Jump to content
SAU Community

Recommended Posts

Very nice!! Any mods to the car? And what iphone app are you using?

Car has Willall full exhaust, project mu pads and fluid and Dodson braided lines.

Using Harry's Lap Timer app with an XGPS 150 Bluetooth GPS receiver which gives 5Hz position updates (mounted in corner of windscreen).

It worked well other than missing the start/finish line once.

I haven't played around with the data yet but it saves your laps in various different formats for various different data analysing programs.

Cost was around $130 for the above and the windscreen mount, I figured this was cheaper than a RaceChrono or vBox type thing.

We went to one of these a couple of years back

Northside are great folks, which is why our new MY12 came from them :)

Yes I can't speak highly enough of Richard and Northside Nissan, we are very lucky to have these people here in Perth.

Are the mu pads any quieter than stock?

I've been plagued with squeeling pads from day 1

I haven't heard anything out of them yet though it is early days. Perhaps after a few street drives since being on track they will make noise. Not sure. I certainly had squeals from the OEM pads though it was only at very low speed and didn't bother me too much.

I am using their "Type HC+" pads.

Great footage mate,i think you fly past my car at one point,it was a great day,nice to see every one having a good time.hope to see you at the next track day,now for that mid-pipe........

Early August for the next one, worth coming along to the Targa West event too, great variety of cars there.

Yes get that midpipe!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...