Jump to content
SAU Community

Recommended Posts

My boot seems to have somehow jammed itself shut and no longer works via the seat side lever. I've never had a boot key either so I'm locked out. The lever seems to be working fine, hopefully I dont get a puncture or I'm screwed and stranded.

Anyone had problems with the boot lock mechanisim? Any special 'Fonzy' bashes to open it :D?

I guess the other way is to rip out the back seat? Does it just come out with a good yank or are there clamps holding it? The audio guys should be guru's at removing the back seat...

Link to comment
https://www.sau.com.au/forums/topic/37324-33-boot-is-jammed/
Share on other sites

my 33 boot is also blanked out so you cannot open it with a key... all I need is someone to muck with that little lock out lever and I would be in the same dilemma. I like the idea of having an electric soleniod in there like the commodores - and being able to operate it with a remote hanging off your keys.

Sumo

Link to comment
https://www.sau.com.au/forums/topic/37324-33-boot-is-jammed/#findComment-748057
Share on other sites

Two bolts securing the bottom section of seat (they're on the carpet, you'll see 'em), then two clips at the front edge of the bottom seat section secure to the body. (Lift up the front edge and you'll see two metal loops going down through the body. A BIG screwdriver as a lever is easiest to get them out as mine were hard as!)

Back section has two bolts at the bottom, then lifts up and forward to remove.

BUT: The only space through here on mine (S1 R33) would be through the removable plate leading to the battery bay. Approx. dimensions = 22" x 5"? (56cm x 14cm... I always mentally think in imperial for some reason:D)

The hole that has the switch in it is about 5cm x 2.5cm, so you should be able to flick it with a metre ruler or something similar fairly easily. Doubt you could reach through without a long stick of some sort though.

Good luck!

Link to comment
https://www.sau.com.au/forums/topic/37324-33-boot-is-jammed/#findComment-751279
Share on other sites

... and try to get hold of the 'owner's' key, not the valet one. Once you get the boot open you should be able to get a locksmith to make you up a new key. Actually, from memory, the valet key is also unable to lock/unlock the glovebox, so you might be able to get a key cut from that.

Link to comment
https://www.sau.com.au/forums/topic/37324-33-boot-is-jammed/#findComment-752276
Share on other sites

I guess the other way is to rip out the back seat? Does it just come out with a good yank or are there clamps holding it? The audio guys should be guru's at removing the back seat...

You still cant get through, theres a metal plate thing that goes the whole way across. Pulling the seats out is easy tho - two bolts on the vertical surface at your legs, then clips to pull the bum part of the seat off. The back rest has a bolt on eaither side and once these are out, it needs to be lifted upwards (its on rail type things) before if will come out.

Hope that helps.

Christian

Link to comment
https://www.sau.com.au/forums/topic/37324-33-boot-is-jammed/#findComment-752327
Share on other sites

I heard if you give your VIN number and key to a local Nissan dealer, they can make you the master key even for imports.... cost a bit more I suppose, but is an option if you've lost the master key and was only given the valet key when you got ur car imported.

