Jump to content
SAU Community

Recommended Posts

There's a steep driveway at my Mum's place which would abrade low lips like nobody's business at the bottom concave section.

Then I installed a rubber speed hump set. It took half an hour to get the positioning just right & then the masonry bolts went in.

The lower lip only faintly brushes the rubber hump now :)

Link to comment
https://www.sau.com.au/forums/topic/403665-steep-driveway/#findComment-6422140
Share on other sites

Did the dodgy and used a plank of wood and some bricks... looks so shabby

Will look @ investing in some of those rubber speed humps.... I have the same problem with the curve @ the top of the driveway.

Have to reverse up to get out too! Skidding all over the place with the semi slicks ....0.o

Link to comment
https://www.sau.com.au/forums/topic/403665-steep-driveway/#findComment-6422456
Share on other sites

I made a custom lip that was 20mm shorter than standard. Extreme approach but I have the driveway from hell (but ain't moving cause cost us just about everything we owned to get into this place).

Oh and have the wood and bricks too to get out of the garage to the incline on the driveway (goes up then down onto the street).

Link to comment
https://www.sau.com.au/forums/topic/403665-steep-driveway/#findComment-6423403
Share on other sites

Pick and shovel with hard work or a bobcat and cash.

I made a driveway, carport, and level paved area all by hand.

It helps to have construction experience so you get the drainage and retaining walls right.

Second hand pavers and my own ute made it cheap.

My back says i should have paid for a bobcat.

>_<

Link to comment
https://www.sau.com.au/forums/topic/403665-steep-driveway/#findComment-6425277
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • I tried the next one up from 600k ohms which is 60M on my multimeter and all readings came out as 0.00 ohms so right now the most accurate is 600k ohms with only a 0.1 ohms difference between coils. Three coils read 1.4 ohms and the other three read 1.5 ohms.
    • surely that is a control arm, not a sway bar. In any case, visual condition should not be an issue, excessive movement under load (eg with a big pry bar) would be the issue. I can't see 99.999% of pink slip places even looking, let alone trying to test it
    • I attached the image of the only thing I found, nothing to do with ohms in the manual only torque values etc. However, being they are so close to each other I am almost certain they are good. Tomorrow I will test the spark plugs while I am there. and look at the ECU connections.
    • Hi Gents. Do u know what 18rim will fit under R32 GTST with no modification of current setup I have. I have buddy Club P1 17x8 on front and 17x9 rears and they fit well.   Will an 18x9 on 35 off set with 235 tyres up front fit? ON the Rears i can run the rim size n fit 255 or 245? or i got option to get 18x9.5 on 35+ Offset n 265?   CHeers
    • And, when measuring and getting <2 ohms, perhaps chose the next larger range than that, rather than something with a k in it!
×
×
  • Create New...