Jump to content
SAU Community

Recommended Posts

hey guys

thought id ask here first before going to a servo (who will charge an arm and a leg). but bought a car in QLD which is not running and has a ton of other shit thats included with the sale. so need to drive up and pick it up.

does anyone here have a car trailer (preferably one that can get low cars on easily) they would like to hire out?

obviously would leave all forms of ID behind PLUS a deposit etc.

please let me know ASAP as i plan on picking the car up on the 30th of may.

thanks

Ash

Link to comment
https://www.sau.com.au/forums/topic/425234-car-trailer-hire/
Share on other sites

It cost me $120 for a 24 hour hire on a flat be from one of the servo places.

As it's a national company you can pickup in one state, deliver in another.

I suggest you pickup in QLD, drop off in Vic. Hire it for 3 days. $360. Pretty cheap option IMO, and will probably save you $150 in fuel on the leg up as you're not towing 400 - 800KG for no reason on the way up.


Something to make sure you get is plenty of straps, and make sure you carry 5L of oil with you, and 20L of water plus some tools.

Towing a car from QLD to VIC could put a bit of strain on your tow vehicle and make something pop that you're not prepared for.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Nah. You need 2x taps for anything that you cannot pass the tap all the way through. And even then, there's a point in response to the above which I will come back to. The 2x taps are 1x tapered for starting, and 1x plug tap for working to the bottom of blind holes. That block's port is effectively a blind hole from the perspective of the tap. The tapered tap/tapered thread response. You don't ever leave a female hole tapered. They are supposed to be parallel, hence the wide section of a tapered tap being parallel, the existince of plug taps, etc. The male is tapered so that it will eventually get too fat for the female thread, and yes, there is some risk if the tapped length of the female hole doesn't offer enough threads, that it will not lock up very nicely. But you can always buzz off the extra length on the male thread, and the tape is very good at adding bulk to the joint.
    • Nice....looking forward to that update
    • Neg, the top one is actually for the front. The sizes are 18x10.5 +18 and 18x11 +32.   I measured many times but I'm sure I'll have problems as this is the thread for problems.
    • Just one thing; tapping tapered threads is tricky. Taps are always tapered and you would generally run it as far as you can, but with a tapered thread you have to stop much sooner otherwise the wide part of the taper will run in too far and you will have to thread the sensor in too far too as well (possible that it will never make a good seal) BTW nice wide wheels, I guess the top one is for the back!
    • Welp, good to know. Will have to wait awhile until steady hands with drills and taps are available. In other news, these just arrived! I will weigh them for posterity. Edit: 11kg each (or 10.9/11.1 depending on what my scale decides over multiple tests, the 18x11 don't seem to weigh noticeably any more than 10.5)  
×
×
  • Create New...