Jump to content
SAU Community

Recommended Posts

  • 2 months later...

I tried a new thermostat that opens at 71deg, no noticeable difference on economy... did get 320km 2 weeks ago,

but i recon that was due to the freezing cold weather / denser air.  I'm at 18-19L per 100km.

 

The idle felt a bit softer with different thermostat, so adjusted the aac screw a 1/4 turn to the left, idle feels better.

tested the old thermostat, started to open at 78deg, fully open by 86deg, about 4-5mm gap.

 

Also i recall my natrad radiator was about twice as thick as the standard radiator.

Fuel filter has also been replaced in last month or so + oil and oil filter 

Replaced the charcoal canister hose that runs back to the rear of the motor as it had cracks.

Replaced the blow of valve rubber hose, as i wasn't confident that it was sealing properly.

Replaced 3inch hose on the throttle body / intake which was rock hard, im sure it wasn't sealing correct.

 

Pedal feel is better, will post in a week or so on the km.

 

  • 2 weeks later...

I got 358km so far and the fuel light just come on, fair improvement over pushing to get 300km.

I attribute this more so to fixing the hoses. I guess the 02 sensor, helped a bit + cold temps of late.

Have reverted back to the original thermostat today and re-tweaked the aac valve screw to correct idle speed.

Will post up again if any dramatic results.... hoping for 400km a tank :)

Edited by Stagea_Neo
  • Like 2
  • 3 months later...

Never got the 400km out of a tank, above was best result. Also that was with the boost solenoid mod :).

Without the boost solenoid mod fuel consumption got worse again, I guess 8psi approx is a sweet spot.

Also I recommend if you haven't swapped your spark plugs ever, like me until today, definitely check em

found two not tight affecting compression, in turn economy and they were just old as.....

 

  • 1 year later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • I haven’t pulled the injectors to watch them spray yet but they are clicking from the cas and all of the spark plugs are wet with fuel. I’ve thought the cylinders were being flooded from the beginning and was hoping fuel pressure would fix it. Tonight I am going to pull the rail and watch the injectors spray. Don’t know how to test/diagnose if the plugs are firing in correct sequence but that should be a timing thing and as far as timing goes my car still has the half moon for the cas can only install it 1 way. And my mechanical timing is 100% correct I posted photos above. Confirmed with the balancer on and off. 
    • I checked spark on all cylinders and they all visually have spark with the plug pulled and grounded, but plug 1 is the only one that fouled. This was a running swap that blew up and was rebuilt by a machine shop, put a new wiring specialties harness and did all gaskets, studs, and bolts while it was out.  compression is 135-150 across all cylinders. Aside from that from my understanding with the z32 ecu and maf the car should start regardless. The wiring for TPS and the dual 02 sensor/ dual knock sensor stuff shouldn’t actually stop the car from starting or even running well, (just slightly rich)  they just give fault codes. Car supposedly is supposed to start as long as you have z32 afm and ecu with the nistune base map and that’s info coming from a well known and trusted tuner who does a lot with SR/RB (Rsenthalpy). After more trouble shooting today where I’m at right now is that the cas is sending signal to the injectors they click while spinning the rotor, Fuel pressure is now set at 43psi, all cylinders have good compression and all of the plugs looked great (just wet with fuel) except for cylinder 1 which was very black (cylinder 1 has 150psi compression). all of the coils generate spark if pulled out and grounded out on the head. On the fuel pump car just pops into the exhaust. On starting fluid car will fire off. Hard to tell if all cylinders are firing off but definitley a couple. sounds like all of them but it’s only for 3-5 seconds hard to tell. 
    • Final update!!! Got the front bar fitted and sprayed and all sorted now. My cutouts worked great and the indicators aren’t just falling off. 😂  
    • Is this a brand new LSD? if so, have you followed any break/bed in procedure for it? Usually involves heaps of figure 8 patterns, a fluid flush.
    • It's TWO steering wheels actually. 😛 one for each hand They are wheels, and they steer!
×
×
  • Create New...