Jump to content
SAU Community

Recommended Posts

IT'S ON!

Thanks for being patient people.

Monday 6/8/2012

@ 7pm

Pioneer tavern, northern rd, penrith(next to john cootes) just off the freeway.

They have a full menu, bit Mondays are 2 4 1 chicken schnitzels.

24 schnitzels toppings to choose from.

3 sizes to choose from.(im a big eater, I get the small).

Jugs of softdrink are $9.50

I'm pretty sure the snitties are a et ound 25+....

I will be booking a table a week in advance.

It does get busy, and you will have to line up for your order.

Went there last Monday, and waited in line for approx 20mins, but they do get the meals cooked pretty quick.

Tables were packed, that's why ill be booking.

Please list in here if you're coming.

Anyone that can't confirm that far out, should be able to just grab a table.

Hope to see you all there.

Cheese, Luke.

  • Replies 57
  • Created
  • Last Reply

Top Posters In This Topic

August? That's, like, years away!

I didnt want it to clash with any other event.

This was around the best time, and it gives people time to organise.

I know how bad people are on here for that.

how farken good is schnitzel?

best i had was a pub in melbournes chinatown that had about twenty different kinds..also the gypsy sauce snitties at Una's german rest. in double bay, they have one near broadway called 'Essen'.

this place might push them off the totem pole though..




  • Similar Content

  • Latest Posts

    • Update: tested my spark plugs that are supposed to be 5ohms with a 10% deviation and one gave me a 0 ohms reading and the rest were 3.9ohm<, so one bad and the others on their way out.
    • 9" wheels are a little too wide for a RWD 32. They can fit. People have put R33 GTR wheels on 32s for years and years. But they are a very tight squeeze. This has been known for about 30 years. As I said - there is no difference between a 17 and an 18 in terms of what will fit. The rolling diameter needs to stay about the same as stock - not very much larger. If you increase that, you will start to have problems. If you increae rolling diamater at the same time as yo increase width, you will have problems earlier. as 9" wheels are pushing the boundaries already, you would need to be careful with tyre choice. I would put 8.5s on the front of mine, but would expect problems with 9s.
    • post up screen shots of your injector tables
    • Diagnostic flow for a code 21 says check signal at the ECU pins, on a voltmeter of some kind it should read 0.1V at idle, 0.12V cranking, 0.15-0.25V at 2000 rpm. Check each coil such that +1, -3 is infinite or very high resistance, -3, +2 should do the same. (-1, +3), (+3, -2), (+1, -2), and (-1, +2) should all be somewhere between 0 ohms and high resistance. If you trace the path from the coil pin all the way back to the ECU in the diagram the resistance you measure at the coil vs connected to the harness should be pretty much the same. 
    • I have an elite 2500 running an adapter harness on an rb25de neo r34. I took the butterfly out and removed all that junk. But I also went Plus+t at the same time. The butterfly thing works in reverse to the boost solenoid on the Gtt if that makes sense
×
×
  • Create New...