Radiator Hoses Fluidyne Engine Oil Cooler Accusump System (trunk Mounted) 5 Speed Transmission w/ Transfer Case F+R Prop-shafts Rear Differential With rear Axles.  Nismo Gauge Cluster Nismo Clutch + Flywheel   Essentially what is needed to make this car running and driving again is as follows: A working Engine, an ECU, and time to put it together. The price posted is or best offer as I am willing to remove some components to accommodate price to a certain extent. If any serious buyer wants full detailed pictures, videos, or any questions I'll be happy to answer them. I believe this car is priced to move quickly considering it's a rust free and very straight chassis but always open to fair negotiation.  I can be contacted via phone or email. (+19517081648) email is juan@bardabe.com   
    • So...to my (and my mechanics doing the swap) surprise...the oil pan from NEO engine does not fit 100% and needs to by modified like this: It is not a huge problem but in the future i want a "proper" oil pan. So question is...what different oil pan can i get to fit without any problems and modification? Thanks! 
    • Some more info I found.  These are the last entries Yoshikiyo Fujii made on his blog before he passed away in 2009: http://blog.livedoor.jp/fujii_dynamics/ And finally this is where the workshop was situated:  https://maps.app.goo.gl/HhTPtHzt3WVcBTiEA  
    • shit boxes, kids, and daily drivers are all welcome
    • Cam seals go hard. It's a very old car.
×
×
  • Create New...