Jump to content
SAU Community

Mugabetown - Whoretownin' At It's Worst.


Recommended Posts

QLD has been quiet all day except for the hand full of key boards warriors causeing trouble from the safety of their computer screens

do you mean on the forum or just internet in General?

the amount of posts on the page haha

sorry my bad for not whorin tonite.

Been frantically trying to install windows 8.1 (full version)

Me and computers - we get along very rarely

Thnk thre is a few 25/30 projects going on now. I swear Matty is doing one along with you and I

I was going to once I got a skyline and probably will depending what I get but not gonna start until I have a car

Thnk thre is a few 25/30 projects going on now. I swear Matty is doing one along with you and I

Well anyways

It's pretty much I hold till I get the kesh to get parts and then I get it gets don't to machine shop then comes back and gets assembled

sorry my bad for not whorin tonite.

Been frantically trying to install windows 8.1 (full version)

Me and computers - we get along very rarely

Did you update all your drivers BEFORE going to 8.1?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • There are black hose clamps as well if you care. Plazmaman for example sells some: https://plazmaman.com/product/black-hose-clamps-premium-quality-stainless-breeze/
    • After using a protractor for an actually accurate assessment of what is required,  and by NOT using my uncalibrated eyeball I worked out I need a 25° silicone bend from the TB ro the MAF, but, my choice was either a 30° or a 23° (23° is a weird spec), so I grabbed the 23° one from Raceworks I also grabbed 1mtr of 3" straight from Just Jap, I needed 350mm, but they only had 300mm, or 1mtr lengths....meh Also ordered a 1/2" hose bulkhead fitting from fleabay, this has a smoothish mushroom looking head (they are designed for below the water line of boats) that will fit inside the bend, the hose bit and threaded bit looks to long, but nothing that a hacksaw cannot fix if required, the hose will then just get jamed on the threaded bit up to the retaining nut Fingers crossed and the unsightly amount of hose clamps will be reduced down to 4 once all the parts arrive 
    • Oil change does not trigger code 21. Code 21 is for coilpacks primary side connection. You can try to clear the code with a battery disconnect, hold down the brake pedal to drain capacitors through the brake lights with the ignition on for 10-15 seconds before you reconnect the battery. I have seen R35 coil conversion permanently cause this code with no ill effects so it might be the resistance it wants to see isn't quite right on one or more coilpacks. Could be inside the ECU, could be the harness, could be a coil. You can test it all if you want or just ignore until the car actually starts misfiring.
    • I forgot you have a Nistune ECU. Use Nistune to do all the tests I mentioned instead of faffing with 30+ year old electrical connectors. You can read MAF volts off that too, there are reference values in the service manual to tell you roughly what it should be in different conditions.
×
×
  • Create New...