Link to comment
https://www.sau.com.au/forums/topic/37324-33-boot-is-jammed/#findComment-764716
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I'd be curious to hear more. Otherwise, have you driven a modern x-trail? I wonder how it compares. Here in Australia they are/were popular for rentals and fleet vehicles. I have been in some and my impression was they are bad. But, this may have been very different in the 2000s at a good trim level. Twenty years is plenty of time to make the model worse. I do very much agree with the 2 silver cars in the garage approach. But, not driving because it's too hot would not leave a lot of time in the year for many Australians. I don't think you need to worry too much unless the car has actual issues with overheating. 
    • Back again. I returned to Japan in Jul/Aug to spend time with the car on my birthday and remind myself what all the sacrifice and compromise is for. It happened to line up with the monthly morning meet in Okutama, which I have been wanting to go to for a long time. It's a unique event at a unique spot with really rare, interesting, and quirky cars. It's where all the oldheads and OGs gather. The nighttime scene at DKF certainly has its place and should be experienced if you're into cars, but there's too much bad attention and negativity around it now. IMO the better time is Sunday morning at DKF or Okutama; it's more chill and relaxed. I'm glad I was finally able to go, but not sure it's worth the drive from all the way from Nagoya immediately the day before, unless I was already staying in Tokyo for the days right before the meet, because you have to wake up quite early to make it in time. Funnily enough though I didn't drive the car all that much this trip because it was just too damn hot. While there were zero issues and running temps were nominal and the A/C was strong, RBs already run crazy hot as it is. Sure, it took it all like a champ but something about driving these cars in the ridiculous heat/humidity bothers me and makes me feel like I'm asking too much of it. I'm just me being weird and treating the car like a living thing with feelings; I'm mechanically sympathetic to a fault. Instead I was mainly driving something else around - a KX4(silver) 2001 X-Trail GT, that I acquired in May. There's a few different flavors to choose from with Xs, but visually it's the Nissan version of the Honda CR-V. Mechanically it's a whole different story as this, being the top-trim GT, has an SR20VET mated to a four-speed auto and full-time AWD! It was a very affordable buy in exceptional condition inside and out, with very low mileage...only 48k kms. Most likely it was owned by an older person who kept it garaged and well-maintained, so I'm really happy with how it all worked out. It literally needs zero attention at the moment, albeit except for some minor visual touch-ups. I wanted something quirky, interesting, and practical and for sure it handily delivers on all three of those aspects. I was immediately able to utilize the cargo and passenger capacity to its full extent. It's a lot of fun to drive and is quite punchy through 1st and 2nd. It's very unassuming -in the twisty bits it's a lot more composed than one would think at a glance- and it'll be even better once I get better tires on it(yes, it's an SUV but still a little boat-y for my liking). So...now I have two golden-era Nissans in silver. One sports car and one that does everything else; the perfect two-car solution I think👍 The rest of the trip...I was able to turn my stressed brain off and enjoy it, although I didn't quite get to do as much as I thought. I did some interesting things, met some interesting people, and happened into some interesting situations however, that's all for another post though only if people really want to know. Project-wise, I went back to Mine's again to discuss more plans and am hoping to wrap that up real soon; keep watching this space if that interests you. Additionally, while working in the tormenting sweatbox that is the warehouse, I was able to organize most of the myriad of parts that my friend is storing for me along with the cars, and the 34 has a nice little spot carved out for it: And since it can get so stupid hot in there, that made it all the more easy -after I was standing there looking at the car and said 'f**k it'- to finally remove all the damn gauges that have mostly been an eyesore all this time. Huzzah. The heat basically makes the adhesive backing on the gauge mounts more pliable to work with, so it was far less stressful getting this done. I didn't fully clean it up or chase the wiring though; that will happen once I have the car in closer possession. Another major reason to remove all that stuff is to give people less reasons to get in my car and steal s**t while it's being exported/imported when/if the time comes, which leads us to my next point... ...and that is even though it's time in Japan is technically almost up since it's a November car and the X would be coming in March, I'm still not entirely sure where my life and career is headed; I don't really know what the future looks like and where I'm going to end up. I feel there's a great deal of uncertainty with me and as a result of that, it feels like I'm at a crossroads moreso now than any point in my life thus far and there are some choices I need to make. Yes, I've had some years to consider things and prepare myself, however too much has happened in that time to maintain confidence and everything feels so up in the air; tenuous one might say. Simply put, there's just too much nonsense going on right now from multiple vectors. Admittedly, I'm struggling to stay in the game and keep my eyes on the prize. So much so in fact, that very recently I came the closest I ever have before to calling it quits outright; selling everything and moving on and not looking back. The astute among you will pick up on key subtext within this paragraph. In the meantime I've still managed to slowly acquire some final bits for the car, but it feels nice knowing there's not much left to get and I'm almost across that finish line; I have almost everything I'll ever want for my interpretation and expression on what it is I think an R34 should be. 'til later.
    • Thanks for that, hadn’t used my brain enough to think about that. 
    • Also playing with fire if they start to flow more air down low than what the stock twins can. It's not even up top you need to worry, it can be at 3000rpm and part throttle and it's getting way more flow than it should.
    • Any G40/1000 or G40/1250 results out there?  
×
×
  • Create New...