Jump to content
SAU Community

Recommended Posts

  • Replies 148
  • Created
  • Last Reply

Top Posters In This Topic

Hi mate, do you have the boot trim flap that goes over where the stock jack is stored? Do you have an assortment of interior trim clips I can get off you?

was the tailshaft causing any vibration when the car was running? (like worn joints or out of balance) might consider taking that off you.

Hi mate, do you have the boot trim flap that goes over where the stock jack is stored? Do you have an assortment of interior trim clips I can get off you?

was the tailshaft causing any vibration when the car was running? (like worn joints or out of balance) might consider taking that off you.

nah don't have the first two things, tailshaft- car wasn't running when i got it so don't really know

I'm after the 4 bolts that hold the gearbox crossmember up along with the 2 plates that go between these bolts and the bushes

bolts where flogged out when i pulled it from the car so no..

  • 3 weeks later...
  • 1 month later...

Rubber window seals that goes along the top of the door frames. More interested in passenger side but will take a pair ;)

Call me good looking I have it all

He mate have u got a bare shell by any chance if so can u please call me on 0432526472

Sorry mate they go to the scrap fast if not damaged

have you still got the gtr rear diff axles and hubs?

Yea got it all flick us a pm

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Yeh I think i'll message an old contact i had for ages that manages his own tyre shop now.. n tell him what i want n work with him before ordering..  Got this 17x9 +30 Driftteks on 245/45/17 PSR Drag Radials on the rear.. They fit well - for your reference in future - Rear guards  have been lipped in & minimal to non flaring of the rear Gaurds.    
    • If only it were that easy! I also needed to remove seats, shocks, brake calipers, send my car through a fence, and use measuring and ended up guessing because I didn't remove seats, shocks and brake calipers. It can be hard sometimes Can be a little more complex than 'just measure' if you want to truly measure the entire wheel through all of it's suspension travel. But if you aren't going for every last mm then yeah, you can check the space you currently have and guesstimate.
    • If you own a car, and it has wheels on it, and you know the offset of those wheels, and you have a measuring device, you have everything you need to work out if other wheels will fit.
    • Will this fit? but they are staggered set - RAYS 57DR SEMI GLOSS BLACK 18x8.5 +37 | 18x9.5 +38 5-114.3 STAGGERED SET   or If no go could just get a set 4's wheels of 18x8.5 +37 5-114.3 - would i run 8.5's 235s up front n 245's at the back if I do?   Thanks.        
    • Put a clamp on your return line. I have a feeling it's sucking air, and introducing bubbles to your fuel. With a lot of fuel, less problematic. I'd honestly be redoing all the lines in the tank and clamps on everything.   Also, you've given two different answers to the same question: Asked if being followed by the police you could get down to use the whole tank, you said yes you could, so long as you keep off boost. However, you then followed this up that free revving, it would also cause the issues. I'm doubting free revving is enough to make any noticeable boost on what is likely a decent sized turbo.   So now I have to ask, can you actually drive it lightly and use all the fuel, or does it break up even free revving? Also, have you put a fuel pressure gauge on it? Can you hear the pump change noise at all when you're having this issue?
×
×
  • Create New...