Jump to content
SAU Community

Wrecking 92 R32 Gtst Coupe Front End Damage

SIFTY32
 Share

Recommended Posts

SIFTY32 Proficient

SIFTY32

Posted
Posted

I am parting out a r32 gtst that has had a front end impact all the front panels are damaged

parts not available:

dash and vents

diff

front windscreen

tailshaft

brake calipers (have a full 5 stud conversion from a 96 r33 with brakes)

ignition barrel, key and locks

interior dash loom

C pillar trims are very average

everything else is for sale including:

mint type m rear pods and skirts

mint seats

doors

rear bar

manual pedals

clutch master, slave and lines

speedo cable

stock suspension

headlights

reverse lights

Lots more available just ask for what you need (I am also parting out a 96 r33 gtst)

located in springwood 4127

Cheers

Dubstein Newbie

Dubstein

Posted
Posted (edited)

Got much interior parts left? Looking to buy the vents on top of the dash and the center console armrest thing. Maybe some other little bits.

Will be in brisbane Wednesday - Saturday if you're free.

Edited by Dubstein
  • 3 weeks later...
Guest
This topic is now closed to further replies.
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • WMDC35
      Wheel Sizes & Offsets For Skylines

      By WMDC35 · Posted

      A bit late but A disk S13P fit over stock R32 GTR brakes, usually A disk front, O disk rear works.
    • Duncan
      RB20DE NEO smallbox clutch.

      By Duncan · Posted

      Or, the height of the release bearing is not correct for your combo. Start with the bleeding and checking the slave moves throughout its range when you press the pedal (2 person required), but it is possible for the height to be internally wrong too (box back off to measure.
    • GTSBoy
      RB20DE NEO smallbox clutch.

      By GTSBoy · Posted

      Yes, there's quite a few things that can go wrong during a clutch install. Very unlikely. I have a similar clutch. They (ACS) make good gear. No, it is not normal. It is possible that you just need to bleed the clutch slave. But the new clutch will also have a more aggressive actuation force/pressure, and so your old slave cylinder might be a bit leaky or otherwise compromised, and not up to the extra force required. Or the master cylinder, same.
    • Kapr
      RB20DE NEO smallbox clutch.

      By Kapr · Posted

      Hi...so a "development" here aswell The swap is "done" and car went "test drive" BUT it seems the clutch(maybe gearbox?) is a little bit sad? I bought this clutch kit https://justjap.com/products/xtreme-heavy-duty-organic-clutch-flywheel-kit-nissan-skyline-r31-r32-r33-push-type "Problem" is that the first gear is hard to put into and it seems that the clutch is not disengaged. It was not the problem with the old clutch...(or like sometime the first gear would not get as easy specialy when the fluid was cold) So? Can it be like...bad "install" or is the clutch wrong ((it should not have been) i done research to get the right one) Or is this "normal" with new clutch and needs to be break in? 
    • Kapr
      What brakes on R34 GTT(Europe)

      By Kapr · Posted

      @Duncan I can try  and thanks i did not thought about VIN and part numbers for 33/34. @GTSBoy yeah it looks like iam gonna do that  
×
×
  • Create New...