Jump to content
SAU Community

Recommended Posts

Hi everyone, I am getting a nistune and tune for my 34GTT and I was hoping for a bit of advice.

The car currently has the usual mods - FMIC, Turbo back exhaust, pod, coilovers. I have read a lot about the nistune which lead to the decision to get one, however I am in two minds about upping the boost. Originally I figured I would get the car tuned and up the boost to around 10psi, but lately I have been wondering if this will be worth it in the long run.The car has ~80thousand k's (100k service done) on it so upping the boost may cause things like clutches and other work parts to fail, and it will have that label as "a boosted/thrashed car". I have read that 10PSI is safe boost on stock parts...

So my questions are, is there any point getting the car tuned running stockish boost (and getting the most out of my mods) or should I be running 10psi at least for decent results? I am looking at buying a HKS EVC5 fairly cheap, would this be overkill?

Cheers!

Link to comment
https://www.sau.com.au/forums/topic/407037-r34-gtt-nistune/
Share on other sites

  • Replies 44
  • Created
  • Last Reply

Top Posters In This Topic

Well the turbo and setup will be fine for 12-14psi which will make a little bit of power, my standard clutch failed at 199kw which you will go close too BUT it will fail in time anyway so upgrade it!

HKS EVC 5 is meant to be one of the best boost controllers on the market, however mine is a peice of poo! So go something cheaper like Profec B or something! Spend your money elsewhere like on a clutch!

Link to comment
https://www.sau.com.au/forums/topic/407037-r34-gtt-nistune/#findComment-6487707
Share on other sites

I had a high flow on mine when i bought it so not a good comparison but ran 199kw and maxed standard injectors, went up a size and went to 250kw safely on 13psi.... Ive heard people go too 220kw on the standard injectors but my car had no sign of going there!

Link to comment
https://www.sau.com.au/forums/topic/407037-r34-gtt-nistune/#findComment-6487836
Share on other sites

Do it.

Get a Nistune and go to 10psi. You'll get noticeable more poke and your clutch etc will be find.

Later down the track you can do some more mods and you'll already have the hard part (the ECU) done and ready to be tuned.

Link to comment
https://www.sau.com.au/forums/topic/407037-r34-gtt-nistune/#findComment-6487942
Share on other sites

haha, so I am thinking I should just up the boost and do it!! :P planning to go to EFI in brissy btw.

Car has a tad over 80k on the clock with 100k service done. I get the feeling the clutch is not 100% already as it only bites in rather late on the pedal, although I have read that this is typical with 34's? It has never shown any sign of slipping while under load so I dunno.

Do I need a boost controller to adjust the boost? I can get an EVC5 for around $300 but I do take the point of maybe putting this money into a clutch and maybe just getting a boost tee?

Thanks for everyones comments.

Link to comment
https://www.sau.com.au/forums/topic/407037-r34-gtt-nistune/#findComment-6487996
Share on other sites

Do it! :D

Mine slipped and died at 100k

You may be able to get an actuator but a simple Turbotech would work if you want to go down that path, 300 is cheap though! (The EVC 5 is more involved in setup too i believe)

Link to comment
https://www.sau.com.au/forums/topic/407037-r34-gtt-nistune/#findComment-6488007
Share on other sites

I'm glad I posted because I am getting slightly excited :) I just have to decide if I should by the EBC5 I guess. For a simple application like this is it a waste? The only thing I thought would be a pro with it is a more accurate boost gauge? I've read the stock one is pretty dodge

Link to comment
https://www.sau.com.au/forums/topic/407037-r34-gtt-nistune/#findComment-6488166
Share on other sites

Evc 5 can be a nightmare but can also be a dream.

Eboost 1,2 or street, profec b spec 2 are easy to use and all work perfectly.

Kurtis34's old hypergear setup maced stock injectors at 235kw 6000rpm. But it had higher fuel pressure

Link to comment
https://www.sau.com.au/forums/topic/407037-r34-gtt-nistune/#findComment-6488198
Share on other sites

Should be fine, especially if its just street driven.

