Jump to content
SAU Community

Recommended Posts

  • Replies 5.5k
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

perhaps they didn't consider people to be so lacking in ethics as to exploit them in that fashion

hence demonstrates the wide difference between obeying the law and the 'spirit' of the law (or rules, as the case may be)

if their gaming of the system last weekend gets Nando across the line for a drivers title this one, then the end, rightly or wrongly, will justify the means

and Ferrari will plaster Alonso's face up in every dealership and milk that marketing leverage like a muthabucker...

regardless of who wins, it was a great season

shame kimi and lewis didnt have a touch more luck to add the pressure on vettel and nando in the closing stages of the year

Has been good. Damned good.

I know every driver has things go wrong every season, but it really seems to me Lewis has had far more than his share of mechanical problems/take-downs this year.

By rights he should be right there with Sebvet and Gonzo as a WDC contender in the final race, if not with a bit of a lead even :(

C'est la vie

Well Coca-Cola have been trying to acquire Monster to boost their market share in energy drinks. There have been some talks between Mercedes and Coca-Cola the past 6 months and some that think that Coco-Cola be it with an acquired Monster or other brand may step up with some major branding/funding for Mercedes. Some have suggested it could be one of the reasons for Hamo jumping on board as it gives him a profile and brand to be associated with outside of motorsport

can't find. :(

http://torcache.net/torrent/93FDA2A64B889F447705E2A223E0CCDF51A1D512.torrent?title=[kat.ph]formula.1.2012.r19.united.states.grand.prix.race

Here's the torrent, I'm assuming you already have BitTorrent or similar.

If not: http://www.bittorrent.com/

It's two gig, but has the race, plus all the pre and post race bs.

Edited by Berk

What happened to Schuey?

Pretty much circulated going backwards all race with nary a whimper barring his chop on Button. The slippery track should have suited him. Is Mercedes the new Toyota?

They've sucked since Silverstone where the tyre variability dissapeared. The car is far too hard on its rear tyres, just like it has been for the previous 2 years. The fall apart tyres we had at the start of the season actually suited Mercedes because the tyres didn't last for anyone.

But a slippery dry track is very different to a wet track - track temp is still up, as is abrasion, so tyre wear is still there. Perhaps even more so than normal because turning the tyres out of the slow corners on the slippy track will hurt them more than normal. In qualy tyre wear doesn't come into it and Schuey once again hustled the car into a position it had no business being, just like he's done in the wet all season. But in the race, the tyres just got torn up. They were the only ones who had to stop twice. Conserving tyres has never been one of Schuey's strengths either, so it hurt him more than Rosberg.

Edited by hrd-hr30

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Power is fed to the ECU when the ignition switch is switched to IGN, at terminal 58. That same wire also connects to the ECCS relay to provide both the coil power and the contact side. When the ECU sees power at 58 it switches 16 to earth, which pulls the ECCS relay on, which feeds main power into the ECU and also to a bunch of other things. None of this is directly involved in the fuel pump - it just has to happen first. The ECU will pull terminal 18 to earth when it wants the fuel pump to run. This allows the fuel pump relay to pull in, which switches power on into the rest of the fuel pump control equipment. The fuel pump control regulator is controlled from terminal 104 on the ECU and is switched high or low depending on whether the ECU thinks the pump needs to run high or low. (I don't know which way around that is, and it really doesn't matter right now). The fuel pump control reg is really just a resistor that controls how the power through the pump goes to earth. Either straight to earth, or via the resistor. This part doesn't matter much to us today. The power to the fuel pump relay comes from one of the switched wires from the IGN switch and fusebox that is not shown off to the left of this page. That power runs the fuel pump relay coil and a number of other engine peripherals. Those peripherals don't really matter. All that matters is that there should be power available at the relay when the key is in the right position. At least - I think it's switched. If it's not switched, then power will be there all the time. Either way, if you don't have power there when you need it (ie, key on) then it won't work. The input-output switching side of the relay gains its power from a line similar (but not the same as) the one that feeds the ECU. SO I presume that is switched. Again, if there is not power there when you need it, then you have to look upstream. And... the upshot of all that? There is no "ground" at the fuel pump relay. Where you say: and say that pin 1 Black/Pink is ground, that is not true. The ECU trigger is AF73, is black/pink, and is the "ground". When the ECU says it is. The Blue/White wire is the "constant" 12V to power the relay's coil. And when I say "constant", I mean it may well only be on when the key is on. As I said above. So, when the ECU says not to be running the pump (which is any time after about 3s of switching on, with no crank signal or engine speed yet), then you should see 12V at both 1 and 2. Because the 12V will be all the way up to the ECU terminal 18, waiting to be switched to ground. When the ECU switches the fuel pump on, then AF73 should go to ~0V, having been switched to ground and the voltage drop now occurring over the relay coil. 3 & 5 are easy. 5 is the other "constant" 12V, that may or may not be constant but will very much want to be there when the key is on. Same as above. 3 goes to the pump. There should never be 12V visible at 3 unless the relay is pulled in. As to where the immobiliser might have been spliced into all this.... It will either have to be on wire AF70 or AF71, whichever is most accessible near the alarm. Given that all those wires run from the engine bay fusebox or the ECU, via the driver's area to the rear of the car, it could really be either. AF70 will be the same colour from the appropriate fuse all the way to the pump. If it has been cut and is dangling, you should be able to see that  in that area somewhere. Same with AF71.   You really should be able to force the pump to run. Just jump 12V onto AF72 and it should go. That will prove that the pump itself is willing to go along with you when you sort out the upstream. You really should be able to force the fuel pump relay on. Just short AF73 to earth when the key is on. If the pump runs, then the relay is fine, and all the power up to both inputs on the relay is fine. If it doesn't run (and given that you checked the relay itself actually works) then one or both of AF70 and AF71 are not bringing power to the game.
    • @PranK can you elaborate further on the Colorlock Dye? The website has a lot of options. I'm sure you've done all the research. I have old genuine leather seats that I have bought various refurbing creams and such, but never a dye. Any info on how long it lasts? Does it wash out? Is it a hassle? What product do I actually need? Am I just buying this kit and following the steps the page advises or something else? https://www.colourlockaustralia.com.au/colourlock-leather-repair-kit-dye.html
    • These going to fit over the big brakes? I'd be reeeeeeeeaaaall hesitant to believe so.
    • The leather work properly stunned me. Again, I am thankful that the leather was in such good condition. I'm not sure what the indent is at the top of the passenger seat. Like somebody was sitting in it with a golf ball between their shoulders. The wheels are more grey than silver now and missing a lot of gloss.  Here's one with nice silver wheels.
    • It's amazing how well the works on the leather seats. Looks mint. Looking forward to see how you go with the wheels. They do suit the car! Gutter rash is easy to fix, but I'm curious about getting the colour done.
×
×
  • Create New...