Jump to content
SAU Community

Mugabetown - Whoretownin' At It's Worst.


Recommended Posts

Isn't Europe fun!

Boz. that sucks, I would assume heater hose

GT6 installing now.....seeyas some time in the future (and sunday)

yes hence y I love it so much :)

Also noice re GT6

been awake, missus got me up with the promise of some nookie,

only to tell me to do the dishes and clean the lounge ........

WTF is this false hope shit !!!!!

That is BS! There are few things in life better than waking up to a morning gobble.

Nor looking forward to cleaning the car today gonna pull half the car apart to fix up some trim that hasn't been sitting properly for a while now.

At least your cars are able to run :-P

Anyone got a spare seat for a photographer I've got coming along? Work and the car gods have f**ked me over. I can get him to the meet (in my oh so classy Astra) but I have to bail early so he'll need a lift to the powerhouse mid afternoon.

been awake, missus got me up with the promise of some nookie,

only to tell me to do the dishes and clean the lounge ........

WTF is this false hope shit !!!!!

just evil that is just evil.......

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • As MBS suggested if this is happening when the engine is cold you're going to want to remove the intake air regulator and verify resistance + that the shutter is physically opening and closing. At -20C should be fully open, 20C half open, over 60C fully closed. At 20C should be 70-80 ohms. For AAC valve testing using a Consult cable see if you can raise and lower the idle by commanding more or less AAC duty cycle. Hopefully it's pretty linear as well, shouldn't be like 30% AAC valve is barely idling and 40% is 1500 rpm.
    • Bloody apprentices! 🙄
    • Not sure yet.  Was considering speedtek because it was rated to 800hp, but when I did some research about him I don't think I will go for that🤣 So maybe giken gear set, but I'm afraid it won't be strong enough🙄
    • Keeping in mind that for most people this is a week to month long job!
    • Its also worth mentioning that 30 years after it left the factory and god knows how many missed oil changes since, there is every possibility that one or more lifters are ticking because they are sticky/gummed up. To resolve that you need to pull the cams then pull each lifter, disassemble, clean, reassemble, soak in oil and re-install, and they should come up good as new.
×
×
  • Create New...