You may run into problems if you are out on a track on boost the whole time for a few laps, mainly because of the heat it will generate. The heat is what kills the wheel.

Edited by Mitcho_7
Link to comment
https://www.sau.com.au/forums/topic/407037-r34-gtt-nistune/#findComment-6488594
Share on other sites

Should be fine, especially if its just street driven.

You may run into problems if you are out on a track on boost the whole time for a few laps, mainly because of the heat it will generate. The heat is what kills the wheel.

Ah....no it's not. It's shaft speed. Extra heat won't help of course, but the problem with high boost is that the shaft speed heads up into the high hundred thousand rpm region and the wheel cannot take the mechanical stress.

Link to comment
https://www.sau.com.au/forums/topic/407037-r34-gtt-nistune/#findComment-6488603
Share on other sites

I thought the high shaft speed contributed to the Extra heat as well as adding more stress and both those factors put together ended up with the turbine wheel in the cat?

Regardless, 10psi will be fine!

Edited by Mitcho_7
Link to comment
https://www.sau.com.au/forums/topic/407037-r34-gtt-nistune/#findComment-6488642
Share on other sites

Regardless, 10psi will be fine!

That's all I wanted to know! I am pretty damn keen to get this done, any recommendations for boost controllers? I will be more than happy with 200kw at wheels, as I'm guessing it would be around the 160 atm, so should be a nice difference without any flat spots

Link to comment
https://www.sau.com.au/forums/topic/407037-r34-gtt-nistune/#findComment-6488646
Share on other sites

Yes, Nistune it!

Get a Profec B Spec 2 boost controller. They are a good little unit. The EBC will help bring on boost earlier and harder as well as trying to keep the target boost.

Replace your clutch first/at the same time.

Later on down the track, put some injectors, fuel pump and a high flow on it and pump out 250-270rwkW!

Link to comment
https://www.sau.com.au/forums/topic/407037-r34-gtt-nistune/#findComment-6488667
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • I've looked up the parts number (41011AL501). It's around $700 OEM. Usually our Infiniti G35 here in Canada have interchangeable parts with my Stagea but the parts number are not the same. I have looked around and it seems the JDM 2005 V35 Skyline (which is the same as our G35) has the same caliper but I cannot confirm. And I can't find a repair kit. The inner brake pads drags on the rotor, seems to be rusty piston. Thanks for the info by the way
    • This coupled with 6-9 speed autos with ridiculously short gearing is why these modern shitbox cars always seem so fast off the line. If it wasn't for those things, Raptors would not seem fast. The problem we have is there is a driveability gap between a more gentle take off and a wheelspinning sideways launch. The difference between ankle flex required to achieve one and ankle flex required to achieve the other is about 0.5°.
    • Yeah I think I'm also with the opposite here. It's 'hard to keep up with traffic' because in the real world I'm accelerating with 15% throttle and they are pinning it. It feels like I'm being an overt dickhead at anything above 15% throttle, so the car sounds like I'm being an overt dickhead to keep up with/get ahead of traffic when I'm really just trying to drive with traffic. There would be no issue 'keeping up with traffic' if we used the same level of throttle input/aggression to drive around. People really do just drive around with their foot nearly pinned in econoboxes.
    • To be fair it's the other way around. 300kw is boring in a modern Golf or BMW. They are so competent / well-engineered / devoid of emotion that you have to go stupid fast to feel anything. Whereas the <300kw RB still makes all the right noises and it feels good to drive. Can pull off at the lights with the turbo whooshing and the blow-off pssshing and feel like the coolest kid on the block. Just don't look to the side where you'll see the bored housewifes in their shitbox Yaris/Corolla/Camry that kept up because you didn't go fast at all
    • 300kW is so boring in a Skyline, you'll get spanked by someone's mum's Golf with Alibaba pipes, and an email tune.
×
×
  • Create New...