Jump to content
SAU Community

Recommended Posts

  • Replies 40
  • Created
  • Last Reply

Top Posters In This Topic

UPDATED LIST!!! PRICE DROP!!!

various trims $name your price

centre console brackets $1

power steering reservoir minus cap $5

centre dome light without cover $5

driver door loom $5

washer bottle loom $5

number plate lights $5

front windscreen washers $5

ignition/headlight reminder beeper $5

stock rear audio amplifier $5

sun visor clips $5

wiper amp $5

Mirror triangle cover thing - $10

drum brakes (in bits and pieces) $10 for both

Pod filter $10

front reading lights $10

HICAS computer bits $10

blower fan $10

bonnet lining $10

brake booster $10

brake pedal $10

centre console hand brake leather $10

centre console front trim $10

door sill trims x 2 $10

driver's side kick panel $10

dump pipe (stock) $10

AC evaporator $10

front pipe (stock) $10

hicas steering rack $10

passenger side a pillar trim $10

passenger rear arm rest trim $10

passenger side kick panel $10

roof lining $10

steering column (minus the bottom part of the shaft) $10

under-dash bar thing $10

under steering wheel trim $10

under windscreen cover $10

alternator - had battery juice spilt on it from the accident, might still work $10

boot rubber seal $10

catalytic convertor sensor $10

dash dimmer $10

door seal (the hard one, not the soft rubber one) - i think it's the driver's side $10

ignition loom $10

driver side door solonoid $10

flywheel cover $10

open door sensors $10

passenger fog light (lens is ok, plastic a little cracked) $10

various metal sheild bits $10 the lot

wiper switch $20

rear wiper motor $20

cluster surround $20

interior wiring (includes wiring that goes into the boot) $30

rear seat belts $20

hazard/stereo switch $20

outer door handles $20 each

fuel pump $20

Headlight wiring loom minus front indicator plugs $20

castor rod arms $20 each

hicas module $30

side mirrors $40 each (driver's side has a small crack on the side)

front control arms x 2 $40

rear calipers x 2 $70

Passenger side mirror gone!

centre console/handbrake surround gone!

2 x kick panels gone!

passenger side a pillar trim gone!

seat belt bolt covers gone!

passenger side rear seat hand rest panel gone!

  • 2 weeks later...
  • 1 month later...

The remaining parts have been listed as a $1 NO RESERVE eBay auction - http://cgi.ebay.com....em=261147664144

I want this stuff gone! Happy bidding!!!

  • 2 weeks later...

Only 3 hours left until the auction closes (see link above) and that's all the parts gone from my wreck! Get your bids in or miss out!

LAST CHANCE!!!!

The remaining parts have been listed as a $1 NO RESERVE eBay auction - http://cgi.ebay.com....em=261147664144

I want this stuff gone! Happy bidding!!!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • 4 to 5 is fine. It will be slow, but that's better than blowing turbos. I don't have a PS pump idle up solenoid on my car, because... I think when we put the Neo in we retained my R32 lines. But.... From inspecton of the R34 vacuum hose diagram, you can see that the solenoid needs to be connected to the turbo inlet as source of clean air) and the plenum (as source of vacuum - which is the place for the air to flow to to cause the idle to increase). So 3 to 1 is VERY WRONG. 3 should go to either the turbo inlet, or the plenum. Follow the other hose from the PS solenoid and if it goes to the plenum, then your 3 goes to 2 2 would also serve as a bleed port for a boost solenoid.
    • Pull them out and pull more apart. You can't do shit with them still bolted to the floor of the car.
    • Yes it is. ZD1 is on the other side of the board. Where ZD1 is marked is clearly opposite a 2 pin device. Our 3 pin device here is not a ZD.
    • Alright, a little update on this... I called Fulcrum, who used to be the distributor in Australia. No Bueno, they don't service them anymore.  Called shock works, who don't service them but offered to dyno the shocks for performance, and suggested DNA in Sydney might service them.  Called DNA, who also do not service them and basically said they try to steer customers away from tein for this exact reason these days- there is just no support for them anymore apparently.  Both SW and DNA said they are a not necessarily a bad product, but they just don't service the brand or know anyone who does service the brand anymore.  So... I could keep calling around but at this point I think I'll probably just spring for the shockworks product, unless anyone here knows anything.  Cheers 🍻 
    • That's not a transistor --- it's marked ZD1 which makes it a zener diode. As to what the breakdown voltage is, not enough there to divine.
×
×
  • Create New...