Jump to content
SAU Community

Recommended Posts

The only difference between ET Streets and ET Drags is a couple of pissy little lines that are supposed to be the tread.

There's no way I'd actually run ET Streets ON the street! I do however run Nittos on the street, including the twisty stuff.

hmmm. Ive got the same but a blitz bov and 17'' 235/45/17. Im also running base map (dont know about timing). The subs are going to be removed from the car this weekend. :bs!: Hopefully then i can push a low 13 :wassup: or even a high 12 :wassup: .

3" turb back

FMIC

POD + CAP

APEXi PFC (Not tuned yet) running base map with Ign set to -5 across the board

12psi boost and Bridgestone RE540s 225/50/16's

i thought that as well but it also will reduce quicker acceleration due to the weight. So its 50/50 chance of success. :P

Don't forget that the subs are adding weight to the rear end which means better squat and better traction, removing them may cause you small traction problems.

I've got those pineapples and they did make a difference but nothing like a good set of tyres will. I leave my sub and spare tyre in the boot just for the extra squat but I still need more traction, the 225's don't help :P

Hehe I know where I can get a set of really big drags wheels/tyres, off of a 7 second drag car... I'm still trying to figure out how far I'd need to lip the guards to fit the 25" wide or so wheels... I reckon I could do a rev-limiter launch in first gear once they've been warmed up and it'd still bog down :bahaha:

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...