Jump to content
SAU Community

[Syd] 1993 R32 Gtr ~E.o.i~

G0Z1LLAAAAA34
 Share

Recommended Posts

G0Z1LLAAAAA34 Rising Star

G0Z1LLAAAAA34

Posted
Posted (edited)

Here is my pride and joy for expressing of interest at this moment. 1993 model in Burgundy colour.

KMs: 113000kms.

Mods:

2860-5 turbos

Walbro fuel pump

Nismo 600cc injectors

splitfire coilpacks

HKS camgears

grex oil cooler

Trust oil sump.

tomei oil restrictors

Power FC with hand controller

HKS boost controller

Extreme twin plate clutch

Original Nismo seats in perfect condition.

Alloy radiator.

Custom made oil catch can by Silverwater Automotive

Carbon shielded airbox

Nismo N1 headlights with HID kit installed.

Brand new Optima AGM dry cell battery with 800cca just put in.

HPI clear timing belt cover.

Braided water and oil lines on turbos.

Atezza switch between AWD and RWD

The bad:

Dash light is on and off which might be bad connection behind. I haven't really had time to take it out to check.

No A/C, condensor was taken out to fit the large oil cooler.

The car is in very good condition for an r32. Not a single bit of rust underbody, in the boot or in the engine bay, or even on any panels. Interior wise, a little wear and tear on steering wheel and shift boot. Dash condition is immaculate with absolutely no bubbles on the passenger side. Car is dead straight and drives dead straight.

Power: 330awkw @ 21psi on high boost

309awkw @ 19psi on low boost

Note: Power made with gtr AFMs. But they are at their max so Z32 AFMs are the option for more power out of this setup.

No asking price as this is a pure EOI. Offers are welcome.

Photos:

Photos:

264766_10151013675541121_799001671_n.jpg

319458_10151018188741121_1461797509_n.jpg

377090_10151018189726121_367795330_n.jpg

Edited by G0Z1LLAAAAA34
Link to comment
https://www.sau.com.au/forums/topic/409736-syd-1993-r32-gtr-~eoi~/
Share on other sites
G0Z1LLAAAAA34 Rising Star

G0Z1LLAAAAA34

Posted
  • Author
Posted (edited)

Opps forgot to add:

Genuine Bilstein coilovers

Nismo front pipes followed by 3 inch cat back

Large 2 piece front brake rotors (Brand unknown, they came with the car when I bought it)

More technical bit:

Knock: 25-35 shown on FC hand controller on high boost setting

Injector max duty: 68-70% under full power on high boost setting

Edited by G0Z1LLAAAAA34
G0Z1LLAAAAA34 Rising Star

G0Z1LLAAAAA34

Posted
  • Author
Posted (edited)

oops, you also forgot to add the price

read the rules

I don't know if you understand what express of interest means......This isn't an official for sale add so no price needed in the thread.

He is asking $16500 on JDMST.

And I don't know which GTR you are referring to. Read my jdmst thread again and see if there is a price on it....

Did you tell him he's dreaming?

I don't know what dreams you are having but i am certainly awake if you haven't noticed :)

Edited by G0Z1LLAAAAA34
G0Z1LLAAAAA34 Rising Star

G0Z1LLAAAAA34

Posted
  • Author
Posted (edited)

No money owing. No major accidents. The chassis is accident free. I think a couple of panels have been repainted before I purchased the car as we can expect from a r32 gtr this age.

Edited by G0Z1LLAAAAA34
Guest
This topic is now closed to further replies.
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Ozdavroz
      WTAC 2025

      By Ozdavroz · Posted

      Yeah good luck out there! Will be good to see a mighty GTST going harder than the GTRs
    • bcozican
      WTAC 2025

      By bcozican · Posted

      i will be there 😁
    • patrickxdf12
      Squeaking clutch/throw out bearing

      By patrickxdf12 · Posted

      Hello!  i just finished manual swaping my r34 skyline with a r33 rb20de box(RB71C)box  When the car is running it squeaks crazy loud and it was smoking from the gearbox area. The gearbox is fine it was tested. The clutch slave cylinder seems like it doesn't fully releases the clutch. I want to ask if this noise is from the throw out bearing or could it be the clutch assembly or disk att.xFliq87Gzw6kImKBVqDebXkj0fBqymk0JaYeP3_3SlM.mp4
    • RP1421
      S15 Spec R

      By RP1421 · Posted

      A few small updates since the previous post and lessons. I decided to do a little interior light upgrade on the 110. I quite like the iilumo items, even if they're a bit of a premium over other brands. You'll also note the Stedi Fogs, that will go into the S15 fog lights as I needed to match the bulbs since I got the new ones earlier. I hope they fit as the body is quite a bit longer than your normal bulb.  Annoyingly, I managed to trip the fuse, which normally wouldn't be an issue until I located the fuse. I can't say I've ever come across this. I had lucked out that someone nearby had a spare, but oddly enough Toyota dealerships seem to keep this in stock. I ordered some to keep in my stash and as luck would have it, someone else nearby tripped the same fuse so I passed on the favour.  I also did a little service on the 110 ahead of some additional work coming up. It's been annoying that Goleby's stopped carrying this particular HKS filter for the 110, so now I need to keep them on order from Japan. I also took the opportunity to install a bash plate and number plate riser. The plate riser is such a cheap but nice fix to help really tidy up the car. I'm tempted to now also replace my headlights, on this car. Both items were from Project Aero.    I also needed to replace the rear tyres on the 110, and after trying to get it aligned learnt that I need to replace some bushes in the front end, so that's next.  Closing out this update with a nicer picture as always! 
    • Murray_Calavera
      WTAC 2025

      By Murray_Calavera · Posted

      Yeah mate, never miss it.
×
×
  • Create New...