Jump to content
SAU Community

Mugabetown - Whoretownin' At It's Worst.


Recommended Posts

f*cking alarm or something on my neighbours shed has been going off all night. Sounds like a truck reversing. No sleep for me :( :( :(

This sucks... f**king neighbours... Things like this make me want to be a hermit... Somewhere with pretty mountain views and easy access to some form of beach... Not asking much :P

I have an air on unit bolted to the wall sitting 20cm from my head... Every day this swing. So it could be worse!

This would still annoy me, tho not as much as the alarm... I don't like the sound of a ceiling fan and they don't make much noise!

AND HAPPY CAKE DAY!!! :cheers::merli: <--- I maintain on peoples birthdays that's a party hat not a wizard

Go burn their shed down?

Hehehehehehe! Made me think of this...

2033663.jpg

Hey Tony, welcome back!

Now when are you guna make that skyline in my backyard dissapear?

careful what you wish for Mike

The Skyline may not be the only thing that disappears from your backyard :ninja:

made me think of this...

2033663.jpg

Thinking of kids Mel?

Now when are you guna make that skyline in my backyard dissapear?

Right after he makes your wallet disappear

I'd load the old rusty subframe into the boot too, but I can't lift it :(

Just zip tie and duct tape it to the side of the car

  • Like 2

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • Did and sync timing with light 
    • Have you done the Ignition Sync Wizard in the AEM software?
    • Find out what RPM it was idling at with the IACV unplugged. It's very weird that the rpm didn't change at all, and then it stalled. When it stalls is it nearly like a switch off, like you've turned the engine off? Or is it more stutters and sputters and coughs to death over a few seconds? Or does the RPM just slowly keep going down and down? Have you done a test of trying to start it with the AFM unplugged? Does it still die?     If you Follow Josh's advice on using Nistune to check the voltages (which is a perfect method!) if you see anything out of wack voltage wise, THEN get the multimeter out and read the voltage directly at the sensor. If the two vary, then you're now looking for a wiring issue vs a sensor issue. So be aware, what the ECU sees, may not be what the sensor is actually saying too...
    • You very likely need to get it on a dyno and tune it. My assumption is, you've got an RB25DET tune in it, which has a different manifold, different injectors, and different cams as a minimum. What O2 sensor are you running?   When you say it runs extremely rich from idle all the way to redline, is this just free revving it you see that?
    • I seem to the be only person that is using a Haltech 2500 on an NA motor, I've installed a Bosch DBW throttle body to the OEM intake manifold and am having problems maintaining AFR even with the wideband o2.  It will run extremely rich at idle and up to redline, but under load it will go extremely lean in the 20s and i'm essentially having to rev it over 4k and feather the clutch to get it up to speed.  I've read a few other threads of about the butterfly, it seems removing the vacuum to it is supposed to have it remain open, i've noticed no difference under 4k with the vacuum line to it plugged.  I'm hoping someone here has had luck using the NA manifold with Haltech, and if they happen to have a tune for it.  
×
×
  • Create New...