Jump to content
SAU Community

Recommended Posts

  • Replies 55
  • Created
  • Last Reply

Top Posters In This Topic

220-240kw R33 gtr, daily driver.

On the same car with 266kw of power I found the standard 595's too hard and slippery in the wet. The 595 RS-R's were actually far grippier in dry or wet even when cold and lasted for a good length of time.

595 if you have no money, 595 RS-R for safer driving (they are not real semi slicks).

But hey upgrading from the base 595's to the RS-R's shows you a huge difference.

Pirelli p7s are abit soft in the sidewall for my liking. Falkens have good grip, performance and cost effective.

Fk452 = best wet tyre ever, abit noisey like 595, directional, new fk453 out now to replace it.

Ze912 = good allround asymmetric tyre

Or for more coin go the Bridgestone potenza range re001, re002, s001. Very rigid tyre an very quiet.

I believe I'm running RE-001 and they're quite decent in both wet and dry. Can't really comment on their ability to hold traction under power in the dry any more since I think they dried out a bit too much in the months my car didn't move and was outside :(

I had the same RE001s before Troy bought them and I always liked them - they did me well for around 350-400kw atw and I did some pretty hard launching on them too.

Only sold cause I needed bigger wheels to clear my brakes. I went OTT and got semi slicks... Super impractical but f**king fun!

Or go to ntw talk to mick and then take your car/wheels round the corner to jax fyshwick where mick takes his cars ;) haha

Also I got 235/40R18 stretched onto my 9.5"s (widest legally permissible for a 235/40), tyres cheap as and it's the look I'm after.

do you have a picture of the stretched tyre?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • CTIS (Central Tire Inflation System) has existed since the 80's. I'm looking into buying a Hummer H1 and they generally included it. 
    • My idle is set at 950rpm though - Moving the timing around 20 degrees is not really what I'd call a calm idle. That said... neither is chop, by definition. The LS ECU likes to adjust timing to hold idle as opposed to air. It'd work, but generally speaking there'd be a discrepancy in the base idle and the IACV would want to move the timing around anyway to maintain said idle. I think I'm just going to keep the timing steady anyway. Preserve my engine mounts.  My aircon is now officially regassed. As the guy was reversing I noticed my reverse lights do not operate, along with my reverse cam. This is a bit distressing, because 100% of guides talk about which wire to connect to backup cams as "the goes with the [other color] wire". Often when doing conversions. Unfortunately the R34 colour wires aren't documented Unfortunately I had a T56 Magnum gearbox with it's reverse switch, which also isn't documented. Unfortunately there's definitely not documentation for people with both of these in the one car. Unfortunately I forgot. After many hours of this, I have a reverse cam and reverse lights again. The wire going through the trans tunnel to the reverse switch had broken. Upon inspection, it looks like this one wire had about 7 spade terminals and extensions in it.. for reasons I cannot possibly comprehend. I also spent the 750 hours required to clean up the wiring behind my head unit which now looks like this: This is a monumental improvement relative to what used to be there WRT triple gauges, head unit, traction control, wideband controller, and whatever the f**k OEM stuff still exists there in various states of connectivity/needed. Next step is to check in at the Exhaust shop to see/confirm how much clearance I have, to decide what mid mufflers or 'resonators' (which are just straight through, narrower mufflers) I can add and hopefully cut out a lot of exhaust leaks, pinhole, v-band or otherwise. But first step will be to 'take a look' before the next step.
    • Fark the AFM card and Nistune, Haltech Nexus S3, DBW, cruise control, flex fuel, dis dat.  
    • It's most likely the bolt/bush where the cover bolts back wore and allowed cover to move forward.
    • Still haven't put the injectors and R35 AFM in so we can tune the bloody thing for the HG highflow it got mid last year! I think I can forecast the upgrade path to a bigger twin scroll, external gate, Haltech, flex setup, Samsonas, dis dat, etc will be .... a while away!
×
×
  • Create New...