Jump to content
SAU Community

Recommended Posts

hi selling a whole lot of stuff ive had sitting around

also have a complete r33 minus engine and box

so if you need anything off a 33 let me know what your after

cheers

blitz power meter id -$200

gizzmo electronic boost controller -$200

autometer 2 inch silver faced air fuel ratio gauge -$80

autometer 2 5/8 black faced boost gauge with mounting cup -$100

75x300x600 front mount intercooler -$100

r33 gtr intercooler -$200

r33 gtr front reo -$200

gtr injectors -$200

adjustable fuel reg (might be malpassi) -$60

FET tb202 turbo timer good working condition -$50

BOSCH 746 fuel pump (used for about 2 months before engine was removed) -$150

TURBOSMART type2 v port bov almost new -$120

MONZA dual trumpet bov brand new in packet -$100

GREDDY bov(bolts to stock rb cross over pipe) -$100

S13/r32 tanabe rear coilovers no knocks -$200

s14 cusco front strut brace -$150

R33 front strut brace -$100

R33 NISMO front strut brace with brake stopper -$180

R33 rear strut brace -$100

GC8 WRX/FORESTER front and rear strut braces -$100each

CA STUFF

ca18 stainless low mount tune length manifold brand new -$150

ca18 manual tail shaft -$100

ca18 manual pedal setup -$150

ca18 stock manual radiator -$80

ca18 engine loom -$100

ca18 afm -$50

ca18 cas -$50

ca18 alternator/pwr steering pump/starter motor -$50 each

ca18 flywheel and almost new excedy clutch -$150

ca front seats -$100 pair

car rear seats -$80 set

SR STUFF

s14 t28 with snout with lines -$400

stainless split dump with stainless 3inch front pipe -$200

RB STUFF

Rb25det series 2 head complete head including inlet plenum (no coilpacks or injectors) -$300 has a bent valve

Rb25 top feed billet fuel rail hks copy brand new -$100

remote oil cooler with remote oil filter (just uses rubber hoses) -$200

RB25det series 2 air flow meter -$150

RB20det stock injectors -$100

RB25det stock injectors in stock rail -$100

RB20det 5 speed ecu -$100

rb25det 5 speed ecu -$100

R32 cross member -$100

RB20/25 series 1 stock coilpacks -$100

Rb25 series 2 coil packs -$200

rb25 lightened flywheel -$100

rb20/25 flywheel and used excedy clutch bit of meat left -$150

R32 STUFF

4 door front seats -$100 pair

gtst bonnet couple little dimples -$100

front gaurds have been rolled not the best -$60 the pair

rear tanabe coilovers no knocks -$200

4 door boot -$50

7 point bolt in roll cage complete with bolts and base plates -$700

R33 STUFF

R33 brake set up consists of

front and rear hubs,front and rear drilled rotors,front and rear calipers,hand brake setup -$800

R33 boot -$100

R33 bonnet -$200

R33 front guards -$100each

R33 head lights -$300 pair no broken mounts

R33 tail lights -$50 each

R33 rear bar -$80

R33 lower control arms -$150 pair

R33 front reo -$100

R33 rear reo -$100

R33 coupe m spec side skirts (1 crack on the side of each(bit that hooks around) -$100

R33 coupe m spec rear pods -$60

R33 front seats -$150 pair no rips

R33 rear seats -$80

most 33 interior up for grabs aswell hit me up if after something

RANDOM BODY PARTS

R32 gtst bonnet couple very small like dimples -$100

silvia boot -$100

silvia rear tail lights -$50 each

silvia stock rear bar great condition not cracked -$100

silvia rear reo -$100

can get any pics if needed just hit me up

located near byron bay in northern nsw bout 30 mins past tweed heads

Edited by team carefactor
  • Replies 60
  • Created
  • Last Reply

Top Posters In This Topic

also have some R34 parts

stock turbo front bar -$200

stock front gaurds -$100 each

nismo 300km dash cluster -$250 (one small crack in outer plastic)

post-48080-0-18558300-1337255569_thumb.jpg

post-48080-0-33135600-1337255582_thumb.jpg

post-48080-0-64748300-1337255597_thumb.jpg

post-48080-0-38910500-1337255611_thumb.jpg

post-48080-0-27935400-1337255659_thumb.png

Nismo strut brace sold pending payment.

No stock steering wheel sorry well not in very good nick ;)

Pm me about the reo if you want

Body parts are series 1

Thanks

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Join SAU NSW for a flame-grilled feed & flame-spitting cruise! Sunday 17th August 2025 3:30PM Meeting Archies Flame Grille Sylvania Waters 4:45PM Cruise Departure 5:15PM Arrival at Cape Solander Kurnell Meet Location: Archies Flame Grille Final Destination: Cape Solander Kurnell *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
    • Yeah good luck out there! Will be good to see a mighty GTST going harder than the GTRs
    • i will be there 😁
    • Hello!  i just finished manual swaping my r34 skyline with a r33 rb20de box(RB71C)box  When the car is running it squeaks crazy loud and it was smoking from the gearbox area. The gearbox is fine it was tested. The clutch slave cylinder seems like it doesn't fully releases the clutch. I want to ask if this noise is from the throw out bearing or could it be the clutch assembly or disk att.xFliq87Gzw6kImKBVqDebXkj0fBqymk0JaYeP3_3SlM.mp4
    • A few small updates since the previous post and lessons. I decided to do a little interior light upgrade on the 110. I quite like the iilumo items, even if they're a bit of a premium over other brands. You'll also note the Stedi Fogs, that will go into the S15 fog lights as I needed to match the bulbs since I got the new ones earlier. I hope they fit as the body is quite a bit longer than your normal bulb.  Annoyingly, I managed to trip the fuse, which normally wouldn't be an issue until I located the fuse. I can't say I've ever come across this. I had lucked out that someone nearby had a spare, but oddly enough Toyota dealerships seem to keep this in stock. I ordered some to keep in my stash and as luck would have it, someone else nearby tripped the same fuse so I passed on the favour.  I also did a little service on the 110 ahead of some additional work coming up. It's been annoying that Goleby's stopped carrying this particular HKS filter for the 110, so now I need to keep them on order from Japan. I also took the opportunity to install a bash plate and number plate riser. The plate riser is such a cheap but nice fix to help really tidy up the car. I'm tempted to now also replace my headlights, on this car. Both items were from Project Aero.    I also needed to replace the rear tyres on the 110, and after trying to get it aligned learnt that I need to replace some bushes in the front end, so that's next.  Closing out this update with a nicer picture as always! 
×
×
  • Create New...