Jump to content
SAU Community

Recommended Posts

Assume if you like butt it's tight (_*_)

(nohomo)

Today replace L/R wing mirrors with New mirror glass and shiney nismo fuel cap on

:thanks: to the new and spare parts section at SAU meet up last night :thumbsup:

Thanks for kind words Eric. Bring it back nxt weekend, leave it for the day, and wallah - NEW Fozzie :)

Here's what I did today (besides dropping half a carton of burbs and a pack of darbs into my physic -lmao)

Put the new side mirror glass in but not worth a pic. Thanks KYLE :D

EDIT: New drink holder works a treat :cheers: . Tested and it prooved 100% as per advertisement.! Would recommend :D LoL

More stock arriving shortly - lol

Seriously though if I could afford too I would run a JDM shop in Canberra.

My passion is definately there but not the capital and the market can be so finicky. Everyone wants the very best for very little.

Pulled out some front suspension bits, got the bearing numbers, monday ill see if i can get em.

It makes that creaking noise

post-89755-0-51704400-1365227620_thumb.jpg

So i pulled it out

post-89755-0-22570700-1365227635_thumb.jpg

Bearings are in this bit, so i can just take it to someone with a press.

top is 6204V bottom is 6907L8, the top is common ill find out about the bottom.

post-89755-0-16159600-1365227658_thumb.jpg

Easy peasy, wont even need a wheel alignment.

post-89755-0-92585200-1365231055_thumb.jpg

Edited by D.I.Y. Mik

Went for a run at the Drags =)

30deg day.

Mostly stock. only FMIC and 3" exhaust.

15.2 sec, 91mph. .5 reaction

I'm pretty happy with that

next month hopefully mid/low 14 with a bit of extra boost and a bigger radiator.

Also just found out a mate has the clutch from my old car which is the purple exedy or Greddy (not sure) one. so might be swapping that in =)

  • Like 1

Yeah Richard's quite the man when it comes to detailing, really knows how to make stuff come up nicely! (now if only he could give himself the once over....:ninja:) hahaha kidding R! But no seriously Richard does some amazing work with simple DIY car detailing. Very impressive. If there were more money in it, he'd make a killing starting his own shop I reckon

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • What copper washer do you guys use on the bleeder bolts? The existing one I have I had no idea where to find it in a local store, I did buy some online but that are only 1mm thick whereas my old one is 2mm+ thick and when I put the new washer out and squeeze the top radiator hose I can hear a bit of air but not with the old one. Does this matter? The new one doesn't leak, but the inner diameter is a bit loose whereas the old one threads on the bolt.
    • Howdy all, after being out a few weeks ago on a spirited drive in my GTR I have 2 issues that oddly have appeared at the same time. Whilst accelerating quickly through the gears all of a sudden i’ve lost power at the top of third gear (below redline around 6000rpm) for no obvious reason.    From that point onwards the car has been running rich on idle, won’t really rev under load without a ton of black smoke and the odd backfire, and dying as a pull up to a set of lights unless I keep the revs up around 1500rpm. In addition when shutting down the car that same night (I was 10 minutes from home) I noticed one of the turbos was significantly noisy on wind down when shutting off the engine. After letting the car cool down overnight it starts up fine, although once it gets to temp the revs start to creep up and down, the exhaust is darker than it should be and it also sounds like it’s running rich (fat note) I’ve put a new set of plugs in it - no change, the old plugs all seemed OK with two of them being somewhat richer/fueled up than the other 3 with 1 being borderline. I’ve smoked tested the intake system via the front of the Turbos, found a split vacuum hose going to the factory boost gauge sender, which I have since replaced.  Also found another leak on the gasket coming off the rear turbo outlet, have also replaced this. After fixing both of these leaks - still have the running rich issue. I’ve also tried another pair of AFM’s - no change here After pulling off the front turbo intake pipes, there is obvious shaft play in the front turbo, which now hisses loudly on light revvs although I can’t see why this would make the car run funny even under idle. I’m curious to know why it’s running rich before I potentially replace/rebuild turbos. The car is completely stock <50,000kms  other than an exhaust. Oil and coolant are all clear. I haven’t bothered with coil packs as it looks like they won’t be the issue due to condition of the plugs. Any help appreciated as I cry myself to sleep!
    • No probs at all. I used to love trying to dig up obscure info for those in need where possible going back 20+ years on SAU.  I did have another look and couldn't come up with any closer match. I'm leaning towards those skirts in your first pic are custom fitments, cut down/extended or from another car entirely and modded to fit an R34 sedan. I would've thought someone in Japan had them and taken a photo at some stage over the last 2 decades but there's nothing. Someone out there must know surely.
    • Welcome mate. Any pics? Even with a DE I'd be well happy if I had that as a 1st car. 
×
×
  • Create New...