Jump to content
SAU Community

Recommended Posts

My whiteline castor bushes couldnt get more than about 5-5.5 degrees. Sydneykid reckoned 6-7 degrees was the limit of these replacement bushes.If you're after more its best to go with a fully adjustable caster arm with a threaded shaft and rose joint (aka rod end) connection. Much more adjustment, just not ADR approved.

IMO run as much castor as you can get away with. To a point!!!

Caster promotes favourable cambering of the wheels specific to the corner (left hand bend - inside and outside wheels camber towards the inside of the corner) to promote higher lateral grip.

However, There are a few disadvantages to running alot of caster. With symmetric geometry, the effect of caster in a left steer situation is to roll the car to the right causing diagonal weight transfer. This will generally lead to the car bearing more load on the right rear tyre, unloading the left rear. This leads to reduced traction when exiting corners.

The offset will never allow a huge amount of caster increase. I would suggest a pair of Kazama/Cusco/Ikeya/TEIN caster rods if you want to achieve specific alignment settings.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I mean it's a bit late to say "This won't have any tangible effect and it is not worth spending more than about three seconds on it, please just enjoy the car" But I said it anyway. Does the pod actually get any airflow in that position behind a bumper like that?
    • Hey guys - apologies for digging this up. Has this website been shutdown or is the outage temporary?
    • So, went shopping at Just Jap for things that might work for the intake  After some trial fitting there I ended up with a 3" x 45° silicone bend, a 3" x 300mm alloy straight, and a humped joiner, some minor trimming will be required to shorten some of the stuff, but nothing that is beyond my "ham fisted" skills The guy at Just Jap was most helpful as we had all sorts of joiners,  bends and stuff out trial fitting  Laying it out above the stuff in there it seems everything will fit nicely, and looking at it, it is probably the way I should have been looking at doing it from the beginning, probably..... In the end it is a front bar off job anyway to remove the original stuff behind the front bar that is taking up the required realestate needed, so maybe a Thursday or Friday job And because I'm a hopeless consumer, I grabbed some new steel wheel nuts, the current ones are a spline drive type with a "security" socket, that somehow someone keeps misplacing, the new ones are a basic black steel 17mm hex socket In other news: I just did my "final" tax return, I am now officially a old retired veteran pensioner, and I'm milking the system for all it's worth,  life is good
    • I hadn't thought about the variable power steering assist. Presumably, it will always be the same level of assist as you get in an S14. The R32/3/4 are either helliishly heavy (at low speeds) if the solenoid is not powered at all, or hellishly too light (at high speed) if it is powered all the time. I presume that it is PWM controlled on those cars. I hadn't thought about the S cars not having variable assist. ugh. What crappy plebby cars they must be!  
    • Hmm yeah that is a good point. It looks like it'll just bolt in with no real issue besides maybe the bushings being different. My other concern was that 2 pin plug that I assume is used in some way to control the rack solenoid depending on the speed signal from the ecu. The DMAX rack doesn't even have that plug though so, don't think it'll matter. Might just order the rack and see how it goes. Will update this when I figure something out
×
×
  • Create New...