Jump to content
SAU Community

Recommended Posts

Howdy again!

So, I took the plunge and bought a R34 GTT which I must say I'm absolutely stoked with owning.. after fiddling with the stock seat I can comfortably drive around town. (for those who helped with info on my last post)

- What's the best way of obtaining a stock airbox snorkel? Basically the previous owner put on a Apexi pod filter.. and I cannot stand the induction noise it makes. I do have the airbox itself just not the snorkel.

- Anyone have any good info relating to BC coil overs for daily driving? I've had a read around but I'm fairly lost when it comes to coil overs.

I am planning to make some handling & minor cosmetic changes in the near future ideally including some coil overs and wheels. If anyone could point me in the right direction it would be greatly appreciated.

I guess to sum this up, I don't plan on chasing huge HP numbers more so modications to tackle the twisty bits.

Link to comment
https://www.sau.com.au/forums/topic/394650-a-few-questions-related-to-r34-gtts/
Share on other sites

1. For Sale section

2. Totally depends on budget, spring rate choice etc. Have a read of the Suspension Section, heaps of info to let you make your mind up. Everyone is different as to what they prefer.

I was talking to OTR in Clayton and there were saying they can get a little bumpy if you're using it on the road alot. Although if you're like me and like the feel of a stiffer ride to give you that "sporty" feel I'd definitely go for them. If I could afford it I'd go buy them. Tein's are supposed to be softer but are more expensive new. Just depends on what you're after I guess

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Dredgggggeeee time; I have recently finally started driving the car. It sat for so long that the fuel tank gave birth to rust sludge and blocked my lift pump sock and one of my walbro 460's and left grime, rust chunks and muck all through the surge tank and system. I decided to commit and pull the trigger on an oem r32 gtr fuel tank and Frenchys twin 460 / sender / surge tank hanger combo and all new larger lines and fittings etc, also boost doc heater hose kit / new heater core and a heap of other bits and shits like wideband sensor installed in the dump and Syltech iacv + lines and all wired and added to current tune. now having lightly driven it a couple times without issue, I can happily report on the hta3076 in its current tune. still no boost control switched on, 20psi gate springs, car makes 22psi at 3200rpm in 6th gear with 30-50% TPS from cruise at 100kmh. Going by the old graph, this means it should be making 300-325whp at the same numbers above. Very very responsive setup under true road driving loads. all that's left for the build is body loom + PDM, finish the remote aircon setup, install carbon fibre parts and go for full tune and 30psi. the 315 rear tyres are now performing like they're 195's, wheel spin in any gear at almost any rpm, whereas my previous setup hooked up in 3rd no issue, albeit Nt01's back then / RB25 5spd vs (new) old date r888r's Z34 6spd now, + obviously all the support upgrades I listed in the quoted post above. car sits at 1-3psi on cruise at 100kmh, expectations totally exceeded and I'm beyond stoked with all this so far. IMG_4848.mov
    • I've also been eyeing their rear axles for my car. I purchased seat mounts from them about 7 years ago and they were hot garbage so I've been a little wary about purchasing them. With that being said, please buy them and get back to us haha. 
    • Can a moderator please move this into the right category.. I've accidently put this into racing build thread 🤦🏽‍♂️
×
×
  • Create New...