Jump to content
SAU Community

Recommended Posts

Hi , im after some info as my 99' R34 GTR had no service interval books when i purchased it in 2010 , it currently has 70 k on the odometer so to be on the safe side so i decided to do a 100k service -

1. Replace water pump with new factory item ( mechanic )

2. Replace timing belt (mechanic)

3. Install adjustable Cam gears (mechanic )

3. Replace idler and tensioner bearings (mechanic)

4. Replace oil filter

5. Replace coolant

6. Replace all the belts AC, Power steer , fan belt

7. Drain and fill both front and back diffs - not 100% sure of oil

8. Drain and fill the gearbox - not 100% sure of oil

9. Replace Air filter

10. Spark plugs

11. Engine oil

12. Coilpacks

13. Check O2 sensors

Have i missed anything , also does anyone have a service interval book that details a 100k service ;)

Thanks for help

Edited by NISSAN GTR
Link to comment
https://www.sau.com.au/forums/topic/406167-require-r34-service-schedule-100k/
Share on other sites

Don't skimp out on the cam and crank seals, they're standard as part of the 100k service.

Might as well change the transfercase (only genuine Nissan fluid) and ATTESSA fluids too if you're doing the gearbox and diffs.

Coilpacks, completely unnecessary and a waste of money unless the car is misfiring.

As for gearbox oil, only use the proper Getrag stuff (Toyota V160 or genuine Nissan fluid etc). You will see recommendations like redline shockproof but these are for nissan 5 speeds, getrag boxes use ATF fluid so thorough research is needed if going with another brand like RP syncromax etc otherwise you will could damage an expensive gearbox if brand shopping.

I posted up the full itemised schedule for the major services at 40, 80 & 100 K some time ago.

It came from Nissan's UK Owners Manual since R34s were sold there.

It's here in General Maintenance somewhere :)

Terry-263.jpg

Terry-264.jpg

Legend:-

I = Inspect and Correct or Replace As Necessary

R = Replace

L = Lubricate

Engine And Emission Control Maintenance

Major Service of 80,000Km and 100,000Km

Engine Oil = R except for Turbo Engines which requires a change every 6 months or 5,000Km whichever is earlier

Oil Filter = R (and more frquently under harsh driving conditions)

Drive Belts = I

Engine Anti-freeze Coolant (ethylene glycol) = R

Cooling System = I

Air Cleaner Filter (paper type) = R

Intake and Exhaust Valve Clearance = I if noisy

Fuel Lines = I

Spark Plugs (Platiunum) = R (at 100,000Km)

Heated Oxygen Sensor (exhaust gas sensor) = I

EVAP Vapour Lines = I

Timing Belt = R

Fulcrum Bolts = I

Chassis And Body Maintenance

Major Service of 80,000 & 100,000Km

Brake, Clutch & Auto Transmission (for level and leaks) = I

Brake Fluid = R

Brake Booster Vacuum Hoses, Connections & Check Valve = I

Power Steering Fluid & Lines (for level and leaks) = I

Brake, Clutch & Exhaust Systems = I

Manual Transmission Gear Oil (for level and leaks) = I

Differential Gear Oil (for level and leaks) = I (to be checked every 2 yrs if car is more than 10 yrs old)

Limited-Slip Differential Gear Oil = R

Transfer Fluid = R

Steering Gear & Linkage, Axle & Suspension Parts = I

Propellor Shafts & Drive Shafts & Boots = I

Wheel Alignment & Wheel Rotation = I

Brake Pads, Rotors & Components = I

Locks, Hinges & Hood Latch = L

Seat Belts, Buckles, Retractors, Anchors & Adjusters = I

Foot Brake, Parking Brake & Clutch (for free play, stroke and operation) = I

Ventilation Air Filter = R

P1040765.jpg

Yes, on the Binder, it says R34 :)

Interesting how there is no mention of water pump replacement though , will replace anyway and bang some cam gears on

should make a difference !!!!

