Jump to content
SAU Community

Terrible Start Up Idle Rocking

ClutchBurndout-:(
 Share

Recommended Posts

ClutchBurndout-:( Grand Master

ClutchBurndout-:(

Posted
Posted

Morning.

r33 gtst series 1

splitfire coils

stock injectors

7's gapped at 1 or .9

This morning when i turned my car on i had terrible idle, i currently have a very mild miss on warm idle and always have, but this morning, and only this morning (so far) it just decided to idle shit, the motor was rocking and you could feel it through the car, i wouldn't say it was a crippling rocking, but enough to shake the motor and car.

The rocking was a perfectly sequential fast paced rock, as apposed to an occasional light miss from the motor. it felt like it was missing every revolution and about 6-8 times a second on startup idle (1200-1500rpm) it almost felt as if you had washed the engine and a bit of water went into the valley, and you get that miss that it does.

I should note that the idle was starting to smooth out as the car was on, but turned it off before it was fully gone.

My guess is an injector is blocked? or a spark plug fault? but its weird that this didnt happen yesterday when i used the car. Could this be in relation to my usual very mild occasional miss that i get normally?

Ive tried to give as much info as possible, if i've missed anything let me know.

Cheers guise

Link to comment
https://www.sau.com.au/forums/topic/389746-terrible-start-up-idle-rocking/
Share on other sites
ClutchBurndout-:( Grand Master

ClutchBurndout-:(

Posted
  • Author
Posted (edited)

check your plugs first man... i'm guessing that they are gone.

did you drive it at all? and if so did the problem rectify itself after a while?

I just reversed the car across the road, and i think the idle was starting to smooth out after about 30 secs to a minute, but didnt want to leave it running, since i thought it might be leaning out on a cylinder or something.

I will check the plugs.

i went out just now and the idle was fine, but id still like to know what happened, as i assume this can happen again.

Edited by ClutchBurndout-:(
SargeRX8 Grand Master

SargeRX8

Posted
Posted

Those misses you say you get when warm are not misses, they are lean pops. They don't happen on idle due to the richness that the car runs to warm the engine up. If you drive your car when its in its cold state and switch it off soon after, the unburnt fuel can quickly foul old plugs. Ive had mornings where my car will start and misfire its face off. Change the plugs and bam its back to normal. My car was running rich all over the place so after I fixed that it didn't happen.

ClutchBurndout-:( Grand Master

ClutchBurndout-:(

Posted
  • Author
Posted

Those misses you say you get when warm are not misses, they are lean pops. They don't happen on idle due to the richness that the car runs to warm the engine up. If you drive your car when its in its cold state and switch it off soon after, the unburnt fuel can quickly foul old plugs. Ive had mornings where my car will start and misfire its face off. Change the plugs and bam its back to normal. My car was running rich all over the place so after I fixed that it didn't happen.

lean pops you say? not on idle? this ONLY happens on idle, how do i fix the lean pops on idle? checking for fouled plugs? what plugs will solve this?

i was very low on fuel yesterday, but filled up yesterday and drove another 30mins home on new fuel, that wouldnt affect it this morning?

so which plugs to use, some are saying BCPR7ES and some are saying BKR6ES?

  • 4 months later...
Black_CSR Rising Star

Black_CSR

Posted
Posted

7's are too cold for your application. Go down a heat range of 6. If the plugs can't get warm enough to it's operating temperature it can't burn off the excess carbon on the plug to clean itself and foul. Assuming your still running stock injectors your not putting out big power and 7's are too cold.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • The Bogan
      NC MX5

      By The Bogan · Posted

      So, version 4 intake is on its way I was looking at these a while ago but at around $200 or more it was a little pricey for something that might not work, but, I had it in my watch list, but, I got a message saying it was on special, and I had a code thingie to use, it eventually came in at $120 delivered, so BAM, BUY NOW.....LOL I'll need to have a look when it arrives but I feel it will "look" better than what I currently have, as it comes with a PCV fitting, so I will be able to get rid of the alloy pipe that goes to the throttle body with the PCV fitting  Well, that's what the voices in my head are telling me  Oh, and this happened today Yeap, it was a Trojan, and it was cheap, so I headed back to the hardware store and actually spent a little bit more on a heavy duty,  one that was actually recommended by a plumber mate, a Cyclone one with a fibreglass handle that is actually rated for clay The broken shovel will eventually be "modified" into a short handle shovel
    • MBS206
      What should I do next to hold the head on

      By MBS206 · Posted

      When you pulled it off, there is no signs of blown head gasket? Is it possible you have some other issues going on? Possible cracked blocked? Or do you think it's straight up lifting the head? Did you check what the head was torqued to before pulling it down (To see if possibly they're stretching, or starting to break threads out etc)?
    • jez NF
      The Evolution Of "night Fury"

      By jez NF · Posted

    • Rezz
      Chris' Toyota Mark ii JZX110

      By Rezz · Posted

      Seems like a decent result for a modded JZX110. They are bulky in comparison to the 100 and 90 models (which I'd prefer myself) but they are getting very few and far between here in JP these days. Thanks for the detailed review and the import process into the UK. I also have a car which I'm hoping to export from Japan at some stage so it's good to know if someone from the UK was interested in it. By the way the corrosion underneath is par for the course for cars which were located in/near the mountains or along the Japan sea coastline. They get huge amounts of snow every winter and the sodium chloride is used on the roads. Many cars have some kind of rubber like treatment underneath but they tend to limit it to the wheel arches underbody and fuel tank. Suspension arms and sub-frames will have similar corrosion to your JZX110 which is a common sight. See it all the time and car dealers here generally don't even mention it unless asked.
    • Kinkstaah
      new 1.5 LSD issues/concerns

      By Kinkstaah · Posted

      If the sound goes away when you clutch in, the 1.5/2 way diffs are just shit, and you are a normal person. The diff is likely "fine" but driving at anything under 30kmh is a violent horrible experience. It would be exaggerated with solid diff bushings and subframe bushings if you have those.
×
×
  • Create New...