Jump to content
SAU Community

Recommended Posts

Met Barry while getting tune done by Chian. Barry was nice to speak to and Chian's tune is absolutely awesome and this was 3 years ago. Been to a few big names for tunes but in my book Chian's tune is much better than any other I've had.

Imagine someone after reading this thread then walks into Edge and asking to speak to master Rajab.... LOL

Will use that one on Barry next time he calls.

He is use to hearing me answer his incoming calls with a "You Farkin Bosnian Carnt trouble makers...."

If you really want to upset him say your getting a engine built or advice from "the King of SR20's", he knows who it refers too and really get up his nose.

Then tell him Peter told you to say it before he punches you. :)

Edited by GTRPSI
  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • Let large companies that are making money off selling kits do the preliminary engineering for you. If they all do -10, then that is all you'll ever need. 
    • Hopefully it ends up being something manageable, like a hone, rather than a full bore—it would be a huge relief if it’s not as bad as it looks. Hang in there; these setbacks are annoying, but it sounds like you’re handling it as smartly as possible.
    • At the end of the day, it’s all about understanding the odds and being comfortable with the potential cost, whether it’s horsepower on a build or chips on a roulette table. And I have to say, the Laine example made me laugh—some people really do embrace that carefree, “roll and see” attitude!
    • Thanks MBS206, i got that PDF but got abit overhelm with all the connections and tracing of wires. I wasn't expecting to plug the dash harness anywhere. i was just going to use my electronics jumper wires to plug into the right pins like ECU power, ecu ground, ignition trigger etc... I do have a few ratchet straps locking it down tight. Fire extinguisher ready and only a small amount of fuel at a time, enough to submerge the pump.
    • Thanks GTSBoy, i will do abit more digging. I am missing a blue relay near the ECU connector... so i will chase that up in the next few days as well  
×
×
  • Create New...