Thanks Terry and Rocky , your posts made me more confident i am doing the right thing here . :cheers:

Hi Terry

Can i have a pdf copy of this manual . been searching all over the net. Just bought a r34 GTT auto...thanks mate cheers

Hiya,

xntrq aka Ricky has a PDF. He's glad to send you that :)

I have the hard copy

If you'd like disc of the R34 workshop manual in PDF I can do that :)

You have mail.

To anyone else who needs these files, the link is here:

http://www.mediafire...kfp0g2vulagm88v

Contents:

The Sky Is The Limit - Pretty much a Skyline bible, tells you the history, fuel consumption, variations, what to look for during inspection (R33 specifics) etc.

Skyline R34 Brochure - I think you'd like this one Terry

R34 ECU Pin Outs - Each and every terminal number

Inside Fuse Box Map - In English

R34 GTR MFD Programming - How to program GTR MFD

R34 Scheduled Maintenance Handbook - When you reach a certain KM on your ODO, you do this and that.

R34 Service Manual (Workshop Manual) - This has EVERYTHING.

R34 Stereo Pin-Outs - Each and every terminal number

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The German place in Cabramatta was rock solid, fresh pretzel cooked to order back then. Then it went all quiet, after all the poker machines were removed, then I believe it closed for good. I did drive past the other week and noticed outdoor lighting a big screen, but no idea what is there now.  
    • Yeah I suspect even if you hold airmass per cycle/cylinder constant if you get too far away from stock you're still going to have problems running the factory tune within the bounds of the factory load scale. Cams, different displacement/rod ratio, etc. I'm just lucky that the GTIII-SS with wastegate boost + CA compliance cats is pretty much equivalent to stock turbos. When I have actual space I can finally get it tuned and modify the fuel system for flex fuel to 100% handle any detonation concerns when cranking the boost to whatever those dinky turbos can put out.
    • I would say no, why, because my daughter, who also lives in Goulburn, hasn't recommended us going there Pity, as we miss all the German joints around in Sydney, actually, the restaurants are the only thing I really miss about Sydney, and a special mention to Ishibanboshi at Bondi Junction, their Kara-age Don is heart cloggingly deliciousness (always added a special boiled egg...or 2) 😋 
    • Does that German restaurant still exist in the old place out the NW end of Goulburn? When I say "out the NW end of"...I am really being vague. It was 1997 when I was last there, and the only point of reference I can recall is that it was on the opposite side of the main drag from the big merino. And when I say "opposite side of the main drag", I don't mean "on the main drag". It was either a couple of streets back from there, or might have even been out in the sticks a bit further. Was an old farm building or mill or somesuch. And when I say "the big merino" I might actually be thinking of a completely different part of town, because I just looked on maps and the big bugger is not where I remembered him to be! The food was good, consisting largely of various German mystery-meat sausage/loaf things and kartofflen.
    • So while the second sentence is completely correct and the whole point of the conversation, the first sentence bears consideration. If this bloke is just hoping to throw big turbos on and drive it around, because there are no helpful facilities at all in his tropical paradise** then he likely has zero chance of even knowing what the TP is on the last column in the stock maps, let alone know whether the ECU is operating anywhere near it or past it. So the point is very very moot. And, per what I said before, at stock boost on those turbos, you may well be off the end of the map. **I'm just back from Vanuatu, so I know exactly what small Pacific nations can be like wrt paradise without requisite facilities. But it's not even that simple. I put a high flow on my car and had to drive it around without a proper tune because of the lack of opportunity*** to put the bigger AFM and injectors into it to allow it to be tuned. I had to turn the boost down to less than I had before, and back off the boost controller's ramp, because it was exploring parts of the map that it didn't drive in before, and really couldn't access for tuning on the dyno either, and so was pinging. It was still well within the last column, because when I first**** set up the Nistune on the Neo I rescaled all axes of the maps to give some more space to explore. ***Family dyno was broken ****This was 13 years ago, and the TIM thing wasn't a thing then and so TP would definitely grow when pushing past the stock tune's limits.
×
×
  • Create New...