Jump to content
SAU Community

Recommended Posts

Hey all,

So i have an r34 gtt.

Z32 AFM, Xspurts 725cc injectors, bosch o44 fuel pump, Nistune.

Turbo, cooler, exhaust bla bla bla.

Problem is cold start is shit, idle is a little rough, and one the cars warms up, it has quite a nasty stumble low in the revs under slight load.

Everything else is great, just gets annoying when cruising around.

AFM is good, no vacuum leaks, no apparent leaks.

Ive had it retuend multiple times, and cant seem to shake it...

Im thinking injectors, but i wanna know what others may think before i rip them out and replace them,

All my parts are less than 12 months old, and its driving me nuts.

Any help would be awsome.

Cheers, Cam

Link to comment
https://www.sau.com.au/forums/topic/398460-r34-gtt-issues/
Share on other sites

the stumble at low revs as you put it sounds like it could be coilpack related. but where have you been taking the car? coz the issues sound tune related to me.

or maybe fuel pump is on the way out

Link to comment
https://www.sau.com.au/forums/topic/398460-r34-gtt-issues/#findComment-6327780
Share on other sites

going fast and stopping fast are too different things

and i don't drive that fast like i used to either... remember all eyes are on Steve when I'm out and about

Dan - the R34 wouldn't have an igniter they are built into the coil packs since S2 RB25

Link to comment
https://www.sau.com.au/forums/topic/398460-r34-gtt-issues/#findComment-6328200
Share on other sites

Its the ilde air control on the back of the manifold is carbon caked that controls idle air and cold start driveability

backside of throttle plate is most likely as well , check the TPS its a touchy bastard with nistune and voltages ever so slight can make it run wonky

Also check O2 sensor

And run a ground wire from coil packs to firewall

with cover off turn off the lights and run the engine you can sometimes see the culprit spark jumper

My splitfires played up after 2 years doing the miss fire and abs, slip, tcs warning to come on The dash

Confirm no boost leaks or vacuum leaks as well

Fuel regulator if its tee'd off for boost gauge , dont do that return to factory setup it can surge and fry a motor if it pops off

And of course fuel filter

And fuel brewed last week is different mix then this weeks cold weather batch if you didnt know that ??

Link to comment
https://www.sau.com.au/forums/topic/398460-r34-gtt-issues/#findComment-6328230
Share on other sites

Does it have nismo thermostat low temp? That on nistune causes issues until its hot as hell too

the laptop kept saying low temp on mine while on

Dyno 35c day , no issues on cold day so far just smells rich as hell for the first 2 km

My car only had 74,000km and it was caked with crap , injector cleaner wont fix that idle air problem either the injection happens below that

Link to comment
https://www.sau.com.au/forums/topic/398460-r34-gtt-issues/#findComment-6328235
Share on other sites

going fast and stopping fast are too different things

and i don't drive that fast like i used to either... remember all eyes are on Steve when I'm out and about

Dan - the R34 wouldn't have an igniter they are built into the coil packs since S2 RB25

Cheers Steve - Lesson learned..... :domokun:

Link to comment
https://www.sau.com.au/forums/topic/398460-r34-gtt-issues/#findComment-6328243
Share on other sites

Its the ilde air control on the back of the manifold is carbon caked that controls idle air and cold start driveability

backside of throttle plate is most likely as well , check the TPS its a touchy bastard with nistune and voltages ever so slight can make it run wonky

Also check O2 sensor

And run a ground wire from coil packs to firewall

with cover off turn off the lights and run the engine you can sometimes see the culprit spark jumper

My splitfires played up after 2 years doing the miss fire and abs, slip, tcs warning to come on The dash

Confirm no boost leaks or vacuum leaks as well

Fuel regulator if its tee'd off for boost gauge , dont do that return to factory setup it can surge and fry a motor if it pops off

And of course fuel filter

And fuel brewed last week is different mix then this weeks cold weather batch if you didnt know that ??

My mate had similar issues with his WRX and it turned out to be the o2 sensor or talk to Morrie at Horse Power in a Box that guy is a legend other wise i agree with everything stated in the post above.

Link to comment
https://www.sau.com.au/forums/topic/398460-r34-gtt-issues/#findComment-6328726
Share on other sites

Ashley at classic chassis and dyno in hackam , he has a Gtt so he knows them well

Nice guys who go above and beyond to do it right not time clock watchers who punch out at 4:30 like a few ive run across

But im pretty sure you will find the problem as above

Unless your wiring harness is knackered , nissan is bad for that in out vintage of cars in this climate

If the car is throwing codes even that can be a goose chase of intertwined ecu functions and not cut and dry fix.

No codes thrown , my money is on idle control and throttleplate ( unless it has greddy manafold)

The 34 O2 can be swapped with some wiring hack for another model , mine was shagged ,2 in 4 years , the r31 i just sand it back slap it in its lasted since car was new in 89 still the original one Still going strong

Link to comment
https://www.sau.com.au/forums/topic/398460-r34-gtt-issues/#findComment-6328789
Share on other sites

Its the ilde air control on the back of the manifold is carbon caked that controls idle air and cold start driveability

backside of throttle plate is most likely as well , check the TPS its a touchy bastard with nistune and voltages ever so slight can make it run wonky

Also check O2 sensor

And run a ground wire from coil packs to firewall

with cover off turn off the lights and run the engine you can sometimes see the culprit spark jumper

My splitfires played up after 2 years doing the miss fire and abs, slip, tcs warning to come on The dash

Confirm no boost leaks or vacuum leaks as well

Fuel regulator if its tee'd off for boost gauge , dont do that return to factory setup it can surge and fry a motor if it pops off

And of course fuel filter

And fuel brewed last week is different mix then this weeks cold weather batch if you didnt know that ??

Ashley at classic chassis and dyno in hackam , he has a Gtt so he knows them well

Nice guys who go above and beyond to do it right not time clock watchers who punch out at 4:30 like a few ive run across

But im pretty sure you will find the problem as above

Unless your wiring harness is knackered , nissan is bad for that in out vintage of cars in this climate

If the car is throwing codes even that can be a goose chase of intertwined ecu functions and not cut and dry fix.

No codes thrown , my money is on idle control and throttleplate ( unless it has greddy manafold)

The 34 O2 can be swapped with some wiring hack for another model , mine was shagged ,2 in 4 years , the r31 i just sand it back slap it in its lasted since car was new in 89 still the original one Still going strong

Hey mate, i need u on speed dial ha ha ha.

Ok so i already checked the IAC valve, cleaned and replaced a while ago chasing this, and didnt work.

Im more inclined to the TPS, but i thought that would be show any issues while tuning, and my tuner would clearly see it? i may be wrong...

Either way does anyone here know how to check the TPS on my car?

O2 sensor is good.

No sparks in the dark, and i ran an extra earth lead from my coils when i installed them.

Ive checked leakes with break cleaner, are there any better ways?

My FPR is TEE'd off for my Profec B...

New fuel filter last week with its service.

N yeh i know fuel changes, but nothing we can do bout that, much like the price HAHA!

I might take it to see Ashley, if he has a 34, id hope he will be able to help.

Thanks everyone for all your input, keep it comin!!

Link to comment
https://www.sau.com.au/forums/topic/398460-r34-gtt-issues/#findComment-6329327
Share on other sites

...

Thanks everyone for all your input, keep it comin!!

Something a bit left field, have you checked your Crank Angle Sensor? Mine was stuffed and was very difficult to diagnose, read more here.

Good luck!

Edited by V28VX37
Link to comment
https://www.sau.com.au/forums/topic/398460-r34-gtt-issues/#findComment-6329475
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Version 1 aluminium airbox is.......not acceptable No pics as I "didn't like the look.....alot" Even after all my "CAD", and measurements, the leg near the fusebox just didn't sit right as it ended up about 10mm long and made the angle of the dangle look wrong, the height was a little short as well, meh, I wasn't that confident that Version 1 was going to be an instant winner I might give Version 2 another go, there's plenty of aluminium at work, but, after having in on and off a few times, and laying in the old OEM airbox without the new pod filter and MAF, there may be an option to modify the OEM air box and still use the Autoexe front cover and filter.... maybe This >  Needs to fit in here, but using the panel, and not the pod, the MAF will need to fit in the airbox though> I'm thinking as the old OEM box and Autoexe cover that is sitting in the shed is just sitting around doing nothing, and they are relatively abundant and cheap to replace if I mess it up and need another, it may well fit with some modifications to how the Autoexe brackets mounts to the rad support, and some dremiling to move it get in there, should give me some more room for activities, as I don't want to move the MAF and affect the tune Sealing the hole it requires to stick it in the air box is simple, a tight fit and some pinch weld will seal it up tight  I am calling this a later problem though
    • and it ends up being already priced in as though you're just on 91RON without any ethanol. Car will lose a bit of economy as the short and long term fuel trims bring down the AFR back to stoich or whatever it is for cruise/idle for the engine.  
    • Oh, you are right. But, in Australia E10 is based on 91RON fuel and ends up being 94RON. Hence it being the cheaper option for economy cars. The more performance oriented cars go for the 98RON fuel that has no ethanol mixed in. The only step up we have left then at some petrol stations is E85.
    • There is a warning that "this thread is super old" but they ignore that anyway...
    • With 10% Ethanol, we're talking 2-3% fuel consumption difference. The emissions reductions and octane boost in my opinion far outweigh this almost non existent loss.    My tanks sitting at 80%. Luckily that should go down fast as I'm on vacation again for the next two weeks. 
×
×
  • Create New...